[   14.838890] ppdev: user-space parallel port driver
[   14.869794] fb0: inteldrmfb frame buffer device
[   14.869797] registered panic notifier
[   15.079146] acpi device:39: registered as cooling_device3
[   15.079452] input: Video Bus as /devices/LNXSYSTM:00/LNXSYBUS:00/PNP0A08:00/LNXVIDEO:01/input/input9
[   15.079510] ACPI: Video Device [OVGA] (multi-head: yes  rom: no  post: no)
[   15.079540] [drm] Initialized i915 1.6.0 20080730 for 0000:00:02.0 on minor 0
[   15.081500] vga16fb: initializing
[   15.081504] vga16fb: mapped to 0xc00a0000
[   15.081562] fb1: VGA16 VGA frame buffer device
[   15.081834] HDA Intel 0000:00:1b.0: PCI INT A -> GSI 22 (level, low) -> IRQ 22
[   15.081865] HDA Intel 0000:00:1b.0: setting latency timer to 64
[   15.187469] input: HDA Digital PCBeep as /devices/pci0000:00/0000:00:1b.0/input/input10
[   15.216901] Console: switching to colour frame buffer device 160x50
[   34.329796]   alloc irq_desc for 31 on node -1
[   34.329800]   alloc kstat_irqs on node -1
[   34.329830] tg3 0000:05:00.0: irq 31 for MSI/MSI-X
[   34.497853] ADDRCONF(NETDEV_UP): eth0: link is not ready
[   34.510449] iwl3945 0000:06:00.0: firmware: requesting iwlwifi-3945-2.ucode
[   34.531084] iwl3945 0000:06:00.0: loaded firmware version 15.32.2.9
[   34.601339] Registered led device: iwl-phy0::radio
[   34.601363] Registered led device: iwl-phy0::assoc
[   34.601423] Registered led device: iwl-phy0::RX
[   34.601442] Registered led device: iwl-phy0::TX
[   34.626344] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   36.052544] tg3: eth0: Link is up at 100 Mbps, full duplex.
[   36.052547] tg3: eth0: Flow control is on for TX and on for RX.
[   36.052735] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   46.544093] eth0: no IPv6 routers present
[  103.388160] usb 2-1: new high speed USB device using ehci_hcd and address 3
[  103.524245] usb 2-1: configuration #1 chosen from 1 choice
[  103.585469] Initializing USB Mass Storage driver...
[  103.585717] scsi5 : SCSI emulation for USB Mass Storage devices
[  103.585923] usbcore: registered new interface driver usb-storage
[  103.585931] USB Mass Storage support registered.
[  103.587487] usb-storage: device found at 3
[  103.587493] usb-storage: waiting for device to settle before scanning
[  108.584325] usb-storage: device scan complete
[  108.585816] scsi 5:0:0:0: Direct-Access     Easy     Disk             3000 PQ: 0 ANSI: 0 CCS
[  108.586765] sd 5:0:0:0: Attached scsi generic sg2 type 0
[  108.590740] sd 5:0:0:0: [sdb] 1907712 512-byte logical blocks: (976 MB/931 MiB)
[  108.591635] sd 5:0:0:0: [sdb] Write Protect is off
[  108.591643] sd 5:0:0:0: [sdb] Mode Sense: 43 00 00 00
[  108.591650] sd 5:0:0:0: [sdb] Assuming drive cache: write through
[  108.595905] sd 5:0:0:0: [sdb] Assuming drive cache: write through
[  108.595916]  sdb: sdb1
[  108.736281] sd 5:0:0:0: [sdb] Assuming drive cache: write through
[  108.736292] sd 5:0:0:0: [sdb] Attached SCSI removable disk
[  109.036128] usb 2-1: reset high speed USB device using ehci_hcd and address 3
[  143.782129] usb 2-1: USB disconnect, address 3