[ 16.271149] sky2 eth0: enabling interface [ 16.271372] ADDRCONF(NETDEV_UP): eth0: link is not ready [ 18.010285] sky2 eth0: Link is up at 100 Mbps, full duplex, flow control both [ 18.010548] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready [ 20.781162] [drm] Setting GART location based on new memory map [ 20.781985] [drm] Loading RS690/RS740 Microcode [ 20.782006] [drm] Num pipes: 1 [ 20.782013] [drm] writeback test succeeded in 1 usecs [ 28.304016] eth0: no IPv6 routers present [ 80.500040] Clocksource tsc unstable (delta = -250161400 ns) [11338.096814] sky2 eth0: disabling interface [11338.245409] [drm] Num pipes: 1 [11338.882566] PM: Syncing filesystems ... done. [11338.884365] PM: Preparing system for mem sleep [11338.884369] Freezing user space processes ... (elapsed 0.00 seconds) done. [11338.885492] Freezing remaining freezable tasks ... (elapsed 0.00 seconds) done. [11338.885556] PM: Entering mem sleep [11338.885572] Suspending console(s) (use no_console_suspend to debug) [11338.900020] sd 4:0:0:0: [sdb] Synchronizing SCSI cache [11339.087244] sd 4:0:0:0: [sdb] Stopping disk [11339.240006] sd 3:0:0:0: [sda] Synchronizing SCSI cache [11339.240104] sd 3:0:0:0: [sda] Stopping disk [11339.284146] ACPI handle has no context! [11339.284425] parport_pc 00:07: disabled [11339.284661] serial 00:06: disabled [11339.284735] ACPI handle has no context! [11339.284741] sky2 0000:02:00.0: PME# disabled [11339.284746] ACPI handle has no context! [11339.300021] pci 0000:01:05.0: PCI INT A disabled [11339.404090] HDA Intel 0000:00:14.2: PCI INT A disabled [11339.420097] pata_atiixp 0000:00:14.1: PCI INT A disabled [11339.420106] ehci_hcd 0000:00:13.5: PCI INT D disabled [11339.420114] ohci_hcd 0000:00:13.4: PCI INT C disabled [11339.420121] ohci_hcd 0000:00:13.3: PCI INT B disabled [11339.420129] ohci_hcd 0000:00:13.2: PCI INT C disabled [11339.420136] ohci_hcd 0000:00:13.1: PCI INT B disabled [11339.420143] ohci_hcd 0000:00:13.0: PCI INT A disabled [11339.484130] ahci 0000:00:12.0: PCI INT A disabled [11339.484162] PM: suspend devices took 0.600 seconds [11339.486000] ehci_hcd 0000:00:13.5: PME# disabled [11339.500249] ACPI: Preparing to enter system sleep state S3 [11339.628207] Disabling non-boot CPUs ... [11339.628254] Extended CMOS year: 2000 [11339.628254] x86 PAT enabled: cpu 0, old 0x7040600070406, new 0x7010600070106 [11339.628254] Back to C! [11339.628254] Extended CMOS year: 2000 [11339.628254] ACPI: Waking up from system sleep state S3 [11339.628254] pcieport-driver 0000:00:07.0: restoring config space at offset 0x1 (was 0x100107, writing 0x100507) [11339.628254] ahci 0000:00:12.0: restoring config space at offset 0xf (was 0x100, writing 0x10b) [11339.628254] ahci 0000:00:12.0: restoring config space at offset 0x2 (was 0x1018f00, writing 0x1060100) [11339.628254] ahci 0000:00:12.0: set SATA to AHCI mode [11339.644046] ehci_hcd 0000:00:13.5: restoring config space at offset 0x1 (was 0x2b00000, writing 0x2b00113) [11339.644063] ehci_hcd 0000:00:13.5: PME# disabled [11339.645752] pata_atiixp 0000:00:14.1: restoring config space at offset 0x3 (was 0x0, writing 0x4000) [11339.645770] HDA Intel 0000:00:14.2: restoring config space at offset 0xf (was 0x105, writing 0x5) [11339.645794] HDA Intel 0000:00:14.2: restoring config space at offset 0x1 (was 0x4100006, writing 0x4100002) [11339.645887] pci 0000:01:05.0: restoring config space at offset 0xf (was 0x1ff, writing 0x10a) [11339.645896] pci 0000:01:05.0: restoring config space at offset 0x3 (was 0x0, writing 0x4010) [11339.645901] pci 0000:01:05.0: restoring config space at offset 0x1 (was 0x100107, writing 0x100103) [11339.645932] sky2 0000:02:00.0: restoring config space at offset 0xf (was 0x100, writing 0x10a) [11339.645940] sky2 0000:02:00.0: restoring config space at offset 0xc (was 0x0, writing 0xfebc0000) [11339.645951] sky2 0000:02:00.0: restoring config space at offset 0x6 (was 0x1, writing 0xe801) [11339.645957] sky2 0000:02:00.0: restoring config space at offset 0x4 (was 0x4, writing 0xfebfc004) [11339.645963] sky2 0000:02:00.0: restoring config space at offset 0x3 (was 0x0, writing 0x10) [11339.645969] sky2 0000:02:00.0: restoring config space at offset 0x1 (was 0x100000, writing 0x100507) [11339.646083] ahci 0000:00:12.0: PCI INT A -> GSI 22 (level, low) -> IRQ 22 [11339.646167] ohci_hcd 0000:00:13.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16 [11339.668016] ohci_hcd 0000:00:13.1: PCI INT B -> GSI 17 (level, low) -> IRQ 17 [11339.692021] ohci_hcd 0000:00:13.2: PCI INT C -> GSI 18 (level, low) -> IRQ 18 [11339.716019] ohci_hcd 0000:00:13.3: PCI INT B -> GSI 17 (level, low) -> IRQ 17 [11339.740018] ohci_hcd 0000:00:13.4: PCI INT C -> GSI 18 (level, low) -> IRQ 18 [11339.764018] ehci_hcd 0000:00:13.5: PME# disabled [11339.764023] ehci_hcd 0000:00:13.5: PCI INT D -> GSI 19 (level, low) -> IRQ 19 [11339.764037] pata_atiixp 0000:00:14.1: PCI INT A -> GSI 16 (level, low) -> IRQ 16 [11339.764050] HDA Intel 0000:00:14.2: PCI INT A -> GSI 16 (level, low) -> IRQ 16 [11339.764080] pci 0000:01:05.0: PME# disabled [11339.764084] pci 0000:01:05.0: PCI INT A -> GSI 18 (level, low) -> IRQ 18 [11339.764091] sky2 0000:02:00.0: PME# disabled [11339.765154] serial 00:06: activated [11339.766428] parport_pc 00:07: activated [11339.947071] sd 3:0:0:0: [sda] Starting disk [11339.964053] ata2: SATA link down (SStatus 0 SControl 300) [11339.964081] ata1: SATA link down (SStatus 0 SControl 300) [11340.128014] ata3: softreset failed (device not ready) [11340.128017] ata3: applying SB600 PMP SRST workaround and retrying [11340.292024] ata3: SATA link up 1.5 Gbps (SStatus 113 SControl 300) [11340.301457] ata3.00: SB600 AHCI: limiting to 255 sectors per cmd [11340.311246] ata3.00: SB600 AHCI: limiting to 255 sectors per cmd [11340.311249] ata3.00: configured for UDMA/100 [11342.704014] ata4: softreset failed (device not ready) [11342.704017] ata4: applying SB600 PMP SRST workaround and retrying [11342.868024] ata4: SATA link up 3.0 Gbps (SStatus 123 SControl 300) [11342.875145] ata4.00: SB600 AHCI: limiting to 255 sectors per cmd [11342.875745] ata4.00: SB600 AHCI: limiting to 255 sectors per cmd [11342.875747] ata4.00: configured for UDMA/133 [11342.890999] sd 4:0:0:0: [sdb] Starting disk [11344.804014] ata5: link is slow to respond, please be patient (ready=0) [11345.080481] ata5.00: ACPI cmd ef/03:0c:00:00:00:a0 filtered out [11345.080484] ata5.00: ACPI cmd ef/03:45:00:00:00:a0 filtered out [11345.080487] ata5.00: ACPI cmd f5/00:00:00:00:00:a0 filtered out [11345.109483] ata5.00: configured for UDMA/100 [11345.163188] PM: resume devices took 5.516 seconds [11345.163191] ------------[ cut here ]------------ [11345.163199] WARNING: at /build/buildd/linux-2.6.31/kernel/power/suspend_test.c:52 suspend_test_finish+0x80/0x90() [11345.163201] Hardware name: To Be Filled By O.E.M. [11345.163203] Component: resume devices [11345.163204] Modules linked in: binfmt_misc snd_hda_codec_realtek iptable_filter ip_tables x_tables snd_hda_intel snd_hda_codec snd_hwdep snd_pcm_oss snd_mixer_oss snd_pcm snd_seq_dummy snd_seq_oss snd_seq_midi snd_rawmidi snd_seq_midi_event snd_seq snd_timer snd_seq_device snd soundcore snd_page_alloc i2c_piix4 shpchp k8temp ppdev psmouse serio_raw parport_pc lp parport usbhid sky2 radeon ttm drm i2c_algo_bit ati_agp agpgart [11345.163231] Pid: 2078, comm: pm-suspend Not tainted 2.6.31-14-generic #48-Ubuntu [11345.163233] Call Trace: [11345.163240] [] warn_slowpath_common+0x6d/0xa0 [11345.163244] [] ? suspend_test_finish+0x80/0x90 [11345.163248] [] ? suspend_test_finish+0x80/0x90 [11345.163251] [] warn_slowpath_fmt+0x26/0x30 [11345.163255] [] suspend_test_finish+0x80/0x90 [11345.163258] [] suspend_devices_and_enter+0x9f/0xd0 [11345.163264] [] ? printk+0x18/0x1c [11345.163267] [] enter_state+0xb9/0xf0 [11345.163270] [] state_store+0x6d/0xb0 [11345.163273] [] ? state_store+0x0/0xb0 [11345.163278] [] kobj_attr_store+0x20/0x30 [11345.163282] [] sysfs_write_file+0x90/0x100 [11345.163286] [] vfs_write+0x9a/0x190 [11345.163289] [] ? sysfs_write_file+0x0/0x100 [11345.163293] [] ? do_page_fault+0x19b/0x380 [11345.163296] [] sys_write+0x3d/0x70 [11345.163299] [] syscall_call+0x7/0xb [11345.163302] ---[ end trace 5637b23f999952ca ]--- [11345.163400] PM: Finishing wakeup. [11345.163402] Restarting tasks ... done. [11346.375666] [drm] Loading RS690/RS740 Microcode [11346.375685] [drm] Num pipes: 1 [11346.457341] sky2 eth0: enabling interface [11346.457571] ADDRCONF(NETDEV_UP): eth0: link is not ready [11348.123069] sky2 eth0: Link is up at 100 Mbps, full duplex, flow control both [11348.123601] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready [11358.320030] eth0: no IPv6 routers present