[   14.432183] ppdev: user-space parallel port driver
[   15.198306]   alloc irq_desc for 29 on node 0
[   15.198309]   alloc kstat_irqs on node 0
[   15.198320] fglrx_pci 0000:01:00.0: irq 29 for MSI/MSI-X
[   15.198791] [fglrx] Firegl kernel thread PID: 1521
[   15.253109] usplash:382 freeing invalid memtype ffffffffd0000000-ffffffffd1000000
[   17.013262] [fglrx] Gart USWC size:942 M.
[   17.013265] [fglrx] Gart cacheable size:373 M.
[   17.013270] [fglrx] Reserved FB block: Shared offset:0, size:1000000 
[   17.013272] [fglrx] Reserved FB block: Unshared offset:fd0b000, size:2f5000 
[   17.013274] [fglrx] Reserved FB block: Unshared offset:1fffb000, size:5000 
[   18.886922] hda-intel: IRQ timing workaround is activated for card #1. Suggest a bigger bdl_pos_adj.
[   28.499846] UDF-fs: No VRS found
[   28.499851] UDF-fs: No partition found (1)
[   28.546615] ISO 9660 Extensions: Microsoft Joliet Level 3
[   28.547192] ISOFS: changing to secondary root
[  466.005718] ATL1E 0000:02:00.0: ATL1E: eth0 NIC Link is Up<100 Mbps Full Duplex>
[  466.006118] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[  476.971316] eth0: no IPv6 routers present
[  816.799475] fglrx_pci 0000:01:00.0: irq 29 for MSI/MSI-X
[  816.799972] [fglrx] Firegl kernel thread PID: 2113
[  818.581003] [fglrx] Gart USWC size:942 M.
[  818.581007] [fglrx] Gart cacheable size:373 M.
[  818.581011] [fglrx] Reserved FB block: Shared offset:0, size:1000000 
[  818.581014] [fglrx] Reserved FB block: Unshared offset:fd0b000, size:2f5000 
[  818.581016] [fglrx] Reserved FB block: Unshared offset:1fffb000, size:5000 
[ 3238.649091] fglrx_pci 0000:01:00.0: irq 29 for MSI/MSI-X
[ 3238.649587] [fglrx] Firegl kernel thread PID: 3151
[ 3240.430908] [fglrx] Gart USWC size:942 M.
[ 3240.430911] [fglrx] Gart cacheable size:373 M.
[ 3240.430916] [fglrx] Reserved FB block: Shared offset:0, size:1000000 
[ 3240.430918] [fglrx] Reserved FB block: Unshared offset:fd0b000, size:2f5000 
[ 3240.430921] [fglrx] Reserved FB block: Unshared offset:1fffb000, size:5000 
[ 3704.290017] usb 1-4: new high speed USB device using ehci_hcd and address 2
[ 3704.455199] usb 1-4: configuration #1 chosen from 1 choice
[ 3704.530459] Initializing USB Mass Storage driver...
[ 3704.530671] scsi6 : SCSI emulation for USB Mass Storage devices
[ 3704.531152] usb-storage: device found at 2
[ 3704.531154] usb-storage: waiting for device to settle before scanning
[ 3704.531171] usbcore: registered new interface driver usb-storage
[ 3704.531174] USB Mass Storage support registered.
[ 3705.850061] usb 1-4: usbfs: USBDEVFS_CONTROL failed cmd gvfs-gphoto2-vo rqt 192 rq 1 len 1000 ret -110
[ 3706.850050] usb 1-4: usbfs: USBDEVFS_CONTROL failed cmd gvfs-gphoto2-vo rqt 128 rq 6 len 1000 ret -110
[ 3709.535275] usb-storage: device scan complete
[ 3709.535756] scsi 6:0:0:0: Direct-Access     Sandisk  Sansa Express    0100 PQ: 0 ANSI: 4
[ 3709.536092] sd 6:0:0:0: Attached scsi generic sg2 type 0
[ 3709.537887] sd 6:0:0:0: [sdb] 1997307 512-byte logical blocks: (1.02 GB/975 MiB)
[ 3709.538303] sd 6:0:0:0: [sdb] Write Protect is off
[ 3709.538306] sd 6:0:0:0: [sdb] Mode Sense: 3e 00 00 00
[ 3709.538308] sd 6:0:0:0: [sdb] Assuming drive cache: write through
[ 3709.539857] sd 6:0:0:0: [sdb] Assuming drive cache: write through
[ 3709.539862]  sdb: sdb1
[ 3709.543994] sd 6:0:0:0: [sdb] Assuming drive cache: write through
[ 3709.543999] sd 6:0:0:0: [sdb] Attached SCSI removable disk
[ 4434.465627] usb 1-4: USB disconnect, address 2
[ 7155.870024] usb 1-4: new high speed USB device using ehci_hcd and address 3
[ 7156.023979] usb 1-4: configuration #1 chosen from 1 choice
[ 7156.025642] scsi7 : SCSI emulation for USB Mass Storage devices
[ 7156.025723] usb-storage: device found at 3
[ 7156.025725] usb-storage: waiting for device to settle before scanning
[ 7157.350166] usb 1-4: usbfs: USBDEVFS_CONTROL failed cmd gvfs-gphoto2-vo rqt 192 rq 1 len 1000 ret -110
[ 7158.350087] usb 1-4: usbfs: USBDEVFS_CONTROL failed cmd gvfs-gphoto2-vo rqt 128 rq 6 len 1000 ret -110
[ 7161.124426] usb-storage: device scan complete
[ 7161.124907] scsi 7:0:0:0: Direct-Access     Sandisk  Sansa Express    0100 PQ: 0 ANSI: 4
[ 7161.125437] sd 7:0:0:0: Attached scsi generic sg2 type 0
[ 7161.128769] sd 7:0:0:0: [sdb] 1997307 512-byte logical blocks: (1.02 GB/975 MiB)
[ 7161.129140] sd 7:0:0:0: [sdb] Write Protect is off
[ 7161.129143] sd 7:0:0:0: [sdb] Mode Sense: 3e 00 00 00
[ 7161.129145] sd 7:0:0:0: [sdb] Assuming drive cache: write through
[ 7161.130764] sd 7:0:0:0: [sdb] Assuming drive cache: write through
[ 7161.130769]  sdb: sdb1
[ 7161.134891] sd 7:0:0:0: [sdb] Assuming drive cache: write through
[ 7161.134895] sd 7:0:0:0: [sdb] Attached SCSI removable disk
[ 9293.918759] usb 1-4: USB disconnect, address 3
[ 9493.111263] usb 1-2: new high speed USB device using ehci_hcd and address 4
[ 9493.263953] usb 1-2: configuration #1 chosen from 1 choice
[ 9493.265653] scsi8 : SCSI emulation for USB Mass Storage devices
[ 9493.265776] usb-storage: device found at 4
[ 9493.265779] usb-storage: waiting for device to settle before scanning
[ 9494.600148] usb 1-2: usbfs: USBDEVFS_CONTROL failed cmd gvfs-gphoto2-vo rqt 192 rq 1 len 1000 ret -110
[ 9495.600080] usb 1-2: usbfs: USBDEVFS_CONTROL failed cmd gvfs-gphoto2-vo rqt 128 rq 6 len 1000 ret -110
[ 9498.264075] usb-storage: device scan complete
[ 9498.264522] scsi 8:0:0:0: Direct-Access     Sandisk  Sansa Express    0100 PQ: 0 ANSI: 4
[ 9498.264865] sd 8:0:0:0: Attached scsi generic sg2 type 0
[ 9498.268023] sd 8:0:0:0: [sdb] 1997307 512-byte logical blocks: (1.02 GB/975 MiB)
[ 9498.268386] sd 8:0:0:0: [sdb] Write Protect is off
[ 9498.268389] sd 8:0:0:0: [sdb] Mode Sense: 3e 00 00 00
[ 9498.268392] sd 8:0:0:0: [sdb] Assuming drive cache: write through
[ 9498.270013] sd 8:0:0:0: [sdb] Assuming drive cache: write through
[ 9498.270017]  sdb: sdb1
[ 9498.274014] sd 8:0:0:0: [sdb] Assuming drive cache: write through
[ 9498.274018] sd 8:0:0:0: [sdb] Attached SCSI removable disk
[10395.914433] usb 1-2: USB disconnect, address 4
[10553.890014] usb 1-4: new high speed USB device using ehci_hcd and address 5
[10554.041037] usb 1-4: configuration #1 chosen from 1 choice
[10554.041315] scsi9 : SCSI emulation for USB Mass Storage devices
[10554.041440] usb-storage: device found at 5
[10554.041444] usb-storage: waiting for device to settle before scanning
[10559.040215] usb-storage: device scan complete
[10559.040689] scsi 9:0:0:0: Direct-Access     ChipBank SD/MM Reader     4080 PQ: 0 ANSI: 2
[10559.041015] sd 9:0:0:0: Attached scsi generic sg2 type 0
[10559.043751] sd 9:0:0:0: [sdb] 3897344 512-byte logical blocks: (1.99 GB/1.85 GiB)
[10559.044356] sd 9:0:0:0: [sdb] Write Protect is off
[10559.044359] sd 9:0:0:0: [sdb] Mode Sense: 0b 00 00 08
[10559.044362] sd 9:0:0:0: [sdb] Assuming drive cache: write through
[10559.046296] sd 9:0:0:0: [sdb] Assuming drive cache: write through
[10559.046300]  sdb: sdb1
[10559.050802] sd 9:0:0:0: [sdb] Assuming drive cache: write through
[10559.050807] sd 9:0:0:0: [sdb] Attached SCSI removable disk
[10652.287020] usb 1-4: USB disconnect, address 5