[   18.841645] Registered led device: iwl-phy0::radio
[   18.841659] Registered led device: iwl-phy0::assoc
[   18.841672] Registered led device: iwl-phy0::RX
[   18.841685] Registered led device: iwl-phy0::TX
[   18.856760] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   19.766831] i2c-adapter i2c-4: unable to read EDID block.
[   19.766834] i915 0000:00:02.0: HDMI Type A-2: no EDID data
[   19.771452] i2c-adapter i2c-4: unable to read EDID block.
[   19.771454] i915 0000:00:02.0: HDMI Type A-2: no EDID data
[   20.502641] i2c-adapter i2c-4: unable to read EDID block.
[   20.502644] i915 0000:00:02.0: HDMI Type A-2: no EDID data
[   20.507874] i2c-adapter i2c-4: unable to read EDID block.
[   20.507877] i915 0000:00:02.0: HDMI Type A-2: no EDID data
[   20.736381] vboxdrv: Trying to deactivate the NMI watchdog permanently...
[   20.736383] vboxdrv: Successfully done.
[   20.736385] vboxdrv: Found 2 processor cores.
[   20.736481] vboxdrv: fAsync=0 offMin=0x195 offMax=0x2142
[   20.736515] vboxdrv: TSC mode is 'synchronous', kernel timer mode is 'normal'.
[   20.736516] vboxdrv: Successfully loaded version 3.1.2 (interface 0x00100001).
[   20.959183] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
[   20.959186] Bluetooth: BNEP filters: protocol multicast
[   20.970734] Bridge firewalling registered
[   21.612804] e1000e: eth0 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: None
[   21.612989] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   21.692450] cfg80211: Found new beacon on frequency: 5745 MHz (Ch 149) on phy0
[   24.547522] i2c-adapter i2c-4: unable to read EDID block.
[   24.547526] i915 0000:00:02.0: HDMI Type A-2: no EDID data
[   24.551938] i2c-adapter i2c-4: unable to read EDID block.
[   24.551939] i915 0000:00:02.0: HDMI Type A-2: no EDID data
[   25.288679] i2c-adapter i2c-4: unable to read EDID block.
[   25.288683] i915 0000:00:02.0: HDMI Type A-2: no EDID data
[   25.293097] i2c-adapter i2c-4: unable to read EDID block.
[   25.293099] i915 0000:00:02.0: HDMI Type A-2: no EDID data
[   26.032453] i2c-adapter i2c-4: unable to read EDID block.
[   26.032456] i915 0000:00:02.0: HDMI Type A-2: no EDID data
[   26.036869] i2c-adapter i2c-4: unable to read EDID block.
[   26.036871] i915 0000:00:02.0: HDMI Type A-2: no EDID data
[   27.430232] i2c-adapter i2c-4: unable to read EDID block.
[   27.430236] i915 0000:00:02.0: HDMI Type A-2: no EDID data
[   27.434923] i2c-adapter i2c-4: unable to read EDID block.
[   27.434925] i915 0000:00:02.0: HDMI Type A-2: no EDID data
[   33.285090] wlan0: authenticate with AP 00:22:90:ea:d8:f0
[   33.286937] wlan0: authenticated
[   33.286939] wlan0: associate with AP 00:22:90:ea:d8:f0
[   33.290280] wlan0: RX AssocResp from 00:22:90:ea:d8:f0 (capab=0x421 status=0 aid=8)
[   33.290285] wlan0: associated
[   33.291954] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[   43.328058] wlan0: no IPv6 routers present