[   36.622515] eth0: no IPv6 routers present
[   37.472661] ACPI: PCI Interrupt Link [ALKC] enabled at IRQ 22
[   37.472667]   alloc irq_desc for 22 on node 0
[   37.472669]   alloc kstat_irqs on node 0
[   37.472677] VIA 82xx Audio 0000:00:11.5: PCI INT C -> Link[ALKC] -> GSI 22 (level, low) -> IRQ 22
[   37.472838] VIA 82xx Audio 0000:00:11.5: setting latency timer to 64
[   38.314178] ath5k phy0: noise floor calibration failed (2417MHz)
[   38.508114] ath5k phy0: noise floor calibration failed (2427MHz)
[   38.607915] ath5k phy0: noise floor calibration failed (2432MHz)
[   38.708951] ath5k phy0: noise floor calibration failed (2437MHz)
[   38.808163] ath5k phy0: noise floor calibration failed (2442MHz)
[   38.907983] ath5k phy0: noise floor calibration failed (2447MHz)
[   39.259842] ath5k phy0: noise floor calibration failed (2412MHz)
[   39.821781] __ratelimit: 6 callbacks suppressed
[   39.821784] type=1503 audit(1260109263.661:26): operation="open" pid=1613 parent=1612 profile="/usr/sbin/mysqld" requested_mask="r::" denied_mask="r::" fsuid=0 ouid=0 name="/sys/devices/system/cpu/"
[   40.780887] usplash:379 freeing invalid memtype ffffffffc0000000-ffffffffd0000000
[   41.088544] type=1503 audit(1260109264.922:27): operation="open" pid=1714 parent=1713 profile="/usr/sbin/mysqld" requested_mask="r::" denied_mask="r::" fsuid=0 ouid=0 name="/sys/devices/system/cpu/"
[   41.500260] type=1503 audit(1260109265.340:28): operation="open" pid=1826 parent=1721 profile="/usr/sbin/mysqld" requested_mask="r::" denied_mask="r::" fsuid=0 ouid=0 name="/sys/devices/system/cpu/"
[   42.197293] type=1503 audit(1260109266.030:29): operation="open" pid=1836 parent=1835 profile="/usr/sbin/mysqld" requested_mask="r::" denied_mask="r::" fsuid=0 ouid=0 name="/sys/devices/system/cpu/"
[   43.258098] type=1503 audit(1260109267.090:30): operation="open" pid=1854 parent=1853 profile="/usr/sbin/mysqld" requested_mask="r::" denied_mask="r::" fsuid=0 ouid=0 name="/sys/devices/system/cpu/"
[   43.319229] type=1503 audit(1260109267.150:31): operation="open" pid=1865 parent=1864 profile="/usr/sbin/mysqld" requested_mask="r::" denied_mask="r::" fsuid=0 ouid=0 name="/sys/devices/system/cpu/"
[   45.270854] /dev/vmmon[1897]: Module vmmon: registered with major=10 minor=165
[   45.270868] /dev/vmmon[1897]: Initial HV check: anyNotCapable=0 anyUnlocked=1 anyEnabled=1 anyDisabled=0
[   45.270873] /dev/vmmon[1897]: HV check: anyNotCapable=0 anyUnlocked=1 anyEnabled=1 anyDisabled=0
[   45.270875] /dev/vmmon[1897]: Module vmmon: initialized
[   45.430327] /dev/vmci[1919]: VMCI: Driver initialized.
[   45.430376] /dev/vmci[1919]: Module vmci: registered with major=10 minor=54
[   45.430378] /dev/vmci[1919]: Module vmci: initialized
[   45.748158] ppdev: user-space parallel port driver
[   46.111128] /dev/vmnet: open called by PID 1957 (vmnet-bridge)
[   46.111138] /dev/vmnet: hub 0 does not exist, allocating memory.
[   46.111151] /dev/vmnet: port on hub 0 successfully opened
[   46.111166] bridge-eth0: up
[   46.111169] bridge-eth0: attached
[   49.180308] /dev/vmnet: open called by PID 2477 (vmnet-dhcpd)
[   49.180318] /dev/vmnet: hub 1 does not exist, allocating memory.
[   49.180331] /dev/vmnet: port on hub 1 successfully opened
[   49.203946] /dev/vmnet: open called by PID 2481 (vmnet-netifup)
[   49.203960] /dev/vmnet: port on hub 1 successfully opened
[   49.430382] /dev/vmnet: open called by PID 2484 (vmnet-dhcpd)
[   49.430394] /dev/vmnet: hub 8 does not exist, allocating memory.
[   49.430407] /dev/vmnet: port on hub 8 successfully opened
[   49.630224] /dev/vmnet: open called by PID 2487 (vmnet-natd)
[   49.630239] /dev/vmnet: port on hub 8 successfully opened
[   49.672125] /dev/vmnet: open called by PID 2493 (vmnet-netifup)
[   49.672142] /dev/vmnet: port on hub 8 successfully opened
[   57.830435] svc: failed to register lockdv1 RPC service (errno 97).
[   57.831145] NFSD: Using /var/lib/nfs/v4recovery as the NFSv4 state recovery directory
[   57.831183] NFSD: starting 90-second grace period
[   58.378060] ath5k phy0: noise floor calibration failed (2422MHz)
[   58.486254] ath5k phy0: noise floor calibration failed (2427MHz)
[   58.689750] ath5k phy0: noise floor calibration failed (2437MHz)
[   58.797045] ath5k phy0: noise floor calibration failed (2442MHz)
[   59.265847] ath5k phy0: noise floor calibration failed (2412MHz)
[   60.120012] vmnet1: no IPv6 routers present
[   60.640010] vmnet8: no IPv6 routers present
[   63.053675] ath5k phy0: noise floor calibration failed (2412MHz)
[   63.489165] usb 2-1: usbfs: interface 0 claimed by usblp while 'usb' sets config #1
[   88.376659] ath5k phy0: noise floor calibration failed (2422MHz)
[   88.481213] ath5k phy0: noise floor calibration failed (2427MHz)
[   93.051924] ath5k phy0: noise floor calibration failed (2412MHz)
[  113.054536] ath5k phy0: noise floor calibration failed (2412MHz)
[  126.422528] Clocksource tsc unstable (delta = -216357270 ns)
[  126.426307] ath5k phy0: noise floor calibration failed (2422MHz)
[  126.538172] ath5k phy0: noise floor calibration failed (2427MHz)
[  127.441060] ath5k phy0: noise floor calibration failed (2437MHz)
[  127.441701] wlan0: authenticate with AP 00:0f:b5:a7:f4:cc
[  127.516428] wlan0: authenticated
[  127.516437] wlan0: associate with AP 00:0f:b5:a7:f4:cc
[  127.525551] wlan0: RX AssocResp from 00:0f:b5:a7:f4:cc (capab=0x431 status=0 aid=1)
[  127.525557] wlan0: associated
[  127.527346] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[  128.390518] ath5k phy0: noise floor calibration failed (2422MHz)
[  128.504396] ath5k phy0: noise floor calibration failed (2427MHz)
[  128.678980] ath5k phy0: noise floor calibration failed (2432MHz)
[  129.544139] ath5k phy0: noise floor calibration failed (2437MHz)
[  133.053886] ath5k phy0: noise floor calibration failed (2437MHz)
[  137.792510] wlan0: no IPv6 routers present
[  143.054816] ath5k phy0: noise floor calibration failed (2437MHz)
[  151.420030] usb 1-4: new high speed USB device using ehci_hcd and address 7
[  151.575330] usb 1-4: configuration #1 chosen from 1 choice
[  151.576542] scsi6 : SCSI emulation for USB Mass Storage devices
[  151.576843] usb-storage: device found at 7
[  151.576847] usb-storage: waiting for device to settle before scanning
[  153.061314] ath5k phy0: noise floor calibration failed (2437MHz)
[  156.572763] usb-storage: device scan complete
[  156.599816] scsi 6:0:0:0: Direct-Access     Verbatim STORE N GO       5.00 PQ: 0 ANSI: 0 CCS
[  156.601010] sd 6:0:0:0: Attached scsi generic sg7 type 0
[  157.333613] sd 6:0:0:0: [sdg] 15630336 512-byte logical blocks: (8.00 GB/7.45 GiB)
[  157.334095] sd 6:0:0:0: [sdg] Write Protect is off
[  157.334101] sd 6:0:0:0: [sdg] Mode Sense: 23 00 00 00
[  157.334107] sd 6:0:0:0: [sdg] Assuming drive cache: write through
[  157.337467] sd 6:0:0:0: [sdg] Assuming drive cache: write through
[  157.337475]  sdg: sdg1 sdg2
[  157.400592] sd 6:0:0:0: [sdg] Assuming drive cache: write through
[  157.400606] sd 6:0:0:0: [sdg] Attached SCSI removable disk
[  159.144826] REISERFS (device sdg2): found reiserfs format "3.6" with standard journal
[  159.144843] REISERFS (device sdg2): using ordered data mode
[  159.145853] REISERFS (device sdg2): journal params: device sdg2, size 8192, journal first block 18, max trans len 1024, max batch 900, max commit age 30, max trans age 30
[  159.146732] REISERFS (device sdg2): checking transaction log (sdg2)
[  159.444931] REISERFS (device sdg2): Using r5 hash to sort names
[  178.240537] ath5k phy0: noise floor calibration failed (2412MHz)
[  178.643046] ath5k phy0: noise floor calibration failed (2432MHz)
[  178.755451] ath5k phy0: noise floor calibration failed (2437MHz)
[  179.271219] ath5k phy0: noise floor calibration failed (2437MHz)
[  218.505718] ath5k phy0: noise floor calibration failed (2427MHz)
[  218.617732] ath5k phy0: noise floor calibration failed (2432MHz)
[  218.833165] ath5k phy0: noise floor calibration failed (2437MHz)
[  253.118082] ath5k phy0: noise floor calibration failed (2437MHz)
[  278.422936] ath5k phy0: noise floor calibration failed (2422MHz)
[  278.530492] ath5k phy0: noise floor calibration failed (2427MHz)
[  279.405089] ath5k phy0: noise floor calibration failed (2437MHz)
[  313.063277] ath5k phy0: noise floor calibration failed (2437MHz)
[  358.422501] ath5k phy0: noise floor calibration failed (2422MHz)
[  358.528041] ath5k phy0: noise floor calibration failed (2427MHz)
[  371.616513] ath5k phy0: unsupported jumbo
[  455.216658] ath5k phy0: unsupported jumbo
[  458.685438] ath5k phy0: noise floor calibration failed (2422MHz)
[  458.788180] ath5k phy0: noise floor calibration failed (2427MHz)
[  458.887393] ath5k phy0: noise floor calibration failed (2432MHz)
[  458.988896] ath5k phy0: noise floor calibration failed (2437MHz)
[  513.059130] ath5k phy0: noise floor calibration failed (2437MHz)
[  513.104192] ath5k phy0: noise floor calibration failed (2437MHz)
[  578.694018] ath5k phy0: noise floor calibration failed (2422MHz)
[  578.899212] ath5k phy0: noise floor calibration failed (2432MHz)
[  579.024388] ath5k phy0: noise floor calibration failed (2437MHz)
[  586.922522] wlan0: deauthenticating by local choice (reason=3)
[  587.473093] ath5k 0000:00:0b.0: PCI INT A disabled
[  609.563219] usb 1-4: USB disconnect, address 7