[   17.511612] ppdev: user-space parallel port driver
[   19.423256] eth0: Media Link Off
[   19.423357] ADDRCONF(NETDEV_UP): eth0: link is not ready
[   19.504049] b43 ssb0:0: firmware: requesting b43/ucode5.fw
[   19.703552] b43 ssb0:0: firmware: requesting b43/pcm5.fw
[   19.798234] b43 ssb0:0: firmware: requesting b43/b0g0initvals5.fw
[   19.920262] b43 ssb0:0: firmware: requesting b43/b0g0bsinitvals5.fw
[   20.144032] b43-phy0: Loading firmware version 410.2160 (2007-05-26 15:32:10)
[   20.188407] Registered led device: b43-phy0::tx
[   20.188433] Registered led device: b43-phy0::rx
[   20.188456] Registered led device: b43-phy0::radio
[   20.188772] ADDRCONF(NETDEV_UP): wlan1: link is not ready
[   20.218551] b43-phy0: Radio hardware status changed to DISABLED
[   71.652112] usb 2-2: new low speed USB device using ohci_hcd and address 2
[   71.869144] usb 2-2: configuration #1 chosen from 1 choice
[   71.961067] usbcore: registered new interface driver hiddev
[   71.961136] usbcore: registered new interface driver usbhid
[   71.961139] usbhid: v2.6:USB HID core driver
[   72.267702] input: Primax Electronics Apple Optical USB Mouse as /devices/pci0000:00/0000:00:03.0/usb2/2-2/2-2:1.0/input/input7
[   72.267823] apple 0003:05AC:0304.0001: input,hidraw0: USB HID v1.10 Mouse [Primax Electronics Apple Optical USB Mouse] on usb-0000:00:03.0-2/input0
[   84.152044] Clocksource tsc unstable (delta = -273943035 ns)
[   90.836057] b43-phy0: Radio hardware status changed to ENABLED
[   91.000060] b43-phy0: Loading firmware version 410.2160 (2007-05-26 15:32:10)
[   91.036506] Registered led device: b43-phy0::tx
[   91.036549] Registered led device: b43-phy0::rx
[   91.036589] Registered led device: b43-phy0::radio
[   91.037011] ADDRCONF(NETDEV_UP): wlan1: link is not ready
[  101.837601] wlan1: authenticate with AP 00:06:25:4b:18:e9
[  101.840541] wlan1: authenticated
[  101.840553] wlan1: associate with AP 00:06:25:4b:18:e9
[  101.844846] wlan1: RX AssocResp from 00:06:25:4b:18:e9 (capab=0x411 status=0 aid=4)
[  101.844856] wlan1: associated
[  101.846880] ADDRCONF(NETDEV_CHANGE): wlan1: link becomes ready
[  112.064044] wlan1: no IPv6 routers present
[  513.975063] cfg80211: Found new beacon on frequency: 2472 MHz (Ch 13) on phy0
[ 2332.467975] usb 2-2: USB disconnect, address 2
[ 2332.900079] usb 2-2: new low speed USB device using ohci_hcd and address 3
[ 2333.116259] usb 2-2: configuration #1 chosen from 1 choice
[ 2333.126808] input: Primax Electronics Apple Optical USB Mouse as /devices/pci0000:00/0000:00:03.0/usb2/2-2/2-2:1.0/input/input8
[ 2333.127018] apple 0003:05AC:0304.0002: input,hidraw0: USB HID v1.10 Mouse [Primax Electronics Apple Optical USB Mouse] on usb-0000:00:03.0-2/input0
[ 2377.701779] usb 2-2: USB disconnect, address 3
[ 2378.120083] usb 2-2: new low speed USB device using ohci_hcd and address 4
[ 2378.348713] usb 2-2: configuration #1 chosen from 1 choice
[ 2378.361838] input: Primax Electronics Apple Optical USB Mouse as /devices/pci0000:00/0000:00:03.0/usb2/2-2/2-2:1.0/input/input9
[ 2378.362062] apple 0003:05AC:0304.0003: input,hidraw0: USB HID v1.10 Mouse [Primax Electronics Apple Optical USB Mouse] on usb-0000:00:03.0-2/input0
[ 2378.608083] usb 1-4: new high speed USB device using ehci_hcd and address 3
[ 2378.746176] usb 1-4: configuration #1 chosen from 1 choice
[ 2378.885176] Initializing USB Mass Storage driver...
[ 2378.887196] scsi2 : SCSI emulation for USB Mass Storage devices
[ 2378.887611] usbcore: registered new interface driver usb-storage
[ 2378.887619] USB Mass Storage support registered.
[ 2378.889621] usb-storage: device found at 3
[ 2378.889629] usb-storage: waiting for device to settle before scanning
[ 2383.888450] usb-storage: device scan complete
[ 2383.889367] scsi 2:0:0:0: Direct-Access     SanDisk  SDCFX4-2048      HDX  PQ: 0 ANSI: 0
[ 2383.890361] sd 2:0:0:0: Attached scsi generic sg2 type 0
[ 2383.907566] sd 2:0:0:0: [sdb] Adjusting the sector count from its reported value: 4001761
[ 2383.907584] sd 2:0:0:0: [sdb] 4001760 512-byte logical blocks: (2.04 GB/1.90 GiB)
[ 2383.910697] sd 2:0:0:0: [sdb] Write Protect is off
[ 2383.910709] sd 2:0:0:0: [sdb] Mode Sense: 03 00 00 00
[ 2383.910716] sd 2:0:0:0: [sdb] Assuming drive cache: write through
[ 2383.913808] sd 2:0:0:0: [sdb] Adjusting the sector count from its reported value: 4001761
[ 2383.920105] sd 2:0:0:0: [sdb] Assuming drive cache: write through
[ 2383.920121]  sdb: unknown partition table
[ 2383.940177] sd 2:0:0:0: [sdb] Adjusting the sector count from its reported value: 4001761
[ 2383.948859] sd 2:0:0:0: [sdb] Assuming drive cache: write through
[ 2383.948872] sd 2:0:0:0: [sdb] Attached SCSI disk
[ 2405.804224] usb 1-4: USB disconnect, address 3
[ 2418.287872] usb 2-2: USB disconnect, address 4
[ 2418.724088] usb 2-2: new low speed USB device using ohci_hcd and address 5
[ 2418.939954] usb 2-2: configuration #1 chosen from 1 choice
[ 2418.952633] input: Primax Electronics Apple Optical USB Mouse as /devices/pci0000:00/0000:00:03.0/usb2/2-2/2-2:1.0/input/input10
[ 2418.952846] apple 0003:05AC:0304.0004: input,hidraw0: USB HID v1.10 Mouse [Primax Electronics Apple Optical USB Mouse] on usb-0000:00:03.0-2/input0
[ 2419.064079] usb 1-4: new high speed USB device using ehci_hcd and address 4
[ 2419.204313] usb 1-4: configuration #1 chosen from 1 choice
[ 2419.207572] scsi3 : SCSI emulation for USB Mass Storage devices
[ 2419.210529] usb-storage: device found at 4
[ 2419.210537] usb-storage: waiting for device to settle before scanning
[ 2424.208498] usb-storage: device scan complete
[ 2424.209218] scsi 3:0:0:0: Direct-Access     SanDisk  SDCFXP-016G      HDX  PQ: 0 ANSI: 0
[ 2424.210168] sd 3:0:0:0: Attached scsi generic sg2 type 0
[ 2424.232804] sd 3:0:0:0: [sdb] Adjusting the sector count from its reported value: 31277233
[ 2424.232823] sd 3:0:0:0: [sdb] 31277232 512-byte logical blocks: (16.0 GB/14.9 GiB)
[ 2424.235705] sd 3:0:0:0: [sdb] Write Protect is off
[ 2424.235717] sd 3:0:0:0: [sdb] Mode Sense: 03 00 00 00
[ 2424.235723] sd 3:0:0:0: [sdb] Assuming drive cache: write through
[ 2424.238122] sd 3:0:0:0: [sdb] Adjusting the sector count from its reported value: 31277233
[ 2424.248340] sd 3:0:0:0: [sdb] Assuming drive cache: write through
[ 2424.248358]  sdb:
[ 2424.299181] sd 3:0:0:0: [sdb] Adjusting the sector count from its reported value: 31277233
[ 2424.304169] sd 3:0:0:0: [sdb] Assuming drive cache: write through
[ 2424.304185] sd 3:0:0:0: [sdb] Attached SCSI disk
[ 2598.966725] usb 1-4: USB disconnect, address 4
[ 2602.034099] usb 2-2: USB disconnect, address 5
[ 2602.452064] usb 2-2: new low speed USB device using ohci_hcd and address 6
[ 2602.681332] usb 2-2: configuration #1 chosen from 1 choice
[ 2602.691848] input: Primax Electronics Apple Optical USB Mouse as /devices/pci0000:00/0000:00:03.0/usb2/2-2/2-2:1.0/input/input11
[ 2602.693074] apple 0003:05AC:0304.0005: input,hidraw0: USB HID v1.10 Mouse [Primax Electronics Apple Optical USB Mouse] on usb-0000:00:03.0-2/input0
[ 2629.148081] usb 1-4: new high speed USB device using ehci_hcd and address 5
[ 2629.282192] usb 1-4: configuration #1 chosen from 1 choice
[ 2629.284590] scsi4 : SCSI emulation for USB Mass Storage devices
[ 2629.284820] usb-storage: device found at 5
[ 2629.284825] usb-storage: waiting for device to settle before scanning
[ 2634.284377] usb-storage: device scan complete
[ 2634.289051] scsi 4:0:0:0: Direct-Access     SanDisk  SDCFXP-016G      HDX  PQ: 0 ANSI: 0
[ 2634.290593] sd 4:0:0:0: Attached scsi generic sg2 type 0
[ 2634.302714] sd 4:0:0:0: [sdb] Adjusting the sector count from its reported value: 31277233
[ 2634.302733] sd 4:0:0:0: [sdb] 31277232 512-byte logical blocks: (16.0 GB/14.9 GiB)
[ 2634.307666] sd 4:0:0:0: [sdb] Write Protect is off
[ 2634.307679] sd 4:0:0:0: [sdb] Mode Sense: 03 00 00 00
[ 2634.307686] sd 4:0:0:0: [sdb] Assuming drive cache: write through
[ 2634.311903] sd 4:0:0:0: [sdb] Adjusting the sector count from its reported value: 31277233
[ 2634.316915] sd 4:0:0:0: [sdb] Assuming drive cache: write through
[ 2634.316932]  sdb:
[ 2634.378633] sd 4:0:0:0: [sdb] Adjusting the sector count from its reported value: 31277233
[ 2634.384485] sd 4:0:0:0: [sdb] Assuming drive cache: write through
[ 2634.384501] sd 4:0:0:0: [sdb] Attached SCSI disk
[ 2674.208578] usb 1-4: USB disconnect, address 5
[ 5459.592055] pcmcia_socket pcmcia_socket0: pccard: CardBus card inserted into slot 0
[ 5459.592116] pci 0000:02:00.0: reg 10 io port: [0xfff8-0xffff]
[ 5459.592131] pci 0000:02:00.0: reg 14 io port: [0xfffc-0xffff]
[ 5459.592144] pci 0000:02:00.0: reg 18 io port: [0x00-0x3f]
[ 5459.592157] pci 0000:02:00.0: reg 1c 32bit mmio: [0x000000-0x000fff]