[   53.981801] usplash:391 freeing invalid memtype ffffffffd5000000-ffffffffd5e00000
[   56.332829] e1000e 0000:00:19.0: irq 31 for MSI/MSI-X
[   56.392685] e1000e 0000:00:19.0: irq 31 for MSI/MSI-X
[   56.393046] ADDRCONF(NETDEV_UP): eth2: link is not ready
[   56.441213] iwlagn 0000:03:00.0: firmware: requesting iwlwifi-4965-2.ucode
[   56.861345] iwlagn 0000:03:00.0: loaded firmware version 228.61.2.24
[   57.078422] Registered led device: iwl-phy0::radio
[   57.078440] Registered led device: iwl-phy0::assoc
[   57.078456] Registered led device: iwl-phy0::RX
[   57.078472] Registered led device: iwl-phy0::TX
[   57.139270] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   57.910987] e1000e: eth2 NIC Link is Up 100 Mbps Full Duplex, Flow Control: RX/TX
[   57.910990] 0000:00:19.0: eth2: 10/100 speed: disabling TSO
[   57.911242] ADDRCONF(NETDEV_CHANGE): eth2: link becomes ready
[   58.975713] cfg80211: Found new beacon on frequency: 5180 MHz (Ch 36) on phy0
[   59.816791] cfg80211: Found new beacon on frequency: 5745 MHz (Ch 149) on phy0
[   60.074568] cfg80211: Found new beacon on frequency: 5805 MHz (Ch 161) on phy0
[   64.478563] vboxdrv: Trying to deactivate the NMI watchdog permanently...
[   64.478567] vboxdrv: Warning: 2.6.31+ kernel detected. Most likely the hwardware performance
[   64.478569] vboxdrv: counter framework which can generate NMIs is active. You have to prevent
[   64.478570] vboxdrv: the usage of hardware performance counters by
[   64.478571] vboxdrv:   echo 2 > /proc/sys/kernel/perf_counter_paranoid
[   64.478575] vboxdrv: Found 2 processor cores.
[   64.478630] VBoxDrv: dbg - g_abExecMemory=ffffffffa0ca4420
[   64.478643] vboxdrv: fAsync=1 offMin=0x10aefa offMax=0x10aefa
[   64.478699] vboxdrv: TSC mode is 'asynchronous', kernel timer mode is 'normal'.
[   64.478701] vboxdrv: Successfully loaded version 3.0.10 (interface 0x000e0001).
[   64.726021] VBoxNetFlt: dbg - g_abExecMemory=ffffffffa0e431c0
[   64.728878] VBoxNetAdp: dbg - g_abExecMemory=ffffffffa0e5cac0
[   65.729635] ppdev: user-space parallel port driver
[   66.584475] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
[   66.584479] Bluetooth: BNEP filters: protocol multicast
[   66.743726] Bridge firewalling registered
[   68.090068] eth2: no IPv6 routers present
[   79.841895] cfg80211: Found new beacon on frequency: 5240 MHz (Ch 48) on phy0
[   89.275170] input: Virtual ThinkFinger Keyboard as /devices/virtual/input/input10
[  125.713034] wlan0: authenticate with AP 00:22:90:5e:37:50
[  125.715143] wlan0: authenticated
[  125.715145] wlan0: associate with AP 00:22:90:5e:37:50
[  125.720189] wlan0: RX AssocResp from 00:22:90:5e:37:50 (capab=0x31 status=0 aid=9)
[  125.720193] wlan0: associated
[  125.747739] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[  125.767033] cfg80211: Calling CRDA for country: CA
[  125.768756] cfg80211: Received country IE:
[  125.768758] cfg80211: Regulatory domain: CA
[  125.768760] 	(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[  125.768762] 	(2402000 KHz - 2477000 KHz @ 40000 KHz), (10000 mBi, 10000 mBm)
[  125.768764] cfg80211: CRDA thinks this should applied:
[  125.768766] cfg80211: Regulatory domain: CA
[  125.768767] 	(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[  125.768770] 	(2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm)
[  125.768772] 	(5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 1700 mBm)
[  125.768774] 	(5250000 KHz - 5330000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[  125.768777] 	(5490000 KHz - 5710000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[  125.768779] 	(5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 3000 mBm)
[  125.768780] cfg80211: We intersect both of these and get:
[  125.768782] cfg80211: Regulatory domain: 98
[  125.768783] 	(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[  125.768786] 	(2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm)
[  125.768790] cfg80211: Leaving channel 5180 MHz intact on phy0 - no rule found in band on Country IE
[  125.768792] cfg80211: Leaving channel 5200 MHz intact on phy0 - no rule found in band on Country IE
[  125.768794] cfg80211: Leaving channel 5220 MHz intact on phy0 - no rule found in band on Country IE
[  125.768796] cfg80211: Leaving channel 5240 MHz intact on phy0 - no rule found in band on Country IE
[  125.768799] cfg80211: Leaving channel 5260 MHz intact on phy0 - no rule found in band on Country IE
[  125.768801] cfg80211: Leaving channel 5280 MHz intact on phy0 - no rule found in band on Country IE
[  125.768803] cfg80211: Leaving channel 5300 MHz intact on phy0 - no rule found in band on Country IE
[  125.768805] cfg80211: Leaving channel 5320 MHz intact on phy0 - no rule found in band on Country IE
[  125.768807] cfg80211: Leaving channel 5745 MHz intact on phy0 - no rule found in band on Country IE
[  125.768809] cfg80211: Leaving channel 5765 MHz intact on phy0 - no rule found in band on Country IE
[  125.768811] cfg80211: Leaving channel 5785 MHz intact on phy0 - no rule found in band on Country IE
[  125.768814] cfg80211: Leaving channel 5805 MHz intact on phy0 - no rule found in band on Country IE
[  125.768816] cfg80211: Leaving channel 5825 MHz intact on phy0 - no rule found in band on Country IE
[  125.768819] cfg80211: Current regulatory domain updated by AP to: CA
[  125.768821] 	(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[  125.768823] 	(2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm)
[  136.410060] wlan0: no IPv6 routers present
[  958.828504] input: Virtual ThinkFinger Keyboard as /devices/virtual/input/input11