[   29.894732] ADDRCONF(NETDEV_UP): eth0: link is not ready
[   32.820209] b44: eth0: Link is up at 100 Mbps, full duplex.
[   32.820216] b44: eth0: Flow control is off for TX and off for RX.
[   32.820519] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   33.131536] intel_rng: FWH not detected
[   33.448513] Synaptics Touchpad, model: 1, fw: 6.2, id: 0x25a0b1, caps: 0xa04793/0x300000
[   33.448524] serio: Synaptics pass-through port at isa0060/serio4/input0
[   33.490024] input: SynPS/2 Synaptics TouchPad as /devices/platform/i8042/serio4/input/input8
[   34.491585] iwl3945: Intel(R) PRO/Wireless 3945ABG/BG Network Connection driver for Linux, 1.2.26ks
[   34.491590] iwl3945: Copyright(c) 2003-2009 Intel Corporation
[   34.491700] iwl3945 0000:10:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
[   34.491717] iwl3945 0000:10:00.0: setting latency timer to 64
[   34.500020] yenta_cardbus 0000:02:06.0: CardBus bridge found [103c:30a2]
[   34.500051] yenta_cardbus 0000:02:06.0: Enabling burst memory read transactions
[   34.500063] yenta_cardbus 0000:02:06.0: Using INTVAL to route CSC interrupts to PCI
[   34.500066] yenta_cardbus 0000:02:06.0: Routing CardBus interrupts to PCI
[   34.500078] yenta_cardbus 0000:02:06.0: TI: mfunc 0x01011b22, devctl 0x64
[   34.503800] lp: driver loaded but no devices found
[   34.563553] iwl3945 0000:10:00.0: Tunable channels: 13 802.11bg, 23 802.11a channels
[   34.563557] iwl3945 0000:10:00.0: Detected Intel Wireless WiFi Link 3945ABG
[   34.563675]   alloc irq_desc for 28 on node -1
[   34.563677]   alloc kstat_irqs on node -1
[   34.563712] iwl3945 0000:10:00.0: irq 28 for MSI/MSI-X
[   34.721944] yenta_cardbus 0000:02:06.0: ISA IRQ mask 0x0cf8, PCI irq 18
[   34.721949] yenta_cardbus 0000:02:06.0: Socket status: 30000006
[   34.721954] pci_bus 0000:02: Raising subordinate bus# of parent bus (#02) from #03 to #06
[   34.721964] yenta_cardbus 0000:02:06.0: pcmcia: parent PCI bridge I/O window: 0x5000 - 0x5fff
[   34.721967] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x5000-0x5fff: clean.
[   34.722224] yenta_cardbus 0000:02:06.0: pcmcia: parent PCI bridge Memory window: 0xf4100000 - 0xf43fffff
[   34.722227] yenta_cardbus 0000:02:06.0: pcmcia: parent PCI bridge Memory window: 0x40000000 - 0x43ffffff
[   35.366765] parport_pc 00:02: reported by Plug and Play ACPI
[   35.366840] parport0: PC-style at 0x378 (0x778), irq 7, dma 1 [PCSPP,TRISTATE,COMPAT,ECP,DMA]
[   35.464341] lp0: using parport0 (interrupt-driven).
[   35.519975] ppdev: user-space parallel port driver
[   35.594976] phy0: Selected rate control algorithm 'iwl-3945-rs'
[   35.875077] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x100-0x3af: clean.
[   35.877159] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x3e0-0x4ff: clean.
[   35.878024] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x820-0x8ff: clean.
[   35.878742] pcmcia_socket pcmcia_socket0: cs: IO port probe 0xc00-0xcf7: clean.
[   35.879650] pcmcia_socket pcmcia_socket0: cs: IO port probe 0xa00-0xaff: clean.
[   36.174220] iwl3945 0000:10:00.0: firmware: requesting iwlwifi-3945-2.ucode
[   36.259729] iwl3945 0000:10:00.0: loaded firmware version 15.32.2.9
[   36.259901] iwl3945 0000:10:00.0: Radio disabled by HW RF Kill switch
[   36.311830] iwl3945 0000:10:00.0: Radio disabled by HW RF Kill switch
[   39.167010] [drm] TV-14: set mode NTSC 480i 0
[   39.307134] [drm] TV-14: set mode NTSC 480i 0
[   39.644308] [drm] TV-14: set mode NTSC 480i 0
[   39.784346] [drm] TV-14: set mode NTSC 480i 0
[   43.060036] eth0: no IPv6 routers present
[   51.146909] [drm] TV-14: set mode NTSC 480i 0
[   51.287436] [drm] TV-14: set mode NTSC 480i 0
[   51.566849] [drm] TV-14: set mode NTSC 480i 0
[   51.706831] [drm] TV-14: set mode NTSC 480i 0
[   52.002845] [drm] TV-14: set mode NTSC 480i 0
[   52.142812] [drm] TV-14: set mode NTSC 480i 0
[   97.311512] [drm] TV-14: set mode NTSC 480i 0
[   97.460960] [drm] TV-14: set mode NTSC 480i 0
[   97.742859] [drm] TV-14: set mode NTSC 480i 0
[   97.882932] [drm] TV-14: set mode NTSC 480i 0
[   98.182830] [drm] TV-14: set mode NTSC 480i 0
[   98.322815] [drm] TV-14: set mode NTSC 480i 0