[    7.391605]   alloc irq_desc for 31 on node 0
[    7.391609]   alloc kstat_irqs on node 0
[    7.391622] ATL1E 0000:05:00.0: irq 31 for MSI/MSI-X
[    7.391747] ATL1E 0000:05:00.0: ATL1E: eth0 NIC Link is Up<100 Mbps Full Duplex>
[    7.392056] ADDRCONF(NETDEV_UP): eth0: link is not ready
[    7.392401] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[    8.255071] fglrx: module license 'Proprietary. (C) 2002 - ATI Technologies, Starnberg, GERMANY' taints kernel.
[    8.255076] Disabling lock debugging due to kernel taint
[    8.267784] [fglrx] Maximum main memory to use for locked dma buffers: 3802 MBytes.
[    8.267872] [fglrx]   vendor: 1002 device: 9441 count: 1
[    8.267875] [fglrx]   vendor: 1002 device: 9441 count: 2
[    8.268281] [fglrx] ioport: bar 4, base 0xa000, size: 0x100
[    8.268298] pci 0000:03:00.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
[    8.268304] pci 0000:03:00.0: setting latency timer to 64
[    8.268341] [fglrx] ioport: bar 4, base 0xb000, size: 0x100
[    8.268350] pci 0000:04:00.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
[    8.268354] pci 0000:04:00.0: setting latency timer to 64
[    8.268675] [fglrx] Kernel PAT support is enabled
[    8.268714] [fglrx] module loaded - fglrx 8.66.10 [Sep  3 2009] with 2 minors
[    8.525747] ip_tables: (C) 2000-2006 Netfilter Core Team
[   10.054138] lp: driver loaded but no devices found
[   10.065874] shpchp: Standard Hot Plug PCI Controller Driver version: 0.4
[   10.763764] index: expects arguments
[   10.763769] snd_hda_intel: `' invalid for parameter `index'
[   10.806899] index: expects arguments
[   10.806904] snd_hda_intel: `' invalid for parameter `index'
[   10.843006] index: expects arguments
[   10.843010] snd_hda_intel: `' invalid for parameter `index'
[   11.537212] AV200 0000:08:04.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
[   13.471688] ppdev: user-space parallel port driver
[   14.801554] usplash:388 freeing invalid memtype ffffffffc0000000-ffffffffc1000000
[   16.429050] [fglrx] Firegl kernel thread PID: 1620
[   16.454839] [fglrx] Firegl kernel thread PID: 1621
[   17.460012] eth0: no IPv6 routers present
[   18.352052] [fglrx] Gart USWC size:1237 M.
[   18.352056] [fglrx] Gart cacheable size:491 M.
[   18.352061] [fglrx] Reserved FB block: Shared offset:0, size:1000000 
[   18.352063] [fglrx] Reserved FB block: Unshared offset:fb9e000, size:462000 
[   18.352065] [fglrx] Reserved FB block: Unshared offset:3fffb000, size:5000 
[  120.020029] usb 1-1: new high speed USB device using ehci_hcd and address 2
[  120.187464] usb 1-1: configuration #1 chosen from 1 choice
[  120.279768] Initializing USB Mass Storage driver...
[  120.279919] scsi6 : SCSI emulation for USB Mass Storage devices
[  120.280055] usbcore: registered new interface driver usb-storage
[  120.280069] USB Mass Storage support registered.
[  120.280259] usb-storage: device found at 2
[  120.280269] usb-storage: waiting for device to settle before scanning
[  125.280174] usb-storage: device scan complete
[  126.017920] scsi 6:0:0:0: Direct-Access     Maxtor   3200             0344 PQ: 0 ANSI: 4
[  126.018387] sd 6:0:0:0: Attached scsi generic sg3 type 0
[  126.041247] sd 6:0:0:0: [sdc] 625142448 512-byte logical blocks: (320 GB/298 GiB)
[  126.042129] sd 6:0:0:0: [sdc] Write Protect is off
[  126.042132] sd 6:0:0:0: [sdc] Mode Sense: 17 00 00 00
[  126.042135] sd 6:0:0:0: [sdc] Assuming drive cache: write through
[  126.043882] sd 6:0:0:0: [sdc] Assuming drive cache: write through
[  126.043887]  sdc: sdc1
[  126.063491] sd 6:0:0:0: [sdc] Assuming drive cache: write through
[  126.063497] sd 6:0:0:0: [sdc] Attached SCSI disk
[ 7104.253777] usb 1-1: USB disconnect, address 2