[   24.849789] ieee80211: 802.11 data/management/control stack, git-1.1.13
[   24.849794] ieee80211: Copyright (C) 2004-2005 Intel Corporation <jketreno@linux.intel.com>
[   24.858049] thinkpad_acpi: ThinkPad ACPI Extras v0.23
[   24.858053] thinkpad_acpi: http://ibm-acpi.sf.net/
[   24.858056] thinkpad_acpi: ThinkPad BIOS 1VET45WW (1.03 ), EC 1VHT25WW-1.01
[   24.858059] thinkpad_acpi: IBM ThinkPad R51, model 2887AVG
[   24.872303] Registered led device: tpacpi::thinklight
[   24.872352] Registered led device: tpacpi::power
[   24.872374] Registered led device: tpacpi::standby
[   24.885404] thinkpad_acpi: brightness: will use unverified default: brightness_mode=2
[   24.885409] thinkpad_acpi: brightness: please report to ibm-acpi-devel@lists.sourceforge.net whether it works well or not on your ThinkPad
[   24.886606] input: ThinkPad Extra Buttons as /devices/virtual/input/input8
[   26.678595] ipw2200: Intel(R) PRO/Wireless 2200/2915 Network Driver, 1.2.2kmprq
[   26.678601] ipw2200: Copyright(c) 2003-2006 Intel Corporation
[   26.679147] ACPI: PCI Interrupt Link [LNKF] enabled at IRQ 11
[   26.679153] ipw2200 0000:02:02.0: PCI INT A -> Link[LNKF] -> GSI 11 (level, low) -> IRQ 11
[   26.679253] ipw2200: Detected Intel PRO/Wireless 2200BG Network Connection
[   26.679308] ipw2200 0000:02:02.0: firmware: requesting ipw2200-bss.fw
[   26.696995] nsc-ircc 00:0b: activated
[   26.697004] nsc_ircc_pnp_probe() : From PnP, found firbase 0x2F8 ; irq 3 ; dma 1.
[   26.697191] nsc-ircc, chip->init
[   26.697200] nsc-ircc, Found chip at base=0x02e
[   26.697223] nsc-ircc, driver loaded (Dag Brattli)
[   27.370065] ipw2200: Detected geography ZZR (14 802.11bg channels, 0 802.11a channels)
[   27.370903] IrDA: Registered device irda0
[   27.370907] nsc-ircc, Using dongle: IBM31T1100 or Temic TFDS6000/TFDS6500
[   28.429247] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x100-0x3af: clean.
[   28.430057] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x3e0-0x4ff: excluding 0x4d0-0x4d7
[   28.430417] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x820-0x8ff: clean.
[   28.430723] pcmcia_socket pcmcia_socket0: cs: IO port probe 0xc00-0xcf7: clean.
[   28.431185] pcmcia_socket pcmcia_socket0: cs: IO port probe 0xa00-0xaff: clean.
[   29.372028] eth0: no IPv6 routers present
[   31.517604] [drm] DAC-6: set mode 640x480 0
[   32.007505] [drm] DAC-6: set mode 640x480 0
[   32.459197] i2c-adapter i2c-1: unable to read EDID block.
[   32.459204] i915 0000:00:02.0: LVDS-1: no EDID data
[   32.529734] [drm] DAC-6: set mode 640x480 0
[   33.020599] [drm] DAC-6: set mode 640x480 0
[   33.482654] i2c-adapter i2c-1: unable to read EDID block.
[   33.482659] i915 0000:00:02.0: LVDS-1: no EDID data
[   37.953923] [drm] DAC-6: set mode 640x480 0
[   38.444482] [drm] DAC-6: set mode 640x480 0
[   38.464019] eth1: no IPv6 routers present
[   38.869478] i2c-adapter i2c-1: unable to read EDID block.
[   38.869483] i915 0000:00:02.0: LVDS-1: no EDID data
[   38.943295] [drm] DAC-6: set mode 640x480 0
[   39.433471] [drm] DAC-6: set mode 640x480 0
[   39.858376] i2c-adapter i2c-1: unable to read EDID block.
[   39.858381] i915 0000:00:02.0: LVDS-1: no EDID data
[   39.944427] [drm] DAC-6: set mode 640x480 0
[   40.435116] [drm] DAC-6: set mode 640x480 0
[   40.860242] i2c-adapter i2c-1: unable to read EDID block.
[   40.860247] i915 0000:00:02.0: LVDS-1: no EDID data
[   68.946546] [drm] DAC-6: set mode 640x480 0
[   69.437972] [drm] DAC-6: set mode 640x480 0
[   69.863284] i2c-adapter i2c-1: unable to read EDID block.
[   69.863290] i915 0000:00:02.0: LVDS-1: no EDID data
[   69.937162] [drm] DAC-6: set mode 640x480 0
[   70.427957] [drm] DAC-6: set mode 640x480 0
[   70.854538] i2c-adapter i2c-1: unable to read EDID block.
[   70.854544] i915 0000:00:02.0: LVDS-1: no EDID data
[   70.928964] [drm] DAC-6: set mode 640x480 0
[   71.419444] [drm] DAC-6: set mode 640x480 0
[   71.846480] i2c-adapter i2c-1: unable to read EDID block.
[   71.846487] i915 0000:00:02.0: LVDS-1: no EDID data
[   73.593179] [drm] DAC-6: set mode 640x480 0
[   74.083698] [drm] DAC-6: set mode 640x480 0
[   74.508200] i2c-adapter i2c-1: unable to read EDID block.
[   74.508205] i915 0000:00:02.0: LVDS-1: no EDID data
[  104.701725] UDF-fs: No VRS found
[  104.701735] UDF-fs: No partition found (1)
[  104.780053] ISO 9660 Extensions: Microsoft Joliet Level 3
[  104.854689] ISO 9660 Extensions: RRIP_1991A
[  159.501893] process `skype' is using obsolete setsockopt SO_BSDCOMPAT