[ 19.134363] nvidia: module license 'NVIDIA' taints kernel. [ 19.134368] Disabling lock debugging due to kernel taint [ 19.389210] nvidia 0000:01:00.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16 [ 19.389221] nvidia 0000:01:00.0: setting latency timer to 64 [ 19.389375] NVRM: loading NVIDIA UNIX x86 Kernel Module 185.18.36 Fri Aug 14 17:18:04 PDT 2009 [ 19.625901] sdhci: Secure Digital Host Controller Interface driver [ 19.625905] sdhci: Copyright(c) Pierre Ossman [ 19.630461] sdhci-pci 0000:0a:06.3: SDHCI controller found [104c:803c] (rev 0) [ 19.630483] sdhci-pci 0000:0a:06.3: PCI INT A -> GSI 22 (level, low) -> IRQ 22 [ 19.630573] Registered led device: mmc0:: [ 19.630615] mmc0: SDHCI controller on PCI [0000:0a:06.3] using PIO [ 19.663090] intel_rng: FWH not detected [ 19.702067] lp: driver loaded but no devices found [ 19.905770] acer-wmi: Acer Laptop ACPI-WMI Extras [ 20.182266] yenta_cardbus 0000:0a:06.0: CardBus bridge found [1025:0107] [ 20.182294] yenta_cardbus 0000:0a:06.0: Using CSCINT to route CSC interrupts to PCI [ 20.182297] yenta_cardbus 0000:0a:06.0: Routing CardBus interrupts to PCI [ 20.182304] yenta_cardbus 0000:0a:06.0: TI: mfunc 0x01aa1b22, devctl 0x64 [ 20.188022] Linux video capture interface: v2.00 [ 20.265091] gspca: main v2.6.0 registered [ 20.272649] gspca: probing 046d:0896 [ 20.273027] vc032x: check sensor header 2c [ 20.337899] vc032x: Sensor ID 3130 (2) [ 20.337903] vc032x: Find Sensor PO3130NC [ 20.340135] gspca: probe ok [ 20.340174] usbcore: registered new interface driver vc032x [ 20.340180] vc032x: registered [ 20.412810] yenta_cardbus 0000:0a:06.0: ISA IRQ mask 0x0cf8, PCI irq 22 [ 20.412815] yenta_cardbus 0000:0a:06.0: Socket status: 30000006 [ 20.412821] pci_bus 0000:0a: Raising subordinate bus# of parent bus (#0a) from #0a to #0e [ 20.412830] yenta_cardbus 0000:0a:06.0: pcmcia: parent PCI bridge I/O window: 0x6000 - 0x6fff [ 20.412834] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x6000-0x6fff: clean. [ 20.413118] yenta_cardbus 0000:0a:06.0: pcmcia: parent PCI bridge Memory window: 0xd2000000 - 0xd20fffff [ 20.413122] yenta_cardbus 0000:0a:06.0: pcmcia: parent PCI bridge Memory window: 0x80000000 - 0x83ffffff [ 20.413773] tifm_7xx1 0000:0a:06.2: PCI INT A -> GSI 22 (level, low) -> IRQ 22 [ 20.512116] cfg80211: Calling CRDA to update world regulatory domain [ 20.621703] cfg80211: World regulatory domain updated: [ 20.621709] (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 20.621715] (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 20.621721] (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) [ 20.621726] (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) [ 20.621730] (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 20.621735] (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 20.748935] Synaptics Touchpad, model: 1, fw: 6.2, id: 0x1280b1, caps: 0xa04713/0x204000 [ 20.778379] input: SynPS/2 Synaptics TouchPad as /devices/platform/i8042/serio4/input/input7 [ 20.860050] usb 5-2: new full speed USB device using uhci_hcd and address 2 [ 21.031221] usb 5-2: configuration #1 chosen from 1 choice [ 21.464961] Bluetooth: Generic Bluetooth USB driver ver 0.5 [ 21.465099] usbcore: registered new interface driver btusb [ 21.539382] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x100-0x3af: clean. [ 21.541498] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x3e0-0x4ff: excluding 0x4d0-0x4d7 [ 21.542364] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x820-0x8ff: clean. [ 21.543080] pcmcia_socket pcmcia_socket0: cs: IO port probe 0xc00-0xcf7: clean. [ 21.544014] pcmcia_socket pcmcia_socket0: cs: IO port probe 0xa00-0xaff: clean. [ 22.728343] iwl3945: Intel(R) PRO/Wireless 3945ABG/BG Network Connection driver for Linux, 1.2.26ks [ 22.728347] iwl3945: Copyright(c) 2003-2009 Intel Corporation [ 22.728494] iwl3945 0000:05:00.0: PCI INT A -> GSI 18 (level, low) -> IRQ 18 [ 22.728509] iwl3945 0000:05:00.0: setting latency timer to 64 [ 22.786272] iwl3945 0000:05:00.0: Tunable channels: 11 802.11bg, 13 802.11a channels [ 22.786276] iwl3945 0000:05:00.0: Detected Intel Wireless WiFi Link 3945ABG [ 22.786396] alloc irq_desc for 286 on node -1 [ 22.786399] alloc kstat_irqs on node -1 [ 22.786433] iwl3945 0000:05:00.0: irq 286 for MSI/MSI-X [ 22.857982] ip_tables: (C) 2000-2006 Netfilter Core Team [ 23.003756] phy0: Selected rate control algorithm 'iwl-3945-rs' [ 23.139894] HDA Intel 0000:00:1b.0: power state changed by ACPI to D0 [ 23.139908] HDA Intel 0000:00:1b.0: PCI INT A -> GSI 22 (level, low) -> IRQ 22 [ 23.139937] HDA Intel 0000:00:1b.0: setting latency timer to 64 [ 23.209603] hda_codec: Unknown model for ALC883, trying auto-probe from BIOS... [ 23.209794] input: HDA Digital PCBeep as /devices/pci0000:00/0000:00:1b.0/input/input8 [ 23.654387] Bluetooth: BNEP (Ethernet Emulation) ver 1.3 [ 23.654391] Bluetooth: BNEP filters: protocol multicast [ 23.683128] Bridge firewalling registered [ 27.919383] r8169: eth0: link down [ 27.919616] ADDRCONF(NETDEV_UP): eth0: link is not ready [ 27.962263] iwl3945 0000:05:00.0: firmware: requesting iwlwifi-3945-2.ucode [ 28.070081] iwl3945 0000:05:00.0: loaded firmware version 15.32.2.9 [ 28.141793] Registered led device: iwl-phy0::radio [ 28.141875] Registered led device: iwl-phy0::assoc [ 28.141915] Registered led device: iwl-phy0::RX [ 28.141948] Registered led device: iwl-phy0::TX [ 28.161080] ADDRCONF(NETDEV_UP): wlan0: link is not ready [ 29.214313] ppdev: user-space parallel port driver [ 36.301032] iwl3945 0000:05:00.0: Error sending REPLY_RXON: time out after 500ms. [ 36.301038] iwl3945 0000:05:00.0: Error setting new configuration (-110). [ 37.965933] wlan0: authenticate with AP 00:19:e3:fb:31:64 [ 37.972995] wlan0: authenticated [ 37.973000] wlan0: associate with AP 00:19:e3:fb:31:64 [ 37.976443] wlan0: RX AssocResp from 00:19:e3:fb:31:64 (capab=0x431 status=0 aid=3) [ 37.976447] wlan0: associated [ 37.978249] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready [ 38.048414] padlock: VIA PadLock not detected. [ 38.062003] cfg80211: Calling CRDA for country: NL [ 38.065843] cfg80211: Received country IE: [ 38.065846] cfg80211: Regulatory domain: NL [ 38.065848] (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 38.065852] (2402000 KHz - 2494000 KHz @ 40000 KHz), (10000 mBi, 10000 mBm) [ 38.065854] cfg80211: CRDA thinks this should applied: [ 38.065856] cfg80211: Regulatory domain: NL [ 38.065858] (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 38.065861] (2402000 KHz - 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm) [ 38.065864] (5170000 KHz - 5250000 KHz @ 40000 KHz), (N/A, 2000 mBm) [ 38.065867] (5250000 KHz - 5330000 KHz @ 40000 KHz), (N/A, 2000 mBm) [ 38.065870] (5490000 KHz - 5710000 KHz @ 40000 KHz), (N/A, 2700 mBm) [ 38.065872] cfg80211: We intersect both of these and get: [ 38.065874] cfg80211: Regulatory domain: 98 [ 38.065876] (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 38.065879] (2402000 KHz - 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm) [ 38.065884] cfg80211: Leaving channel 5180 MHz intact on phy0 - no rule found in band on Country IE [ 38.065887] cfg80211: Leaving channel 5200 MHz intact on phy0 - no rule found in band on Country IE [ 38.065890] cfg80211: Leaving channel 5220 MHz intact on phy0 - no rule found in band on Country IE [ 38.065893] cfg80211: Leaving channel 5240 MHz intact on phy0 - no rule found in band on Country IE [ 38.065896] cfg80211: Leaving channel 5260 MHz intact on phy0 - no rule found in band on Country IE [ 38.065898] cfg80211: Leaving channel 5280 MHz intact on phy0 - no rule found in band on Country IE [ 38.065901] cfg80211: Leaving channel 5300 MHz intact on phy0 - no rule found in band on Country IE [ 38.065904] cfg80211: Leaving channel 5320 MHz intact on phy0 - no rule found in band on Country IE [ 38.065907] cfg80211: Leaving channel 5745 MHz intact on phy0 - no rule found in band on Country IE [ 38.065909] cfg80211: Leaving channel 5765 MHz intact on phy0 - no rule found in band on Country IE [ 38.065912] cfg80211: Leaving channel 5785 MHz intact on phy0 - no rule found in band on Country IE [ 38.065915] cfg80211: Leaving channel 5805 MHz intact on phy0 - no rule found in band on Country IE [ 38.065917] cfg80211: Leaving channel 5825 MHz intact on phy0 - no rule found in band on Country IE [ 38.065921] cfg80211: Current regulatory domain updated by AP to: NL [ 38.065923] (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 38.065926] (2402000 KHz - 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm)