[   40.717376] ADDRCONF(NETDEV_UP): eth0: link is not ready
[   40.720409] e1000: eth0 NIC Link is Up 100 Mbps Full Duplex, Flow Control: RX/TX
[   40.725764] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   40.792342] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   42.151201] agpgart-intel 0000:00:00.0: AGP 2.0 bridge
[   42.151222] agpgart-intel 0000:00:00.0: putting AGP V2 device into 4x mode
[   42.151261] pci 0000:01:00.0: putting AGP V2 device into 4x mode
[   42.483550] [drm] Setting GART location based on new memory map
[   42.483562] [drm] Loading R200 Microcode
[   42.483618] [drm] writeback test succeeded in 2 usecs
[   50.952029] eth0: no IPv6 routers present
[   71.998535] EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended
[  104.132052] Clocksource tsc unstable (delta = -323617236 ns)
[  157.555019] usb 1-1.1: USB disconnect, address 3
[  157.563374] FAT: bread failed in fat_clusters_flush
[  157.596888] FAT: bread failed in fat_clusters_flush
[  157.617230] FAT: bread failed in fat_clusters_flush
[  157.617459] FAT: bread failed in fat_clusters_flush
[  181.053332] usb 1-1.1: new high speed USB device using ehci_hcd and address 6
[  181.146069] usb 1-1.1: configuration #1 chosen from 1 choice
[  181.151237] scsi4 : SCSI emulation for USB Mass Storage devices
[  181.151565] usb-storage: device found at 6
[  181.151572] usb-storage: waiting for device to settle before scanning
[  186.177414] usb-storage: device scan complete
[  186.179763] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[  186.181050] scsi 4:0:0:0: Direct-Access     WD       10EACS External  1.75 PQ: 0 ANSI: 4
[  186.181616] sd 4:0:0:0: Attached scsi generic sg2 type 0
[  186.188461] sd 4:0:0:0: [sdb] 1953525168 512-byte logical blocks: (1.00 TB/931 GiB)
[  186.194766] sd 4:0:0:0: [sdb] Write Protect is off
[  186.194771] sd 4:0:0:0: [sdb] Mode Sense: 23 00 00 00
[  186.194775] sd 4:0:0:0: [sdb] Assuming drive cache: write through
[  186.197774] sd 4:0:0:0: [sdb] Assuming drive cache: write through
[  186.197783]  sdb: sdb1
[  186.207300] sd 4:0:0:0: [sdb] Assuming drive cache: write through
[  186.207308] sd 4:0:0:0: [sdb] Attached SCSI disk
[  187.576203] kjournald starting.  Commit interval 5 seconds
[  187.576235] EXT3-fs warning: maximal mount count reached, running e2fsck is recommended
[  187.581313] EXT3 FS on sdb1, internal journal
[  187.581329] EXT3-fs: mounted filesystem with writeback data mode.
[  277.141292] ath5k phy0: noise floor calibration timeout (2437MHz)
[  388.019942] ath5k phy0: noise floor calibration failed (5180MHz)
[  748.331082] ath5k phy0: noise floor calibration timeout (5180MHz)
[ 1058.743391] mtrr: no MTRR for e0000000,2000000 found
[ 1059.298535] agpgart-intel 0000:00:00.0: AGP 2.0 bridge
[ 1059.298558] agpgart-intel 0000:00:00.0: putting AGP V2 device into 4x mode
[ 1059.298597] pci 0000:01:00.0: putting AGP V2 device into 4x mode
[ 1059.511469] [drm] Setting GART location based on new memory map
[ 1059.511487] [drm] Loading R200 Microcode
[ 1059.511548] [drm] writeback test succeeded in 1 usecs
[ 1110.969735] thinkpad_acpi: deprecated sysfs attribute: access by process with PID 3449
[ 1110.969741] thinkpad_acpi: WARNING: sysfs attribute hotkey_enable is deprecated and will be removed. Hotkey reporting is always enabled
[ 1110.970497] thinkpad_acpi: deprecated sysfs attribute: access by process with PID 3449
[ 1110.970501] thinkpad_acpi: WARNING: sysfs attribute bluetooth_enable is deprecated and will be removed. Please switch to generic rfkill before year 2010
[ 1368.681831] ADDRCONF(NETDEV_UP): wlan0: link is not ready