[   45.502475] agpgart-intel 0000:00:00.0: AGP 2.0 bridge
[   45.502497] agpgart-intel 0000:00:00.0: putting AGP V2 device into 1x mode
[   45.502536] pci 0000:01:00.0: putting AGP V2 device into 1x mode
[   45.729496] [drm] Setting GART location based on new memory map
[   45.729506] [drm] Loading R100 Microcode
[   45.729562] [drm] writeback test succeeded in 2 usecs
[   53.264155] vboxdrv: Trying to deactivate the NMI watchdog permanently...
[   53.264160] vboxdrv: Successfully done.
[   53.264163] vboxdrv: Found 1 processor cores.
[   53.264321] vboxdrv: TSC mode is 'synchronous', kernel timer mode is 'normal'.
[   53.264324] vboxdrv: Successfully loaded version 3.1.0 (interface 0x00100001).
[   59.374035] ADDRCONF(NETDEV_UP): eth2: link is not ready
[   59.376415] e1000: eth2 NIC Link is Up 100 Mbps Full Duplex, Flow Control: RX/TX
[   59.377116] ADDRCONF(NETDEV_CHANGE): eth2: link becomes ready
[   61.563684] ADDRCONF(NETDEV_UP): eth2: link is not ready
[   63.120419] e1000: eth2 NIC Link is Up 100 Mbps Full Duplex, Flow Control: RX/TX
[   63.121177] ADDRCONF(NETDEV_CHANGE): eth2: link becomes ready
[   73.624129] eth2: no IPv6 routers present
[ 1437.866249] ath_pci 0000:02:02.0: found PCI INT A -> IRQ 11
[ 1437.866266] ath_pci 0000:02:02.0: sharing IRQ 11 with 0000:00:1d.2
[ 1437.866276] ath_pci 0000:02:02.0: sharing IRQ 11 with 0000:00:1f.1
[ 1437.866291] ath_pci 0000:02:02.0: sharing IRQ 11 with 0000:02:00.2
[ 1438.169034] MadWifi: ath_attach: Switching rfkill capability off.
[ 1438.173650] wifi0: Atheros AR5213 chip found (MAC 5.6, PHY 2112 4.1, 5 GHz Radio 1.7 2 GHz Radio 2.3)
[ 1438.174682] ath_pci: wifi0: Atheros 5212: mem=0xc0210000, irq=11
[ 1438.210682] udev: renamed network interface ath0 to ath1
[ 1748.380043] ath1: no IPv6 routers present
[ 1796.909727] ADDRCONF(NETDEV_UP): eth2: link is not ready
[ 1798.584422] e1000: eth2 NIC Link is Up 100 Mbps Full Duplex, Flow Control: RX/TX
[ 1798.584821] ADDRCONF(NETDEV_CHANGE): eth2: link becomes ready
[ 1798.812327] ADDRCONF(NETDEV_UP): eth2: link is not ready
[ 1800.476425] e1000: eth2 NIC Link is Up 100 Mbps Full Duplex, Flow Control: RX/TX
[ 1800.476816] ADDRCONF(NETDEV_CHANGE): eth2: link becomes ready
[ 1809.568056] ath1: no IPv6 routers present
[ 1810.680054] eth2: no IPv6 routers present
[ 1895.627324] ADDRCONF(NETDEV_UP): eth2: link is not ready
[ 1897.280412] e1000: eth2 NIC Link is Up 100 Mbps Full Duplex, Flow Control: RX/TX
[ 1897.281176] ADDRCONF(NETDEV_CHANGE): eth2: link becomes ready
[ 1906.008553] ath1: no IPv6 routers present
[ 1908.004039] eth2: no IPv6 routers present
[ 2050.270359] ADDRCONF(NETDEV_UP): eth2: link is not ready
[ 2051.900399] e1000: eth2 NIC Link is Up 100 Mbps Full Duplex, Flow Control: RX/TX
[ 2051.901166] ADDRCONF(NETDEV_CHANGE): eth2: link becomes ready
[ 2061.032044] ath1: no IPv6 routers present
[ 2062.356039] eth2: no IPv6 routers present
[ 2074.955665] ADDRCONF(NETDEV_UP): eth2: link is not ready
[ 2076.564406] e1000: eth2 NIC Link is Up 100 Mbps Full Duplex, Flow Control: RX/TX
[ 2076.565022] ADDRCONF(NETDEV_CHANGE): eth2: link becomes ready
[ 2080.473848] ath1: unknown SIOCSIWAUTH flag 12
[ 2086.040045] ath1: no IPv6 routers present
[ 2086.900117] eth2: no IPv6 routers present
[ 2094.055524] ath1: unknown SIOCSIWAUTH flag 12
[ 2108.201749] ath1: unknown SIOCSIWAUTH flag 12
[ 2121.816614] ath1: unknown SIOCSIWAUTH flag 12
[ 2135.574178] ath1: unknown SIOCSIWAUTH flag 12
[ 2144.231241] ADDRCONF(NETDEV_UP): eth2: link is not ready
[ 2145.784410] e1000: eth2 NIC Link is Up 100 Mbps Full Duplex, Flow Control: RX/TX
[ 2145.785146] ADDRCONF(NETDEV_CHANGE): eth2: link becomes ready
[ 2154.772050] ath1: no IPv6 routers present
[ 2156.596043] eth2: no IPv6 routers present
[ 2162.882583] ADDRCONF(NETDEV_UP): eth2: link is not ready
[ 2164.294893] ath1: unknown SIOCSIWAUTH flag 12
[ 2164.740425] e1000: eth2 NIC Link is Up 100 Mbps Full Duplex, Flow Control: RX/TX
[ 2164.741165] ADDRCONF(NETDEV_CHANGE): eth2: link becomes ready
[ 2173.532041] ath1: no IPv6 routers present
[ 2174.872044] eth2: no IPv6 routers present
[ 2174.910245] ath1: unknown SIOCSIWAUTH flag 12
[ 2188.389141] ath1: unknown SIOCSIWAUTH flag 12
[ 2207.429846] ath1: unknown SIOCSIWAUTH flag 12
[ 2227.870319] ADDRCONF(NETDEV_UP): ath1: link is not ready
[ 2228.134624] ADDRCONF(NETDEV_UP): eth2: link is not ready
[ 2229.700422] e1000: eth2 NIC Link is Up 100 Mbps Full Duplex, Flow Control: RX/TX
[ 2229.705143] ADDRCONF(NETDEV_CHANGE): eth2: link becomes ready
[ 2240.112040] eth2: no IPv6 routers present
[ 2997.470124] ADDRCONF(NETDEV_UP): ath1: link is not ready
[ 3074.407845] ADDRCONF(NETDEV_UP): eth2: link is not ready
[ 3074.560462] ADDRCONF(NETDEV_UP): ath1: link is not ready
[ 3075.898527] ath1: unknown SIOCSIWAUTH flag 12
[ 3076.424411] e1000: eth2 NIC Link is Up 100 Mbps Full Duplex, Flow Control: RX/TX
[ 3076.425193] ADDRCONF(NETDEV_CHANGE): eth2: link becomes ready
[ 3086.256000] ath1: unknown SIOCSIWAUTH flag 12
[ 3086.744118] eth2: no IPv6 routers present
[ 3096.410606] ath1: unknown SIOCSIWAUTH flag 12
[ 3109.778351] ath1: unknown SIOCSIWAUTH flag 12
[ 3123.602146] ath1: unknown SIOCSIWAUTH flag 12
[ 3137.426814] ath1: unknown SIOCSIWAUTH flag 12
[ 3139.505713] ADDRCONF(NETDEV_UP): ath1: link is not ready
[ 3139.766338] ADDRCONF(NETDEV_UP): eth2: link is not ready
[ 3141.300420] e1000: eth2 NIC Link is Up 100 Mbps Full Duplex, Flow Control: RX/TX
[ 3141.301199] ADDRCONF(NETDEV_CHANGE): eth2: link becomes ready
[ 3151.548047] eth2: no IPv6 routers present
[ 3712.711393] ADDRCONF(NETDEV_UP): eth2: link is not ready
[ 3712.814058] ADDRCONF(NETDEV_UP): ath1: link is not ready
[ 3714.304396] e1000: eth2 NIC Link is Up 100 Mbps Full Duplex, Flow Control: RX/TX
[ 3714.305443] ADDRCONF(NETDEV_CHANGE): eth2: link becomes ready
[ 3718.264727] ath1: unknown SIOCSIWAUTH flag 12
[ 3724.972121] eth2: no IPv6 routers present
[ 3731.976543] ath1: unknown SIOCSIWAUTH flag 12
[ 3745.453645] ath1: unknown SIOCSIWAUTH flag 12
[ 3759.096077] ath1: unknown SIOCSIWAUTH flag 12
[ 3773.348687] ath1: unknown SIOCSIWAUTH flag 12
[ 3785.826117] ADDRCONF(NETDEV_UP): ath1: link is not ready
[ 3786.084831] ADDRCONF(NETDEV_UP): eth2: link is not ready
[ 3787.640423] e1000: eth2 NIC Link is Up 100 Mbps Full Duplex, Flow Control: RX/TX
[ 3787.641194] ADDRCONF(NETDEV_CHANGE): eth2: link becomes ready
[ 3797.684042] eth2: no IPv6 routers present
[ 4250.902062] ADDRCONF(NETDEV_UP): eth2: link is not ready
[ 4251.013689] ADDRCONF(NETDEV_UP): ath1: link is not ready
[ 4252.512399] e1000: eth2 NIC Link is Up 100 Mbps Full Duplex, Flow Control: RX/TX
[ 4252.513151] ADDRCONF(NETDEV_CHANGE): eth2: link becomes ready
[ 4256.663548] ath1: unknown SIOCSIWAUTH flag 12
[ 4262.632125] eth2: no IPv6 routers present
[ 4276.882572] ADDRCONF(NETDEV_UP): ath1: link is not ready
[ 4281.451420] ADDRCONF(NETDEV_UP): eth2: link is not ready
[ 4281.615668] ADDRCONF(NETDEV_UP): ath1: link is not ready
[ 4283.064417] e1000: eth2 NIC Link is Up 100 Mbps Full Duplex, Flow Control: RX/TX
[ 4283.069057] ADDRCONF(NETDEV_CHANGE): eth2: link becomes ready
[ 4293.636037] eth2: no IPv6 routers present
[ 4314.351768] ADDRCONF(NETDEV_UP): ath1: link is not ready
[ 4314.554515] ADDRCONF(NETDEV_UP): eth2: link is not ready
[ 4316.068404] e1000: eth2 NIC Link is Up 100 Mbps Full Duplex, Flow Control: RX/TX
[ 4316.069043] ADDRCONF(NETDEV_CHANGE): eth2: link becomes ready
[ 4326.760044] eth2: no IPv6 routers present