[ 25.865665] ADDRCONF(NETDEV_UP): eth0: link is not ready [ 32.907876] [drm] Setting GART location based on new memory map [ 32.909889] [drm] Loading R500 Microcode [ 32.909943] [drm] Num pipes: 1 [ 32.909957] [drm] writeback test succeeded in 1 usecs [ 36.745915] vboxdrv: Trying to deactivate the NMI watchdog permanently... [ 36.745918] vboxdrv: Warning: 2.6.31+ kernel detected. Most likely the hwardware performance [ 36.745919] vboxdrv: counter framework which can generate NMIs is active. You have to prevent [ 36.745921] vboxdrv: the usage of hardware performance counters by [ 36.745922] vboxdrv: echo 2 > /proc/sys/kernel/perf_counter_paranoid [ 36.745926] vboxdrv: Found 2 processor cores. [ 36.746001] vboxdrv: fAsync=1 offMin=0xfc5ae388 offMax=0xfc5ae388 [ 36.746049] vboxdrv: TSC mode is 'asynchronous', kernel timer mode is 'normal'. [ 36.746051] vboxdrv: Successfully loaded version 3.0.8 (interface 0x000e0000). [ 40.505865] ppdev: user-space parallel port driver [ 123.818047] iwl3945 0000:0b:00.0: firmware: requesting iwlwifi-3945-2.ucode [ 124.249064] iwl3945 0000:0b:00.0: loaded firmware version 15.32.2.9 [ 124.330141] Registered led device: iwl-phy0::radio [ 124.330162] Registered led device: iwl-phy0::assoc [ 124.330217] Registered led device: iwl-phy0::RX [ 124.330234] Registered led device: iwl-phy0::TX [ 124.374127] ADDRCONF(NETDEV_UP): wlan0: link is not ready [ 134.425650] wlan0: authenticate with AP 00:1d:70:98:93:d1 [ 134.428381] wlan0: authenticated [ 134.428387] wlan0: associate with AP 00:1d:70:98:93:d1 [ 134.432957] wlan0: RX AssocResp from 00:1d:70:98:93:d1 (capab=0x421 status=0 aid=12) [ 134.432964] wlan0: associated [ 134.441297] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready [ 134.493046] cfg80211: Calling CRDA for country: DE [ 134.496984] cfg80211: Received country IE: [ 134.496990] cfg80211: Regulatory domain: DE [ 134.496993] (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 134.496999] (2402000 KHz - 2494000 KHz @ 40000 KHz), (10000 mBi, 10000 mBm) [ 134.497007] cfg80211: CRDA thinks this should applied: [ 134.497011] cfg80211: Regulatory domain: DE [ 134.497014] (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 134.497019] (2400000 KHz - 2483500 KHz @ 40000 KHz), (N/A, 2000 mBm) [ 134.497024] (5150000 KHz - 5350000 KHz @ 40000 KHz), (N/A, 2000 mBm) [ 134.497029] (5470000 KHz - 5725000 KHz @ 40000 KHz), (N/A, 2698 mBm) [ 134.497032] cfg80211: We intersect both of these and get: [ 134.497036] cfg80211: Regulatory domain: 98 [ 134.497039] (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 134.497045] (2402000 KHz - 2483500 KHz @ 40000 KHz), (N/A, 2000 mBm) [ 134.497054] cfg80211: Leaving channel 5170 MHz intact on phy0 - no rule found in band on Country IE [ 134.497059] cfg80211: Leaving channel 5180 MHz intact on phy0 - no rule found in band on Country IE [ 134.497063] cfg80211: Leaving channel 5190 MHz intact on phy0 - no rule found in band on Country IE [ 134.497068] cfg80211: Leaving channel 5200 MHz intact on phy0 - no rule found in band on Country IE [ 134.497073] cfg80211: Leaving channel 5210 MHz intact on phy0 - no rule found in band on Country IE [ 134.497078] cfg80211: Leaving channel 5220 MHz intact on phy0 - no rule found in band on Country IE [ 134.497083] cfg80211: Leaving channel 5230 MHz intact on phy0 - no rule found in band on Country IE [ 134.497087] cfg80211: Leaving channel 5240 MHz intact on phy0 - no rule found in band on Country IE [ 134.497092] cfg80211: Leaving channel 5260 MHz intact on phy0 - no rule found in band on Country IE [ 134.497097] cfg80211: Leaving channel 5280 MHz intact on phy0 - no rule found in band on Country IE [ 134.497102] cfg80211: Leaving channel 5300 MHz intact on phy0 - no rule found in band on Country IE [ 134.497107] cfg80211: Leaving channel 5320 MHz intact on phy0 - no rule found in band on Country IE [ 134.497112] cfg80211: Leaving channel 5500 MHz intact on phy0 - no rule found in band on Country IE [ 134.497117] cfg80211: Leaving channel 5520 MHz intact on phy0 - no rule found in band on Country IE [ 134.497121] cfg80211: Leaving channel 5540 MHz intact on phy0 - no rule found in band on Country IE [ 134.497126] cfg80211: Leaving channel 5560 MHz intact on phy0 - no rule found in band on Country IE [ 134.497131] cfg80211: Leaving channel 5580 MHz intact on phy0 - no rule found in band on Country IE [ 134.497136] cfg80211: Leaving channel 5600 MHz intact on phy0 - no rule found in band on Country IE [ 134.497141] cfg80211: Leaving channel 5620 MHz intact on phy0 - no rule found in band on Country IE [ 134.497146] cfg80211: Leaving channel 5640 MHz intact on phy0 - no rule found in band on Country IE [ 134.497150] cfg80211: Leaving channel 5660 MHz intact on phy0 - no rule found in band on Country IE [ 134.497155] cfg80211: Leaving channel 5680 MHz intact on phy0 - no rule found in band on Country IE [ 134.497160] cfg80211: Leaving channel 5700 MHz intact on phy0 - no rule found in band on Country IE [ 134.497166] cfg80211: Current regulatory domain updated by AP to: DE [ 134.497170] (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 134.497175] (2402000 KHz - 2483500 KHz @ 40000 KHz), (N/A, 2000 mBm) [ 145.092035] wlan0: no IPv6 routers present [ 150.940053] iwl3945 0000:0b:00.0: Failed to get channel info for channel 1 [1] [ 153.299145] wlan0: authenticate with AP 00:1d:70:98:93:de [ 153.300031] wlan0: authenticated [ 153.300036] wlan0: associate with AP 00:1d:70:98:93:de [ 153.302124] wlan0: RX ReassocResp from 00:1d:70:98:93:de (capab=0x1 status=0 aid=4) [ 153.302129] wlan0: associated [ 213.282784] tun: Universal TUN/TAP device driver, 1.6 [ 213.282790] tun: (C) 1999-2004 Max Krasnyansky [ 217.176475] tun0: Disabled Privacy Extensions [ 370.304054] wlan0: no probe response from AP 00:1d:70:98:93:de - disassociating [ 372.895605] iwl3945 0000:0b:00.0: Failed to get channel info for channel 100 [0] [ 375.559957] wlan0: authenticate with AP 00:1d:70:98:93:d1 [ 375.562079] wlan0: authenticated [ 375.562083] wlan0: associate with AP 00:1d:70:98:93:d1 [ 375.565591] wlan0: RX ReassocResp from 00:1d:70:98:93:d1 (capab=0x421 status=0 aid=13) [ 375.565595] wlan0: associated [ 430.960068] iwl3945 0000:0b:00.0: Failed to get channel info for channel 6 [1] [ 433.320644] wlan0: authenticate with AP 00:1d:70:98:93:de [ 433.321845] wlan0: authenticated [ 433.321850] wlan0: associate with AP 00:1d:70:98:93:de [ 433.324003] wlan0: RX ReassocResp from 00:1d:70:98:93:de (capab=0x1 status=0 aid=1) [ 433.324038] wlan0: associated [ 468.516892] CE: hpet increasing min_delta_ns to 15000 nsec [ 569.966503] CE: hpet increasing min_delta_ns to 22500 nsec [ 1151.141248] iwl3945 0000:0b:00.0: Failed to get channel info for channel 132 [0] [ 1153.510324] wlan0: authenticate with AP 00:1d:70:98:93:d1 [ 1153.515928] wlan0: authenticated [ 1153.515934] wlan0: associate with AP 00:1d:70:98:93:d1 [ 1153.527000] wlan0: RX ReassocResp from 00:1d:70:98:93:d1 (capab=0x421 status=0 aid=9) [ 1153.527006] wlan0: associated [ 1391.100092] iwl3945 0000:0b:00.0: Failed to get channel info for channel 1 [1] [ 1393.516271] wlan0: authenticate with AP 00:1d:70:98:93:de [ 1393.517109] wlan0: authenticated [ 1393.517112] wlan0: associate with AP 00:1d:70:98:93:de [ 1393.521592] wlan0: RX ReassocResp from 00:1d:70:98:93:de (capab=0x1 status=0 aid=8) [ 1393.521595] wlan0: associated [ 2349.309010] hda-intel: azx_get_response timeout, switching to polling mode: last cmd=0x00df0700 [ 2471.092155] iwl3945 0000:0b:00.0: Failed to get channel info for channel 132 [0] [ 2473.462164] wlan0: authenticate with AP 00:1d:70:98:93:d1 [ 2473.466286] wlan0: authenticated [ 2473.466291] wlan0: associate with AP 00:1d:70:98:93:d1 [ 2473.472685] wlan0: RX ReassocResp from 00:1d:70:98:93:d1 (capab=0x421 status=0 aid=13) [ 2473.472691] wlan0: associated