[   12.776834] cfg80211: World regulatory domain updated:
[   12.776845] 	(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[   12.776853] 	(2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   12.776861] 	(2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[   12.776869] 	(2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[   12.776876] 	(5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   12.776884] 	(5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   13.156889] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
[   13.156894] Bluetooth: BNEP filters: protocol multicast
[   13.417383] Bridge firewalling registered
[   16.529275] ADDRCONF(NETDEV_UP): eth0: link is not ready
[   16.861575] iwl3945 0000:05:00.0: firmware: requesting iwlwifi-3945-2.ucode
[   16.918649] iwl3945 0000:05:00.0: loaded firmware version 15.32.2.9
[   16.990983] Registered led device: iwl-phy0::radio
[   16.991033] Registered led device: iwl-phy0::assoc
[   16.991075] Registered led device: iwl-phy0::RX
[   16.991160] Registered led device: iwl-phy0::TX
[   17.009310] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   21.580789] [drm] Setting GART location based on new memory map
[   21.582942] [drm] Loading R500 Microcode
[   21.583008] [drm] Num pipes: 1
[   21.583020] [drm] writeback test succeeded in 1 usecs
[  111.889055] CE: hpet increasing min_delta_ns to 15000 nsec
[  186.552066] usb 3-1: new full speed USB device using uhci_hcd and address 2
[  186.737274] usb 3-1: configuration #1 chosen from 1 choice
[  186.756465] input: Logitech USB Receiver as /devices/pci0000:00/0000:00:1d.1/usb3/3-1/3-1:1.0/input/input10
[  186.756679] generic-usb 0003:046D:C51A.0002: input,hidraw1: USB HID v1.11 Mouse [Logitech USB Receiver] on usb-0000:00:1d.1-1/input0
[  186.769427] input: Logitech USB Receiver as /devices/pci0000:00/0000:00:1d.1/usb3/3-1/3-1:1.1/input/input11
[  186.769671] generic-usb 0003:046D:C51A.0003: input,hiddev97,hidraw2: USB HID v1.11 Device [Logitech USB Receiver] on usb-0000:00:1d.1-1/input1
[  195.352410] wlan0: authenticate with AP 00:1a:4f:93:dc:ac
[  195.354378] wlan0: authenticated
[  195.354387] wlan0: associate with AP 00:1a:4f:93:dc:ac
[  195.358170] wlan0: RX AssocResp from 00:1a:4f:93:dc:ac (capab=0x411 status=0 aid=1)
[  195.358180] wlan0: associated
[  195.365458] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[  205.368254] wlan0: disassociating by local choice (reason=3)
[  205.376032] wlan0: deauthenticated (Reason: 6)
[  206.168038] wlan0: no IPv6 routers present
[  210.738855] wlan0: authenticate with AP 00:1a:4f:93:dc:ac
[  210.740580] wlan0: authenticated
[  210.740587] wlan0: associate with AP 00:1a:4f:93:dc:ac
[  210.744147] wlan0: RX AssocResp from 00:1a:4f:93:dc:ac (capab=0x411 status=0 aid=1)
[  210.744180] wlan0: associated
[  428.892067] usb 1-6: new high speed USB device using ehci_hcd and address 6
[  429.042124] usb 1-6: configuration #1 chosen from 1 choice
[  429.101435] Initializing USB Mass Storage driver...
[  429.102206] scsi6 : SCSI emulation for USB Mass Storage devices
[  429.102468] usbcore: registered new interface driver usb-storage
[  429.102478] USB Mass Storage support registered.
[  429.102956] usb-storage: device found at 6
[  429.102962] usb-storage: waiting for device to settle before scanning
[  434.102989] usb-storage: device scan complete
[  434.105604] scsi 6:0:0:0: Direct-Access     HTC      Android Phone    0100 PQ: 0 ANSI: 2
[  434.106569] sd 6:0:0:0: Attached scsi generic sg2 type 0
[  434.123442] sd 6:0:0:0: [sdb] Attached SCSI removable disk
[  873.908081] CE: hpet increasing min_delta_ns to 22500 nsec
[ 1363.921620] CE: hpet increasing min_delta_ns to 33750 nsec
[ 1797.564291] gvfsd-archive[19383]: segfault at 0 ip 00c6f54d sp b75e4150 error 6 in libarchive.so.2.6.2[c69000+30000]
[ 3510.001171] gvfsd-archive[2578]: segfault at 0 ip 00d1c54d sp b77a2150 error 6 in libarchive.so.2.6.2[d16000+30000]
[ 4186.896557] usb 1-6: USB disconnect, address 6
[ 4400.324072] wlan0: no probe response from AP 00:1a:4f:93:dc:ac - disassociating
[ 6427.280655] wlan0: authenticate with AP 00:1a:4f:93:dc:ac
[ 6427.283026] wlan0: authenticated
[ 6427.283034] wlan0: associate with AP 00:1a:4f:93:dc:ac
[ 6427.287589] wlan0: RX ReassocResp from 00:1a:4f:93:dc:ac (capab=0x411 status=0 aid=1)
[ 6427.287597] wlan0: associated