[   18.464581] ricoh-mmc: Ricoh MMC Controller disabling driver
[   18.464585] ricoh-mmc: Copyright(c) Philip Langdale
[   18.464625] ricoh-mmc: Ricoh MMC controller found at 0000:05:06.2 [1180:0843] (rev 1)
[   18.464643] ricoh-mmc: Controller is now disabled.
[   19.380610] intel_rng: FWH not detected
[   19.385114] Bluetooth: Generic Bluetooth USB driver ver 0.5
[   19.385240] usbcore: registered new interface driver btusb
[   19.559306] lp: driver loaded but no devices found
[   19.670391] sdhci: Secure Digital Host Controller Interface driver
[   19.670395] sdhci: Copyright(c) Pierre Ossman
[   19.673971] yenta_cardbus 0000:05:04.0: CardBus bridge found [17aa:2075]
[   19.673998] yenta_cardbus 0000:05:04.0: Using CSCINT to route CSC interrupts to PCI
[   19.674001] yenta_cardbus 0000:05:04.0: Routing CardBus interrupts to PCI
[   19.674008] yenta_cardbus 0000:05:04.0: TI: mfunc 0x01111c12, devctl 0x44
[   19.704612] Linux video capture interface: v2.00
[   19.904812] yenta_cardbus 0000:05:04.0: ISA IRQ mask 0x0cf8, PCI irq 16
[   19.904818] yenta_cardbus 0000:05:04.0: Socket status: 30000006
[   19.904822] pci_bus 0000:05: Raising subordinate bus# of parent bus (#05) from #05 to #09
[   19.904831] yenta_cardbus 0000:05:04.0: pcmcia: parent PCI bridge I/O window: 0x2000 - 0x2fff
[   19.904835] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x2000-0x2fff: clean.
[   19.905071] yenta_cardbus 0000:05:04.0: pcmcia: parent PCI bridge Memory window: 0xd0100000 - 0xd01fffff
[   19.905075] yenta_cardbus 0000:05:04.0: pcmcia: parent PCI bridge Memory window: 0x40000000 - 0x43ffffff
[   19.905637] sdhci-pci 0000:05:06.1: SDHCI controller found [1180:0822] (rev 19)
[   19.905651] sdhci-pci 0000:05:06.1: enabling device (0000 -> 0002)
[   19.905660] sdhci-pci 0000:05:06.1: PCI INT B -> GSI 23 (level, low) -> IRQ 23
[   19.907726] Registered led device: mmc0::
[   19.908799] mmc0: SDHCI controller on PCI [0000:05:06.1] using PIO
[   19.926565] gspca: main v2.6.0 registered
[   19.955178] iwl3945: Intel(R) PRO/Wireless 3945ABG/BG Network Connection driver for Linux, 1.2.26ks
[   19.955181] iwl3945: Copyright(c) 2003-2009 Intel Corporation
[   19.955302] iwl3945 0000:03:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
[   19.955317] iwl3945 0000:03:00.0: setting latency timer to 64
[   20.030023] gspca: probing 0c45:624f
[   20.030303] iwl3945 0000:03:00.0: Tunable channels: 13 802.11bg, 23 802.11a channels
[   20.030306] iwl3945 0000:03:00.0: Detected Intel Wireless WiFi Link 3945ABG
[   20.030422]   alloc irq_desc for 26 on node -1
[   20.030425]   alloc kstat_irqs on node -1
[   20.030459] iwl3945 0000:03:00.0: irq 26 for MSI/MSI-X
[   20.098165] sn9c20x: OV9650 sensor detected
[   20.098282] gspca: probe ok
[   20.098332] usbcore: registered new interface driver sn9c20x
[   20.098339] sn9c20x: registered
[   20.213507] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x100-0x3af: clean.
[   20.215480] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x3e0-0x4ff: excluding 0x4d0-0x4d7
[   20.216334] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x820-0x8ff: clean.
[   20.217023] pcmcia_socket pcmcia_socket0: cs: IO port probe 0xc00-0xcf7: clean.
[   20.217886] pcmcia_socket pcmcia_socket0: cs: IO port probe 0xa00-0xaff: clean.
[   20.869666] Synaptics Touchpad, model: 1, fw: 6.2, id: 0x1a0b1, caps: 0xa04753/0x200000
[   20.938400] input: SynPS/2 Synaptics TouchPad as /devices/platform/i8042/serio4/input/input8
[   21.195063] phy0: Selected rate control algorithm 'iwl-3945-rs'
[   21.865161] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
[   21.865165] Bluetooth: BNEP filters: protocol multicast
[   21.925171] Bridge firewalling registered
[   22.760150] iwl3945 0000:03:00.0: firmware: requesting iwlwifi-3945-2.ucode
[   23.242432] iwl3945 0000:03:00.0: loaded firmware version 15.32.2.9
[   23.313641] Registered led device: iwl-phy0::radio
[   23.313720] Registered led device: iwl-phy0::assoc
[   23.313755] Registered led device: iwl-phy0::RX
[   23.313788] Registered led device: iwl-phy0::TX
[   23.333121] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   23.334601] eth0: link down
[   23.334831] ADDRCONF(NETDEV_UP): eth0: link is not ready
[   28.875036] [drm] TV-14: set mode NTSC 480i 0
[   29.015260] [drm] TV-14: set mode NTSC 480i 0
[   29.608799] [drm] TV-14: set mode NTSC 480i 0
[   29.748910] [drm] TV-14: set mode NTSC 480i 0
[   33.175114] vboxdrv: Trying to deactivate the NMI watchdog permanently...
[   33.175118] vboxdrv: Successfully done.
[   33.175120] vboxdrv: Found 2 processor cores.
[   33.175229] vboxdrv: fAsync=0 offMin=0x3cc offMax=0x2280
[   33.175273] vboxdrv: TSC mode is 'synchronous', kernel timer mode is 'normal'.
[   33.175275] vboxdrv: Successfully loaded version 3.0.8_OSE (interface 0x000e0000).
[   34.605460] ppdev: user-space parallel port driver
[   41.136355] [drm] TV-14: set mode NTSC 480i 0
[   41.277009] [drm] TV-14: set mode NTSC 480i 0
[   41.564297] [drm] TV-14: set mode NTSC 480i 0
[   41.704657] [drm] TV-14: set mode NTSC 480i 0
[   41.980035] [drm] TV-14: set mode NTSC 480i 0
[   42.120180] [drm] TV-14: set mode NTSC 480i 0
[   44.867697] [drm] TV-14: set mode NTSC 480i 0
[   45.008129] [drm] TV-14: set mode NTSC 480i 0
[   69.037138] ACPI: EC: GPE storm detected, transactions will use polling mode
[  606.972811] wlan0: authenticate with AP 00:23:f8:0b:75:89
[  606.980409] wlan0: authenticated
[  606.980416] wlan0: associate with AP 00:23:f8:0b:75:89
[  606.983439] wlan0: RX AssocResp from 00:23:f8:0b:75:89 (capab=0x471 status=0 aid=1)
[  606.983446] wlan0: associated
[  606.996359] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[  617.928019] wlan0: no IPv6 routers present
[  634.290448] hda_codec: invalid CONNECT_LIST verb 12[2]:2100