EDAC amd64: WARNING: ECC is NOT currently enabled by the BIOS. Module will NOT be loaded.
    Either Enable ECC in the BIOS, or use the 'ecc_enable_override' parameter.
    Might be a BIOS bug, if BIOS says ECC is enabled
    Use of the override can cause unknown side effects.
amd64_edac: probe of 0000:00:18.2 failed with error -22
  alloc irq_desc for 20 on node 0
  alloc kstat_irqs on node 0
rt61pci 0000:03:06.0: PCI INT A -> GSI 20 (level, low) -> IRQ 20
phy0: Selected rate control algorithm 'minstrel'
Registered led device: rt61pci-phy0::radio
Registered led device: rt61pci-phy0::assoc
HDA Intel 0000:00:14.2: PCI INT A -> GSI 16 (level, low) -> IRQ 16
hda_codec: Unknown model for ALC889A, trying auto-probe from BIOS...
input: HDA Digital PCBeep as /devices/pci0000:00/0000:00:14.2/input/input5
HDA Intel 0000:01:05.1: PCI INT B -> GSI 19 (level, low) -> IRQ 19
HDA Intel 0000:01:05.1: setting latency timer to 64
usplash:423 freeing invalid memtype ffffffffd0000000-ffffffffd1000000
r8169: eth0: link up
r8169: eth0: link up
rt61pci 0000:03:06.0: firmware: requesting rt2561s.bin
input: rt61pci as /devices/pci0000:00/0000:00:14.4/0000:03:06.0/input/input6
ADDRCONF(NETDEV_UP): wlan0: link is not ready
ADDRCONF(NETDEV_UP): wlan0: link is not ready
[fglrx] GART Table is not in FRAME_BUFFER range 
  alloc irq_desc for 27 on node 0
  alloc kstat_irqs on node 0
fglrx_pci 0000:01:05.0: irq 27 for MSI/MSI-X
[fglrx] Firegl kernel thread PID: 1652
vboxdrv: Trying to deactivate the NMI watchdog permanently...
vboxdrv: Successfully done.
vboxdrv: Found 2 processor cores.
VBoxDrv: dbg - g_abExecMemory=ffffffffa04b7420
vboxdrv: fAsync=0 offMin=0x47d offMax=0xa1a
vboxdrv: TSC mode is 'synchronous', kernel timer mode is 'normal'.
vboxdrv: Successfully loaded version 3.0.8 (interface 0x000e0000).
[fglrx] Gart USWC size:1079 M.
[fglrx] Gart cacheable size:428 M.
[fglrx] Reserved FB block: Shared offset:0, size:1000000 
[fglrx] Reserved FB block: Unshared offset:27ffc000, size:4000 
eth0: no IPv6 routers present
VBoxNetFlt: dbg - g_abExecMemory=ffffffffa06561c0
VBoxNetAdp: dbg - g_abExecMemory=ffffffffa066fac0
usb 1-4: usbfs: interface 1 claimed by usblp while 'usb' sets config #1
CPU0 attaching NULL sched-domain.
CPU1 attaching NULL sched-domain.
CPU0 attaching sched-domain:
 domain 0: span 0-1 level MC
  groups: 0 1
  domain 1: span 0-1 level CPU
   groups: 0-1 (__cpu_power = 2048)
CPU1 attaching sched-domain:
 domain 0: span 0-1 level MC
  groups: 1 0
  domain 1: span 0-1 level CPU
   groups: 0-1 (__cpu_power = 2048)
CPU0 attaching NULL sched-domain.
CPU1 attaching NULL sched-domain.
CPU0 attaching sched-domain:
 domain 0: span 0-1 level MC
  groups: 0 1
CPU1 attaching sched-domain:
 domain 0: span 0-1 level MC
  groups: 1 0
hda-intel: IRQ timing workaround is activated for card #1. Suggest a bigger bdl_pos_adj.
hda-intel: Too big adjustment 32
hda-intel: Too big adjustment 32