Error: command ['sh', '-c', 'dmesg | comm -13 /var/log/dmesg -'] failed with exit code 1: [   25.264672] sky2 eth0: enabling interface
[   25.264915] ADDRCONF(NETDEV_UP): eth0: link is not ready
[   25.531523] iwl3945 0000:03:00.0: firmware: requesting iwlwifi-3945-2.ucode
[   25.701369] iwl3945 0000:03:00.0: loaded firmware version 15.32.2.9
[   25.778251] Registered led device: iwl-phy0::radio
[   25.778317] Registered led device: iwl-phy0::assoc
[   25.778341] Registered led device: iwl-phy0::RX
[   25.778364] Registered led device: iwl-phy0::TX
[   25.796996] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   28.004073] CE: hpet increasing min_delta_ns to 15000 nsec
[   29.264461] cfg80211: Found new beacon on frequency: 5240 MHz (Ch 48) on phy0
[   29.450516] [drm] TV-14: set mode NTSC 480i 0
[   29.590962] [drm] TV-14: set mode NTSC 480i 0
[   29.879643] [drm] TV-14: set mode NTSC 480i 0
[   30.019755] [drm] TV-14: set mode NTSC 480i 0
[   35.419739] [drm] TV-14: set mode NTSC 480i 0
[   35.560263] [drm] TV-14: set mode NTSC 480i 0
[   35.839836] [drm] TV-14: set mode NTSC 480i 0
[   35.980070] [drm] TV-14: set mode NTSC 480i 0
[   36.263609] [drm] TV-14: set mode NTSC 480i 0
[   36.403764] [drm] TV-14: set mode NTSC 480i 0
comm: file 2 is not in sorted order
[  182.750351] [drm] TV-14: set mode NTSC 480i 0
[  182.890416] [drm] TV-14: set mode NTSC 480i 0
[  183.171387] [drm] TV-14: set mode NTSC 480i 0
[  183.312275] [drm] TV-14: set mode NTSC 480i 0
[  183.595234] [drm] TV-14: set mode NTSC 480i 0
[  183.735294] [drm] TV-14: set mode NTSC 480i 0
[  192.397424] wlan0: authenticate with AP 00:14:bf:e5:32:37
[  192.399337] wlan0: authenticated
[  192.399343] wlan0: associate with AP 00:14:bf:e5:32:37
[  192.401736] wlan0: RX AssocResp from 00:14:bf:e5:32:37 (capab=0x411 status=0 aid=1)
[  192.401743] wlan0: associated
[  192.403782] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[  203.068090] wlan0: no IPv6 routers present