Error: command ['sh', '-c', 'dmesg | comm -13 /var/log/dmesg -'] failed with exit code 1: [   20.781186] IBM TrackPoint firmware: 0x0b, buttons: 2/3
[   21.061295] input: TPPS/2 IBM TrackPoint as /devices/platform/i8042/serio1/serio2/input/input7
comm: file 2 is not in sorted order
[  100.696184] pcmcia_socket pcmcia_socket0: pccard: CardBus card inserted into slot 0
[  100.696248] pci 0000:03:00.0: reg 10 32bit mmio: [0xffff8000-0xffffffff]
[  100.748165] cfg80211: Calling CRDA to update world regulatory domain
[  100.831588] cfg80211: World regulatory domain updated:
[  100.831599] 	(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[  100.831609] 	(2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[  100.831618] 	(2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[  100.831628] 	(2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[  100.831637] 	(5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[  100.831646] 	(5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[  100.904803] rt61pci 0000:03:00.0: enabling device (0000 -> 0002)
[  100.904831] rt61pci 0000:03:00.0: PCI INT A -> Link[LNKD] -> GSI 11 (level, low) -> IRQ 11
[  100.904847] rt61pci 0000:03:00.0: setting latency timer to 64
[  100.938357] phy0: Selected rate control algorithm 'minstrel'
[  100.940728] Registered led device: rt61pci-phy0::radio
[  100.940784] Registered led device: rt61pci-phy0::assoc
[  101.059478] rt61pci 0000:03:00.0: firmware: requesting rt2561s.bin
[  101.128818] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[  109.097042] wlan0: authenticate with AP 00:1a:70:a2:3d:04
[  109.099713] wlan0: authenticated
[  109.099726] wlan0: associate with AP 00:1a:70:a2:3d:04
[  109.105391] wlan0: RX AssocResp from 00:1a:70:a2:3d:04 (capab=0x471 status=0 aid=2)
[  109.105404] wlan0: associated
[  109.107629] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[  119.236039] wlan0: no IPv6 routers present
[  146.984461] codec_semaphore: semaphore is not ready [0x1][0x300b00]
[  146.984502] codec_read 0: semaphore is not ready for register 0x56