[   23.596457] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   23.617696] e100 0000:02:08.0: firmware: requesting e100/d102e_ucode.bin
[   23.796501] ADDRCONF(NETDEV_UP): eth1: link is not ready
[   25.425505] agpgart-amdk7 0000:00:00.0: AGP 2.0 bridge
[   25.425524] agpgart-amdk7 0000:00:00.0: putting AGP V2 device into 4x mode
[   25.425552] nvidia 0000:01:05.0: putting AGP V2 device into 4x mode
[   25.816278] e100: eth1 NIC Link is Up 100 Mbps Full Duplex
[   25.819035] ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready
[   26.260235] cfg80211: Found new beacon on frequency: 2472 MHz (Ch 13) on phy0
[   36.100038] eth1: no IPv6 routers present
[   72.388819] vboxdrv: Trying to deactivate the NMI watchdog permanently...
[   72.388828] vboxdrv: Warning: 2.6.31+ kernel detected. Most likely the hwardware performance
[   72.388830] vboxdrv: counter framework which can generate NMIs is active. You have to prevent
[   72.388832] vboxdrv: the usage of hardware performance counters by
[   72.388834] vboxdrv:   echo 2 > /proc/sys/kernel/perf_counter_paranoid
[   72.388840] vboxdrv: Found 2 processor cores.
[   72.390290] vboxdrv: fAsync=0 offMin=0x9d7 offMax=0x7050
[   72.393866] vboxdrv: TSC mode is 'synchronous', kernel timer mode is 'normal'.
[   72.393875] vboxdrv: Successfully loaded version 3.0.6 (interface 0x000e0000).
[   73.662013] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
[   73.662020] Bluetooth: BNEP filters: protocol multicast
[   73.972773] Bridge firewalling registered