Error: command ['sh', '-c', 'dmesg | comm -13 /var/log/dmesg -'] failed with exit code 1: [   28.253474] i2c-adapter i2c-1: unable to read EDID block.
[   28.309136] i915 0000:00:02.0: LVDS-1: no EDID data
[   28.493539] [drm] DAC-6: set mode 1024x768 27
[   29.091301] [drm] LVDS-8: set mode 1024x768 28
[   31.252845] sky2 eth0: enabling interface
[   31.253045] ADDRCONF(NETDEV_UP): eth0: link is not ready
[   31.253608] iwlagn 0000:0c:00.0: firmware: requesting iwlwifi-4965-2.ucode
[   31.327473] iwlagn 0000:0c:00.0: loaded firmware version 228.57.2.23
[   31.530022] Registered led device: iwl-phy0::radio
[   31.530041] Registered led device: iwl-phy0::assoc
[   31.530055] Registered led device: iwl-phy0::RX
[   31.530068] Registered led device: iwl-phy0::TX
[   31.585345] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   32.084479] i2c-adapter i2c-1: unable to read EDID block.
[   32.136161] i915 0000:00:02.0: LVDS-1: no EDID data
[   32.921009] sky2 eth0: Link is up at 100 Mbps, full duplex, flow control rx
[   32.921263] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   43.640057] eth0: no IPv6 routers present
[   44.440483] i2c-adapter i2c-1: unable to read EDID block.
[   44.492162] i915 0000:00:02.0: LVDS-1: no EDID data
[   44.876532] i2c-adapter i2c-1: unable to read EDID block.
[   44.928166] i915 0000:00:02.0: LVDS-1: no EDID data
[   45.344469] i2c-adapter i2c-1: unable to read EDID block.
[   45.396154] i915 0000:00:02.0: LVDS-1: no EDID data
[   60.012484] i2c-adapter i2c-1: unable to read EDID block.
[   60.064167] i915 0000:00:02.0: LVDS-1: no EDID data
[   70.512483] i2c-adapter i2c-1: unable to read EDID block.
[   70.564152] i915 0000:00:02.0: LVDS-1: no EDID data
[   70.749692] [drm] DAC-6: set mode  29
[   96.553132] iwlagn 0000:0c:00.0: Radio Frequency Kill Switch is On:
[   96.553138] Kill switch must be turned off for wireless networking to work.
[   96.624194] usb 3-2: USB disconnect, address 2
[   96.625155] btusb_intr_complete: hci0 urb c294bf00 failed to resubmit (19)
[   96.625169] btusb_bulk_complete: hci0 urb c294b300 failed to resubmit (19)
[   96.626164] btusb_bulk_complete: hci0 urb c294bf80 failed to resubmit (19)
[   96.626570] btusb_send_frame: hci0 urb c1c6b080 submission failed
[   99.269030] wlan0: deauthenticating by local choice (reason=3)
comm: file 2 is not in sorted order
[  108.908082] usb 3-2: new full speed USB device using uhci_hcd and address 3
[  109.087549] usb 3-2: configuration #1 chosen from 1 choice
[  111.454680] Registered led device: iwl-phy0::radio
[  111.454697] Registered led device: iwl-phy0::assoc
[  111.454711] Registered led device: iwl-phy0::RX
[  111.454724] Registered led device: iwl-phy0::TX
[  111.488641] ADDRCONF(NETDEV_UP): wlan0: link is not ready