Error: command ['sh', '-c', 'dmesg | comm -13 /var/log/dmesg -'] failed with exit code 1: [   25.291494] ADDRCONF(NETDEV_UP): eth0: link is not ready
[   25.337145] b43 ssb0:0: firmware: requesting b43/ucode5.fw
[   25.432829] b43 ssb0:0: firmware: requesting b43/pcm5.fw
[   25.535923] b43 ssb0:0: firmware: requesting b43/b0g0initvals5.fw
[   25.695551] b43 ssb0:0: firmware: requesting b43/b0g0bsinitvals5.fw
[   25.885107] b43-phy0: Loading firmware version 410.2160 (2007-05-26 15:32:10)
[   25.975350] Registered led device: b43-phy0::tx
[   25.975522] Registered led device: b43-phy0::rx
[   25.975678] Registered led device: b43-phy0::radio
[   25.975749] b43-phy0: Radio hardware status changed to DISABLED
[   26.593078] b43-phy0: Radio turned on by software
[   26.593084] b43-phy0: The hardware RF-kill button still turns the radio physically off. Press the button to turn it on.
[   26.594056] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   28.804227] b44: eth0: Link is up at 100 Mbps, full duplex.
[   28.804232] b44: eth0: Flow control is off for TX and off for RX.
[   28.804751] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   39.148196] eth0: no IPv6 routers present
comm: file 2 is not in sorted order
[  341.308137] CE: hpet increasing min_delta_ns to 15000 nsec
[  493.897165] CE: hpet increasing min_delta_ns to 22500 nsec