[ 66.670833] [fglrx] GART Table is not in FRAME_BUFFER range [ 66.721804] fglrx_pci 0000:01:05.0: irq 2297 for MSI/MSI-X [ 66.740660] [fglrx] Firegl kernel thread PID: 4238 [ 66.746595] APIC error on CPU1: 00(08) [ 66.746599] APIC error on CPU0: 00(08) [ 66.838655] [fglrx] Gart USWC size:1754 M. [ 66.838659] [fglrx] Gart cacheable size:60 M. [ 66.838665] [fglrx] Reserved FB block: Shared offset:0, size:1000000 [ 66.838668] [fglrx] Reserved FB block: Unshared offset:fffb000, size:5000 [ 68.284312] r8169: eth4: link down [ 68.287639] ADDRCONF(NETDEV_UP): eth4: link is not ready [ 108.964960] CPU0 attaching NULL sched-domain. [ 108.964982] CPU1 attaching NULL sched-domain. [ 108.980715] CPU0 attaching sched-domain: [ 108.980728] domain 0: span 0-1 level MC [ 108.980738] groups: 0 1 [ 108.980751] domain 1: span 0-1 level CPU [ 108.980759] groups: 0-1 [ 108.980774] CPU1 attaching sched-domain: [ 108.980780] domain 0: span 0-1 level MC [ 108.980786] groups: 1 0 [ 108.980796] domain 1: span 0-1 level CPU [ 108.980803] groups: 0-1 [ 133.452966] cfg80211: Calling CRDA to update world regulatory domain [ 133.534539] cfg80211: World regulatory domain updated: [ 133.534552] (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 133.534563] (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 133.534572] (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) [ 133.534580] (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) [ 133.534589] (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 133.534597] (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 133.569219] ath9k: 0.1 [ 133.569434] ath9k 0000:09:00.0: PCI INT A -> GSI 18 (level, low) -> IRQ 18 [ 133.569459] ath9k 0000:09:00.0: setting latency timer to 64 [ 134.005441] phy0: Selected rate control algorithm 'ath9k_rate_control' [ 134.065474] Registered led device: ath9k-phy0:radio [ 134.065491] Registered led device: ath9k-phy0:assoc [ 134.065506] Registered led device: ath9k-phy0:tx [ 134.065522] Registered led device: ath9k-phy0:rx [ 134.066259] phy0: Atheros 9280: mem=0xffffc20002400000, irq=18 [ 134.084186] udev: renamed network interface wlan0 to wlan2 [ 138.326648] ADDRCONF(NETDEV_UP): wlan2: link is not ready [ 151.945687] wlan2: authenticate with AP 00:12:17:32:b1:e6 [ 152.144134] wlan2: authenticate with AP 00:12:17:32:b1:e6 [ 152.346906] wlan2: authenticate with AP 00:12:17:32:b1:e6 [ 152.544148] wlan2: authentication with AP 00:12:17:32:b1:e6 timed out [ 169.276449] wlan2: authenticate with AP 00:12:17:32:b1:e6 [ 169.287655] wlan2: authenticate with AP 00:12:17:32:b1:e6 [ 169.484111] wlan2: authenticate with AP 00:12:17:32:b1:e6 [ 169.684588] wlan2: authenticate with AP 00:12:17:32:b1:e6 [ 169.884585] wlan2: authentication with AP 00:12:17:32:b1:e6 timed out [ 190.247982] wlan2: authenticate with AP 00:12:17:32:b1:e6 [ 190.258403] wlan2: authenticate with AP 00:12:17:32:b1:e6 [ 190.456591] wlan2: authenticate with AP 00:12:17:32:b1:e6 [ 190.462218] wlan2: authenticated [ 190.462230] wlan2: associate with AP 00:12:17:32:b1:e6 [ 190.465722] wlan2: RX AssocResp from 00:12:17:32:b1:e6 (capab=0x431 status=0 aid=1) [ 190.465732] wlan2: associated [ 190.487872] ADDRCONF(NETDEV_CHANGE): wlan2: link becomes ready [ 200.552583] wlan2: no IPv6 routers present