[   22.963095] [drm] Setting GART location based on new memory map
[   22.964697] [drm] Loading R500 Microcode
[   22.964752] [drm] Num pipes: 1
[   22.964767] [drm] writeback test succeeded in 1 usecs
[   25.908963] ADDRCONF(NETDEV_UP): eth0: link is not ready
[   25.910665] iwl3945 0000:0b:00.0: firmware: requesting iwlwifi-3945-1.ucode
[   26.001752] Registered led device: iwl-phy0:radio
[   26.001773] Registered led device: iwl-phy0:assoc
[   26.001830] Registered led device: iwl-phy0:RX
[   26.001848] Registered led device: iwl-phy0:TX
[   26.018085] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[  114.334294] wlan0: authenticate with AP 00:18:4d:99:e4:d2
[  114.336193] wlan0: authenticated
[  114.336200] wlan0: associate with AP 00:18:4d:99:e4:d2
[  114.339243] wlan0: RX AssocResp from 00:18:4d:99:e4:d2 (capab=0x431 status=0 aid=2)
[  114.339249] wlan0: associated
[  114.345928] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[  124.457064] wlan0: no IPv6 routers present
[ 2342.709120] Uhhuh. NMI received for unknown reason b0 on CPU 0.
[ 2342.709127] You have some hardware problem, likely on the PCI bus.
[ 2342.709130] Dazed and confused, but trying to continue
[ 2354.112258] hda-intel: IRQ timing workaround is activated for card #0. Suggest a bigger bdl_pos_adj.
[ 2354.435302] CE: hpet increasing min_delta_ns to 15000 nsec
[ 2354.435378] CE: hpet increasing min_delta_ns to 22500 nsec
[ 2355.421317] CE: hpet increasing min_delta_ns to 33750 nsec
[ 2363.512116] CE: hpet increasing min_delta_ns to 50624 nsec
[ 2392.873273] CE: hpet increasing min_delta_ns to 75936 nsec
[ 2496.553342] CE: hpet increasing min_delta_ns to 113904 nsec
[ 3291.973792] [drm] Num pipes: 1
[ 3292.263011] wlan0: disassociating by local choice (reason=3)
[ 3292.663036] mtrr: no MTRR for d0000000,4000000 found
[ 3294.540624] wlan0: deauthenticated
[ 3295.138288] [drm] Setting GART location based on new memory map
[ 3295.140079] [drm] Loading R500 Microcode
[ 3295.140135] [drm] Num pipes: 1
[ 3295.140149] [drm] writeback test succeeded in 1 usecs
[ 3297.729175] [drm] Num pipes: 1
[ 3305.009850] [drm] Loading R500 Microcode
[ 3305.009916] [drm] Num pipes: 1
[ 3315.949011] hda_intel: azx_get_response timeout, switching to polling mode: last cmd=0x005f000a
[ 3323.214691] wlan0: authenticate with AP 00:18:4d:99:e4:d2
[ 3323.216487] wlan0: authenticated
[ 3323.216494] wlan0: associate with AP 00:18:4d:99:e4:d2
[ 3323.218939] wlan0: RX AssocResp from 00:18:4d:99:e4:d2 (capab=0x431 status=0 aid=2)
[ 3323.218945] wlan0: associated
[ 4172.768119] usb 5-1: USB disconnect, address 2