[   35.498576] [drm] Initialized drm 1.1.0 20060810
[   35.503319] pci 0000:00:02.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
[   35.503323] pci 0000:00:02.0: setting latency timer to 64
[   35.503439] pci 0000:00:02.0: irq 2300 for MSI/MSI-X
[   35.503521] [drm] Initialized i915 1.6.0 20080730 on minor 0
[   35.504743] [drm:i915_setparam] *ERROR* unknown parameter 4
[   37.189444] tg3 0000:09:00.0: irq 2299 for MSI/MSI-X
[   37.267170] ADDRCONF(NETDEV_UP): eth0: link is not ready
[   37.357786] input: b43-phy0 as /devices/virtual/input/input12
[   37.453078] b43 ssb0:0: firmware: requesting b43/ucode5.fw
[   37.518500] b43 ssb0:0: firmware: requesting b43/pcm5.fw
[   37.542478] b43 ssb0:0: firmware: requesting b43/b0g0initvals5.fw
[   37.546381] b43 ssb0:0: firmware: requesting b43/b0g0bsinitvals5.fw
[   37.665194] b43-phy0: Loading firmware version 351.126 (2006-07-29 05:54:02)
[   37.665202] b43-phy0 warning: You are using an old firmware image. Support for old firmware will be removed in July 2008.
[   37.665206] b43-phy0 warning: You must go to http://linuxwireless.org/en/users/Drivers/b43#devicefirmware and download the latest firmware (version 4).
[   37.745537] Registered led device: b43-phy0::tx
[   37.745555] Registered led device: b43-phy0::rx
[   37.745574] Registered led device: b43-phy0::radio
[   37.765068] b43-phy0: Radio turned on by software
[   37.765435] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   39.292364] wlan0: authenticate with AP 00:11:50:40:c8:dd
[   39.293907] wlan0: authenticated
[   39.293912] wlan0: associate with AP 00:11:50:40:c8:dd
[   39.296122] wlan0: RX AssocResp from 00:11:50:40:c8:dd (capab=0x401 status=0 aid=3)
[   39.296126] wlan0: associated
[   39.296391] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[   39.311532] wlan0: disassociating by local choice (reason=3)
[   41.528348] cdrom: This disc doesn't have any tracks I recognize!
[   50.240038] wlan0: no IPv6 routers present
[   58.160820] wlan0: authenticate with AP 00:11:50:40:c8:dd
[   58.168212] wlan0: authenticate with AP 00:11:50:40:c8:dd
[   58.170084] wlan0: authenticated
[   58.170089] wlan0: associate with AP 00:11:50:40:c8:dd
[   58.173093] wlan0: RX ReassocResp from 00:11:50:40:c8:dd (capab=0x401 status=0 aid=3)
[   58.173097] wlan0: associated
[ 1080.320032] CE: hpet increasing min_delta_ns to 15000 nsec
[ 8982.462228] warning: `VirtualBox' uses 32-bit capabilities (legacy support in use)
[22215.901650] hda-intel: IRQ timing workaround is activated for card #0. Suggest a bigger bdl_pos_adj.
[22216.136500] usb 2-2: new high speed USB device using ehci_hcd and address 3
[22216.270417] usb 2-2: configuration #1 chosen from 1 choice
[22216.715107] Initializing USB Mass Storage driver...
[22216.716261] scsi4 : SCSI emulation for USB Mass Storage devices
[22216.716447] usbcore: registered new interface driver usb-storage
[22216.716454] USB Mass Storage support registered.
[22216.716829] usb-storage: device found at 3
[22216.716833] usb-storage: waiting for device to settle before scanning
[22221.716646] usb-storage: device scan complete
[22221.717907] scsi 4:0:0:0: Direct-Access     WD       10EAVS External  1.05 PQ: 0 ANSI: 4
[22221.720083] sd 4:0:0:0: [sdb] 1953525168 512-byte hardware sectors: (1.00 TB/931 GiB)
[22221.721737] sd 4:0:0:0: [sdb] Write Protect is off
[22221.721744] sd 4:0:0:0: [sdb] Mode Sense: 21 00 00 00
[22221.721749] sd 4:0:0:0: [sdb] Assuming drive cache: write through
[22221.722451] sd 4:0:0:0: [sdb] 1953525168 512-byte hardware sectors: (1.00 TB/931 GiB)
[22221.723345] sd 4:0:0:0: [sdb] Write Protect is off
[22221.723351] sd 4:0:0:0: [sdb] Mode Sense: 21 00 00 00
[22221.723355] sd 4:0:0:0: [sdb] Assuming drive cache: write through
[22221.723362]  sdb: sdb1
[22221.747946] sd 4:0:0:0: [sdb] Attached SCSI disk
[22221.748091] sd 4:0:0:0: Attached scsi generic sg2 type 0