[   19.420450] atkbd.c: Unknown key pressed (translated set 2, code 0xf7 on isa0060/serio0).
[   19.420453] atkbd.c: Use 'setkeycodes e077 <keycode>' to make it known.
[   19.421688] atkbd.c: Unknown key released (translated set 2, code 0xf7 on isa0060/serio0).
[   19.421691] atkbd.c: Use 'setkeycodes e077 <keycode>' to make it known.
[   20.486660] atkbd.c: Unknown key pressed (translated set 2, code 0xf8 on isa0060/serio0).
[   20.486663] atkbd.c: Use 'setkeycodes e078 <keycode>' to make it known.
[   20.487923] atkbd.c: Unknown key released (translated set 2, code 0xf8 on isa0060/serio0).
[   20.487925] atkbd.c: Use 'setkeycodes e078 <keycode>' to make it known.
[   20.683558] [drm] Initialized drm 1.1.0 20060810
[   20.688450] pci 0000:00:02.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
[   20.688454] pci 0000:00:02.0: setting latency timer to 64
[   20.688563] pci 0000:00:02.0: irq 2296 for MSI/MSI-X
[   20.688642] [drm] Initialized i915 1.6.0 20080730 on minor 0
[   20.693361] [drm:i915_setparam] *ERROR* unknown parameter 4
[   21.098492] atkbd.c: Unknown key pressed (translated set 2, code 0xf7 on isa0060/serio0).
[   21.098496] atkbd.c: Use 'setkeycodes e077 <keycode>' to make it known.
[   21.099750] atkbd.c: Unknown key released (translated set 2, code 0xf7 on isa0060/serio0).
[   21.099752] atkbd.c: Use 'setkeycodes e077 <keycode>' to make it known.
[   21.368932] r8169: eth0: link down
[   21.369149] ADDRCONF(NETDEV_UP): eth0: link is not ready
[   21.369792] iwlagn 0000:03:00.0: firmware: requesting iwlwifi-4965-2.ucode
[   21.413385] iwlagn: Radio disabled by HW RF Kill switch
[   21.414659] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   21.732287] atkbd.c: Unknown key pressed (translated set 2, code 0xf8 on isa0060/serio0).
[   21.732290] atkbd.c: Use 'setkeycodes e078 <keycode>' to make it known.
[   21.733570] atkbd.c: Unknown key released (translated set 2, code 0xf8 on isa0060/serio0).
[   21.733573] atkbd.c: Use 'setkeycodes e078 <keycode>' to make it known.
[   35.325198] atkbd.c: Unknown key pressed (translated set 2, code 0xf8 on isa0060/serio0).
[   35.325201] atkbd.c: Use 'setkeycodes e078 <keycode>' to make it known.
[   35.326459] atkbd.c: Unknown key released (translated set 2, code 0xf8 on isa0060/serio0).
[   35.326462] atkbd.c: Use 'setkeycodes e078 <keycode>' to make it known.
[   43.388721] atkbd.c: Unknown key pressed (translated set 2, code 0xe2 on isa0060/serio0).
[   43.388724] atkbd.c: Use 'setkeycodes e062 <keycode>' to make it known.
[   43.389982] atkbd.c: Unknown key released (translated set 2, code 0xe2 on isa0060/serio0).
[   43.389985] atkbd.c: Use 'setkeycodes e062 <keycode>' to make it known.
[   43.390878] atkbd.c: Unknown key pressed (translated set 2, code 0xf6 on isa0060/serio0).
[   43.390881] atkbd.c: Use 'setkeycodes e076 <keycode>' to make it known.
[   43.392187] atkbd.c: Unknown key released (translated set 2, code 0xf6 on isa0060/serio0).
[   43.392191] atkbd.c: Use 'setkeycodes e076 <keycode>' to make it known.
[   44.200028] usb 3-2: new full speed USB device using uhci_hcd and address 2
[   44.563139] usb 3-2: configuration #1 chosen from 1 choice
[   44.585477] Bluetooth: Generic Bluetooth USB driver ver 0.3
[   44.585865] usbcore: registered new interface driver btusb
[   85.461417] Registered led device: iwl-phy0:radio
[   85.463029] Registered led device: iwl-phy0:assoc
[   85.463077] Registered led device: iwl-phy0:RX
[   85.463114] Registered led device: iwl-phy0:TX
[   85.553567] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   92.612944] wlan0: authenticate with AP 00:1c:df:96:e4:54
[   92.614901] wlan0: authenticated
[   92.614910] wlan0: associate with AP 00:1c:df:96:e4:54
[   92.617777] wlan0: RX AssocResp from 00:1c:df:96:e4:54 (capab=0x411 status=0 aid=1)
[   92.617783] wlan0: associated
[   92.637903] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[   92.873890] padlock: VIA PadLock not detected.
[  103.256078] wlan0: no IPv6 routers present