[   16.862716] ACPI: \_SB_.PCI0.SATA.PRT1: found ejectable bay
[   16.862721] ACPI: \_SB_.PCI0.SATA.PRT1: Adding notify handler
[   16.862746] ACPI: Error installing bay notify handler
[   17.825588] warning: `avahi-daemon' uses 32-bit capabilities (legacy support in use)
[   18.019701] ppdev: user-space parallel port driver
[   19.187790] IBM TrackPoint firmware: 0x0e, buttons: 3/3
[   19.435796] input: TPPS/2 IBM TrackPoint as /devices/platform/i8042/serio1/serio2/input/input10
[   20.186567] Bluetooth: L2CAP ver 2.11
[   20.186578] Bluetooth: L2CAP socket layer initialized
[   20.223042] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
[   20.223054] Bluetooth: BNEP filters: protocol multicast
[   20.271784] Bridge firewalling registered
[   20.286772] Bluetooth: SCO (Voice Link) ver 0.6
[   20.286781] Bluetooth: SCO socket layer initialized
[   20.401192] Bluetooth: RFCOMM socket layer initialized
[   20.401582] Bluetooth: RFCOMM TTY layer initialized
[   20.401591] Bluetooth: RFCOMM ver 1.10
[   23.578172] [drm] Initialized drm 1.1.0 20060810
[   23.581293] pci 0000:00:02.0: power state changed by ACPI to D0
[   23.581304] pci 0000:00:02.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
[   23.581307] pci 0000:00:02.0: setting latency timer to 64
[   23.581514] [drm] Initialized i915 1.6.0 20060119 on minor 0
[   24.599222] set status page addr 0x041ab000
[   24.607536] iwlagn 0000:03:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
[   24.607649] iwlagn 0000:03:00.0: restoring config space at offset 0x1 (was 0x100102, writing 0x100106)
[   24.607845] firmware: requesting iwlwifi-5000-1.ucode
[   26.857046] Registered led device: iwl-phy0:radio
[   26.858419] Registered led device: iwl-phy0:assoc
[   26.859875] Registered led device: iwl-phy0:RX
[   26.862436] Registered led device: iwl-phy0:TX
[   27.031504] NET: Registered protocol family 17
[   44.842101] NET: Registered protocol family 10
[   44.843341] lo: Disabled Privacy Extensions
[   44.844703] ADDRCONF(NETDEV_UP): eth0: link is not ready
[   44.846817] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   71.061580] CPU0 attaching NULL sched-domain.
[   71.061587] CPU1 attaching NULL sched-domain.
[   71.072600] CPU0 attaching sched-domain:
[   71.072605]  domain 0: span 0-1 level MC
[   71.072608]   groups: 0 1
[   71.072612]   domain 1: span 0-1 level NODE
[   71.072615]    groups: 0-1
[   71.072619] CPU1 attaching sched-domain:
[   71.072621]  domain 0: span 0-1 level MC
[   71.072623]   groups: 1 0
[   71.072627]   domain 1: span 0-1 level NODE
[   71.072629]    groups: 0-1
[   74.065955] wlan0: authenticate with AP 00:1c:f0:c2:7e:c7
[   74.066283] wlan0: authenticate with AP 00:1c:f0:c2:7e:c7
[   74.068394] wlan0: authenticated
[   74.068404] wlan0: associate with AP 00:1c:f0:c2:7e:c7
[   74.074057] wlan0: RX AssocResp from 00:1c:f0:c2:7e:c7 (capab=0x431 status=0 aid=1)
[   74.074067] wlan0: associated
[   74.074158] wlan0 (WE) : Wireless Event too big (320)
[   74.109867] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[   84.772095] wlan0: no IPv6 routers present
[  107.996366] process `skype.real' is using obsolete setsockopt SO_BSDCOMPAT
[  795.756084] CE: hpet increasing min_delta_ns to 15000 nsec