Comment 2 for bug 275345

I have a similar problem. Since updating from Hardy to Intrepid beta I can only use my SD card after ejecting it once.

Here is what /var/log/messages says during booting:

--- cut here ---
Oct 5 17:25:07 lllu0143 kernel: [ 14.130616] sdhci-pci 0000:02:00.1: SDHCI controller found [1180:0822] (rev 13)
Oct 5 17:25:07 lllu0143 kernel: [ 14.130634] sdhci-pci 0000:02:00.1: PCI INT B -> GSI 17 (level, low) -> IRQ 17
Oct 5 17:25:07 lllu0143 kernel: [ 14.133722] mmc0: SDHCI controller on PCI [0000:02:00.1] using PIO
Oct 5 17:25:07 lllu0143 kernel: [ 14.203597] wlan: 0.9.4
Oct 5 17:25:07 lllu0143 kernel: [ 14.284482] mmc0: new SDHC card at address d164
[...]
Oct 5 17:25:07 lllu0143 kernel: [ 17.160278] mmcblk0: mmc0:d164 SD32G 31850496KiB
Oct 5 17:25:07 lllu0143 kernel: [ 17.160337] mmcblk0: p1
--- cut here ---

I have no notification in the KDE plasmoid for removable devices. I do see the partition in dolphin - but I cannot access it.

After ejecting the card and re-inserting it /var/log/messages displays:

--- cut here ---
Oct 5 17:47:56 lllu0143 kernel: [ 1392.444143] mmc0: card d164 removed
Oct 5 17:47:58 lllu0143 kernel: [ 1394.784596] mmc0: new SDHC card at address d164
Oct 5 17:47:58 lllu0143 kernel: [ 1394.794916] mmcblk0: mmc0:d164 SD32G 31850496KiB
Oct 5 17:47:58 lllu0143 kernel: [ 1394.796070] mmcblk0: p1
--- cut here ---

No I do have a notification in the KDE plasmoid, dolphin shows it just like before - but now I can access it.

Hardware: Thinkpad X40

02:00.1 SD Host controller [0805]: Ricoh Co Ltd R5C822 SD/SDIO/MMC/MS/MSPro Host Adapter [1180:0822] (rev 13)
        Subsystem: IBM Device [1014:0556]
        Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B- DisINTx-
        Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
        Latency: 64
        Interrupt: pin B routed to IRQ 17
        Region 0: Memory at d0210000 (32-bit, non-prefetchable) [size=256]
        Capabilities: [80] Power Management version 2
                Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0+,D1+,D2+,D3hot+,D3cold+)
                Status: D0 PME-Enable- DSel=0 DScale=2 PME-
        Kernel driver in use: sdhci-pci
        Kernel modules: sdhci-pci