[    1.974958] input: HDA NVidia HDMI/DP,pcm=3 as /devices/pci0000:00/0000:00:01.0/0000:01:00.1/sound/card1/input15
[    1.975026] input: HDA NVidia HDMI/DP,pcm=7 as /devices/pci0000:00/0000:00:01.0/0000:01:00.1/sound/card1/input17
[    1.975087] input: HDA NVidia HDMI/DP,pcm=8 as /devices/pci0000:00/0000:00:01.0/0000:01:00.1/sound/card1/input19
[    1.975157] input: HDA NVidia HDMI/DP,pcm=9 as /devices/pci0000:00/0000:00:01.0/0000:01:00.1/sound/card1/input21
[    1.983054] input: HDA NVidia HDMI/DP,pcm=3 as /devices/pci0000:00/0000:00:01.1/0000:02:00.1/sound/card2/input16
[    1.983142] input: HDA NVidia HDMI/DP,pcm=7 as /devices/pci0000:00/0000:00:01.1/0000:02:00.1/sound/card2/input18
[    1.983196] input: HDA NVidia HDMI/DP,pcm=8 as /devices/pci0000:00/0000:00:01.1/0000:02:00.1/sound/card2/input20
[    1.983381] input: HDA NVidia HDMI/DP,pcm=9 as /devices/pci0000:00/0000:00:01.1/0000:02:00.1/sound/card2/input22
[    2.022841] init: plymouth-upstart-bridge main process ended, respawning
[    2.080011] usb 1-10.3: New USB device found, idVendor=0bda, idProduct=0119
[    2.080013] usb 1-10.3: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[    2.080014] usb 1-10.3: Product: USB2.0-CRW
[    2.080015] usb 1-10.3: Manufacturer: Generic
[    2.080016] usb 1-10.3: SerialNumber: 20090815198100000
[    2.085240] usb-storage 1-10.3:1.0: USB Mass Storage device detected
[    2.085377] scsi host8: usb-storage 1-10.3:1.0
[    2.085449] usbcore: registered new interface driver usb-storage
[    2.086359] usbcore: registered new interface driver uas
[    2.495997] Switched to clocksource tsc
[    2.624742] init: plymouth-splash main process (1283) terminated with status 1
[    2.669219] NVRM: Your system is not currently configured to drive a VGA console
[    2.669221] NVRM: on the primary VGA device. The NVIDIA Linux graphics driver
[    2.669222] NVRM: requires the use of a text-mode VGA console. Use of other console
[    2.669223] NVRM: drivers including, but not limited to, vesafb, may result in
[    2.669223] NVRM: corruption and stability problems, and is not supported.
[    3.086072] scsi 8:0:0:0: Direct-Access     Generic- SD/MMC           1.00 PQ: 0 ANSI: 0 CCS
[    3.086204] sd 8:0:0:0: Attached scsi generic sg4 type 0
[    3.324651] sound hdaudioC1D0: HDMI: invalid ELD data byte 68
[    3.798577] sd 8:0:0:0: [sdd] 62333952 512-byte logical blocks: (31.9 GB/29.7 GiB)
[    3.798909] sd 8:0:0:0: [sdd] Write Protect is off
[    3.798912] sd 8:0:0:0: [sdd] Mode Sense: 03 00 00 00
[    3.799221] sd 8:0:0:0: [sdd] No Caching mode page found
[    3.799224] sd 8:0:0:0: [sdd] Assuming drive cache: write through
[    3.811172]  sdd: sdd1
[    3.812608] sd 8:0:0:0: [sdd] Attached SCSI removable disk
[    4.552253] e1000e: eth0 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: Rx/Tx
[    4.552302] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[    8.536677] FAT-fs (sdd1): Volume was not properly unmounted. Some data may be corrupt. Please run fsck.
[   31.640233] audit_printk_skb: 153 callbacks suppressed
[   31.640235] audit: type=1400 audit(1451502344.542:62): apparmor="STATUS" operation="profile_replace" profile="unconfined" name="/usr/lib/cups/backend/cups-pdf" pid=2583 comm="apparmor_parser"
[   31.640239] audit: type=1400 audit(1451502344.542:63): apparmor="STATUS" operation="profile_replace" profile="unconfined" name="/usr/sbin/cupsd" pid=2583 comm="apparmor_parser"
[   31.640434] audit: type=1400 audit(1451502344.542:64): apparmor="STATUS" operation="profile_replace" profile="unconfined" name="/usr/sbin/cupsd" pid=2583 comm="apparmor_parser"