[   53.968724] wlan0: send auth to 34:6b:d3:99:da:0c (try 1/3)
[   53.970548] wlan0: authenticated
[   53.972096] wlan0: associate with 34:6b:d3:99:da:0c (try 1/3)
[   53.974912] wlan0: RX AssocResp from 34:6b:d3:99:da:0c (capab=0x411 status=0 aid=3)
[   53.979598] wlan0: associated
[   53.979639] IPv6: ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[   54.197051] wlan0: deauthenticating from 34:6b:d3:99:da:0c by local choice (reason=2)
[   54.221188] wlan0: authenticate with 34:6b:d3:99:da:0c
[   54.221327] wlan0: send auth to 34:6b:d3:99:da:0c (try 1/3)
[   54.221877] cfg80211: Calling CRDA to update world regulatory domain
[   54.223441] wlan0: authenticated
[   54.224063] wlan0: associate with 34:6b:d3:99:da:0c (try 1/3)
[   54.226783] wlan0: RX AssocResp from 34:6b:d3:99:da:0c (capab=0x411 status=0 aid=3)
[   54.227342] cfg80211: World regulatory domain updated:
[   54.227348] cfg80211:   (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[   54.227353] cfg80211:   (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   54.227358] cfg80211:   (2457000 KHz - 2482000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   54.227362] cfg80211:   (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[   54.227366] cfg80211:   (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   54.227371] cfg80211:   (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[   54.228845] wlan0: associated
[   60.655972] init: plymouth-upstart-bridge main process ended, respawning
[   60.754318] init: plymouth-upstart-bridge main process ended, respawning
[   61.725762] Adding 1961980k swap on /dev/mapper/cryptswap1.  Priority:-1 extents:1 across:1961980k FS
[   68.755400] init: anacron main process (1001) killed by TERM signal
[  589.989633] SGI XFS with ACLs, security attributes, realtime, large block/inode numbers, no debug enabled
[  590.081781] JFS: nTxBlock = 8192, nTxLock = 65536
[  590.252364] NTFS driver 2.1.30 [Flags: R/O MODULE].
[  590.545366] QNX4 filesystem 0.2.3 registered.
[  590.655173] xor: measuring software checksum speed
[  590.692017]    pIII_sse  :  3062.000 MB/sec
[  590.732021]    prefetch64-sse:  3359.000 MB/sec
[  590.732030] xor: using function: prefetch64-sse (3359.000 MB/sec)
[  590.836074] raid6: mmxx1     1131 MB/s
[  590.904031] raid6: mmxx2     1238 MB/s
[  590.972068] raid6: sse1x1     875 MB/s
[  591.040048] raid6: sse1x2    1131 MB/s
[  591.108060] raid6: sse2x1    1344 MB/s
[  591.176055] raid6: sse2x2    1425 MB/s
[  591.176063] raid6: using algorithm sse2x2 (1425 MB/s)
[  591.176068] raid6: using intx1 recovery algorithm
[  591.360926] bio: create slab <bio-2> at 2
[  591.361373] Btrfs loaded
[  637.878728] perf samples too long (2514 > 2500), lowering kernel.perf_event_max_sample_rate to 50000
[  736.500097] ieee80211 phy0: wlan0: No probe response from AP 34:6b:d3:99:da:0c after 500ms, disconnecting.
[  736.528854] cfg80211: Calling CRDA to update world regulatory domain
[  736.604114] cfg80211: World regulatory domain updated:
[  736.604122] cfg80211:   (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[  736.604127] cfg80211:   (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[  736.604132] cfg80211:   (2457000 KHz - 2482000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[  736.604137] cfg80211:   (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[  736.604141] cfg80211:   (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[  736.604145] cfg80211:   (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[  739.765166] wlan0: authenticate with 34:6b:d3:99:da:0c
[  739.768824] wlan0: send auth to 34:6b:d3:99:da:0c (try 1/3)
[  739.770665] wlan0: authenticated
[  739.772278] wlan0: associate with 34:6b:d3:99:da:0c (try 1/3)
[  739.775042] wlan0: RX AssocResp from 34:6b:d3:99:da:0c (capab=0x411 status=0 aid=3)
[  739.779428] wlan0: associated
[ 1688.106415] iwl3945 0000:0c:00.0: Microcode SW error detected. Restarting 0x82000008.
[ 1688.106428] iwl3945 0000:0c:00.0: Loaded firmware version: 15.32.2.9
[ 1688.106477] iwl3945 0000:0c:00.0: Start IWL Error Log Dump:
[ 1688.106483] iwl3945 0000:0c:00.0: Status: 0x000202E4, count: 1
[ 1688.106488] iwl3945 0000:0c:00.0: Desc       Time       asrtPC  blink2 ilink1  nmiPC   Line
[ 1688.106719] iwl3945 0000:0c:00.0: SYSASSERT     (0x5) 0000202126 0x008B6 0x00274 0x00320 0x04EBE 116
[ 1688.106719] 
[ 1688.106739] iwl3945 0000:0c:00.0: Error Reply type 0x00000005 cmd C_TX (0x1C) seq 0x02A5 ser 0x00740000
[ 1688.106754] iwl3945 0000:0c:00.0: Command C_RXON failed: FW Error
[ 1688.106761] iwl3945 0000:0c:00.0: Error clearing ASSOC_MSK on current configuration (-5).
[ 1688.108011] iwl3945 0000:0c:00.0: Can't stop Rx DMA.
[ 1688.119241] ieee80211 phy0: Hardware restart was requested
[ 2056.496067] ieee80211 phy0: wlan0: No probe response from AP 34:6b:d3:99:da:0c after 500ms, disconnecting.
[ 2056.553658] cfg80211: Calling CRDA to update world regulatory domain
[ 2057.063455] cfg80211: World regulatory domain updated:
[ 2057.063469] cfg80211:   (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[ 2057.063474] cfg80211:   (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 2057.063479] cfg80211:   (2457000 KHz - 2482000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 2057.063483] cfg80211:   (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[ 2057.063487] cfg80211:   (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 2057.063492] cfg80211:   (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 2059.861543] wlan0: authenticate with 34:6b:d3:99:da:0c
[ 2059.861748] wlan0: send auth to 34:6b:d3:99:da:0c (try 1/3)
[ 2059.865376] wlan0: authenticated
[ 2059.868068] wlan0: associate with 34:6b:d3:99:da:0c (try 1/3)
[ 2059.870800] wlan0: RX AssocResp from 34:6b:d3:99:da:0c (capab=0x411 status=0 aid=3)
[ 2059.875679] wlan0: associated
[ 2286.794528] iwl3945 0000:0c:00.0: Microcode SW error detected. Restarting 0x82000008.
[ 2286.794568] iwl3945 0000:0c:00.0: Loaded firmware version: 15.32.2.9
[ 2286.794606] iwl3945 0000:0c:00.0: Start IWL Error Log Dump:
[ 2286.794615] iwl3945 0000:0c:00.0: Status: 0x000202E4, count: 1
[ 2286.794622] iwl3945 0000:0c:00.0: Desc       Time       asrtPC  blink2 ilink1  nmiPC   Line
[ 2286.794855] iwl3945 0000:0c:00.0: SYSASSERT     (0x5) 0000202183 0x008B6 0x00274 0x00320 0x04EBE 116
[ 2286.794855] 
[ 2286.794888] iwl3945 0000:0c:00.0: Error Reply type 0x00000005 cmd C_TX (0x1C) seq 0x024A ser 0x00740000
[ 2286.794919] iwl3945 0000:0c:00.0: Command C_RXON failed: FW Error
[ 2286.794958] iwl3945 0000:0c:00.0: Error clearing ASSOC_MSK on current configuration (-5).
[ 2286.798893] iwl3945 0000:0c:00.0: Can't stop Rx DMA.
[ 2286.803532] ieee80211 phy0: Hardware restart was requested