[ 5.699178] usb 3-3: driver_version = mwifiex 1.0 (14.69.11.p179) [ 5.703732] ieee80211 phy0: uap0: changing to 2 not supported [ 5.750758] ieee80211 phy0: uap0: changing to 2 not supported [ 5.750937] ieee80211 phy0: uap0: changing to 2 not supported [ 5.751501] ieee80211 phy0: uap0: changing to 2 not supported [ 5.751518] ieee80211 phy0: uap0: changing to 2 not supported [ 5.751701] ieee80211 phy0: uap0: changing to 2 not supported [ 11.769447] do_trap: 165 callbacks suppressed [ 11.769453] traps: install-default[1694] trap int3 ip:7f763f2451f9 sp:7ffff0a6f340 error:0 [ 43.036527] ISO 9660 Extensions: Microsoft Joliet Level 3 [ 43.039778] ISO 9660 Extensions: RRIP_1991A [ 67.526123] usb 4-2: USB disconnect, device number 2 [ 67.530859] sd 6:0:0:0: [sdb] Synchronizing SCSI cache [ 67.530977] sd 6:0:0:0: [sdb] [ 67.530985] Result: hostbyte=DID_NO_CONNECT driverbyte=DRIVER_OK [ 67.531296] usb 4-2: Set SEL for device-initiated U1 failed. [ 67.531307] usb 4-2: Set SEL for device-initiated U2 failed. [ 73.616922] usb 3-2: new high-speed USB device number 5 using xhci_hcd [ 73.651792] usb 3-2: New USB device found, idVendor=05ac, idProduct=1402 [ 73.651802] usb 3-2: New USB device strings: Mfr=1, Product=2, SerialNumber=3 [ 73.651808] usb 3-2: Product: Apple USB Ethernet Adapter [ 73.651813] usb 3-2: Manufacturer: Apple Inc. [ 73.651818] usb 3-2: SerialNumber: 0ECB26 [ 73.982001] asix 3-2:1.0 eth0: register 'asix' at usb-0000:00:14.0-2, ASIX AX88772 USB 2.0 Ethernet, 10:9a:dd:41:c1:1e [ 73.982292] usbcore: registered new interface driver asix [ 74.802874] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready [ 74.803940] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready [ 76.615422] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready [ 76.616749] asix 3-2:1.0 eth0: link up, 100Mbps, full-duplex, lpa 0xC5E1 [ 308.465390] systemd-hostnamed[3429]: Warning: nss-myhostname is not installed. Changing the local hostname might make it unresolveable. Please install nss-myhostname!