[ 8.920036] usbcore: registered new interface driver bcm5974 [ 9.963206] bio: create slab at 1 [ 10.257769] bio: create slab at 1 [ 13.403098] applesmc: light sensor data length set to 10 [ 14.935334] mei 0000:00:16.0: init hw failure. [ 14.935419] mei 0000:00:16.0: initialization failed. [ 14.935542] ACPI Warning: 0x0000000000000830-0x000000000000083f SystemIO conflicts with Region \GPIO 1 (20121018/utaddress-251) [ 14.935550] ACPI: If an ACPI driver is available for this device, you should use it instead of the native driver [ 14.935552] ACPI Warning: 0x0000000000000800-0x000000000000082f SystemIO conflicts with Region \GPIO 1 (20121018/utaddress-251) [ 14.935557] ACPI Warning: 0x0000000000000800-0x000000000000082f SystemIO conflicts with Region \IO_D 2 (20121018/utaddress-251) [ 14.935561] ACPI Warning: 0x0000000000000800-0x000000000000082f SystemIO conflicts with Region \IO_T 3 (20121018/utaddress-251) [ 14.935566] ACPI: If an ACPI driver is available for this device, you should use it instead of the native driver [ 14.935568] lpc_ich: Resource conflict(s) found affecting gpio_ich [ 14.935888] snd_hda_intel 0000:00:03.0: irq 66 for MSI/MSI-X [ 14.951278] hda_codec: invalid CONNECT_LIST verb 3[0]:0 [ 14.951536] input: HDA Intel MID HDMI/DP,pcm=3 as /devices/pci0000:00/0000:00:03.0/sound/card1/input9 [ 14.952014] snd_hda_intel 0000:00:1b.0: irq 67 for MSI/MSI-X [ 15.155551] cfg80211: Calling CRDA for country: SE [ 15.170592] Adding 8161276k swap on /dev/mapper/cryptswap1. Priority:-1 extents:1 across:8161276k SS [ 15.172896] cfg80211: Regulatory domain changed to country: SE [ 15.172901] cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 15.172904] cfg80211: (2402000 KHz - 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm) [ 15.172907] cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (N/A, 2000 mBm) [ 15.172909] cfg80211: (5250000 KHz - 5330000 KHz @ 40000 KHz), (N/A, 2000 mBm) [ 15.172912] cfg80211: (5490000 KHz - 5710000 KHz @ 40000 KHz), (N/A, 2700 mBm)