[  945.884096] e1000e 0000:00:19.0: irq 45 for MSI/MSI-X
[  945.884628] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[  945.884903] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[  945.888949] mtrr: no more MTRRs available
[  945.889948] iwlwifi 0000:03:00.0: L1 Disabled; Enabling L0S
[  945.890332] iwlwifi 0000:03:00.0: Radio type=0x1-0x2-0x0
[  945.901821] mtrr: no more MTRRs available
[  945.902404] mtrr: no more MTRRs available
[  945.937426] init: lightdm main process (1694) terminated with status 1
[  946.004888] iwlwifi 0000:03:00.0: L1 Disabled; Enabling L0S
[  946.005265] iwlwifi 0000:03:00.0: Radio type=0x1-0x2-0x0
[  946.050842] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[  946.051056] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[  946.052763] mtrr: no more MTRRs available
[  946.109351] Adding 1951740k swap on /dev/mapper/cryptswap1.  Priority:-1 extents:1 across:1951740k 
[  946.113252] init: friendly-recovery post-stop process (984) terminated with status 1
[  946.465928] init: plymouth-stop pre-start process (2111) terminated with status 1
[  946.791106] cfg80211: Found new beacon on frequency: 5200 MHz (Ch 40) on phy0
[  947.388991] e1000e: eth0 NIC Link is Up 100 Mbps Full Duplex, Flow Control: Rx/Tx
[  947.388997] e1000e 0000:00:19.0: eth0: 10/100 speed: disabling TSO
[  947.389439] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[  952.600850] wlan0: authenticate with 00:0c:41:3a:34:b0
[  952.603499] wlan0: send auth to 00:0c:41:3a:34:b0 (try 1/3)
[  952.606593] wlan0: authenticated
[  952.608060] wlan0: associate with 00:0c:41:3a:34:b0 (try 1/3)
[  952.610779] wlan0: RX AssocResp from 00:0c:41:3a:34:b0 (capab=0x431 status=0 aid=4)
[  952.612357] wlan0: associated
[  952.612811] IPv6: ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[ 1197.928147] wlan0: deauthenticated from 00:0c:41:3a:34:b0 (Reason: 7)
[ 1197.938044] cfg80211: All devices are disconnected, going to restore regulatory settings
[ 1197.938053] cfg80211: Restoring regulatory settings
[ 1197.938085] cfg80211: Calling CRDA to update world regulatory domain
[ 1197.948342] cfg80211: Ignoring regulatory request Set by core since the driver uses its own custom regulatory domain
[ 1197.948350] cfg80211: World regulatory domain updated:
[ 1197.948354] cfg80211:   (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[ 1197.948360] cfg80211:   (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 1197.948365] cfg80211:   (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[ 1197.948370] cfg80211:   (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[ 1197.948374] cfg80211:   (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 1197.948379] cfg80211:   (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[ 1201.299525] wlan0: authenticate with 00:0c:41:3a:34:b0
[ 1201.302083] wlan0: send auth to 00:0c:41:3a:34:b0 (try 1/3)
[ 1201.314404] wlan0: authenticated
[ 1201.316125] wlan0: associate with 00:0c:41:3a:34:b0 (try 1/3)
[ 1201.318582] wlan0: RX AssocResp from 00:0c:41:3a:34:b0 (capab=0x431 status=0 aid=4)
[ 1201.319995] wlan0: associated