[   19.724700]  excluding 0x170-0x177 0x1f0-0x1f7 0x370-0x377
[   19.725695] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x3e0-0x4ff:
[   19.726203]  excluding 0x3f0-0x3f7 0x4d0-0x4d7
[   19.726671] pcmcia_socket pcmcia_socket0: cs: IO port probe 0x820-0x8ff:
[   19.727455]  clean.
[   19.727473] pcmcia_socket pcmcia_socket0: cs: IO port probe 0xc00-0xcf7:
[   19.728356]  clean.
[   19.728380] pcmcia_socket pcmcia_socket0: cs: memory probe 0x0c0000-0x0fffff:
[   19.728387]  excluding 0xc0000-0xcffff 0xdc000-0xfffff
[   19.728418] pcmcia_socket pcmcia_socket0: cs: memory probe 0xa0000000-0xa0ffffff:
[   19.728438]  clean.
[   19.728456] pcmcia_socket pcmcia_socket0: cs: memory probe 0x60000000-0x60ffffff:
[   19.728471]  excluding 0x60000000-0x60ffffff
[   19.728491] pcmcia_socket pcmcia_socket0: cs: IO port probe 0xa00-0xaff:
[   19.729384]  clean.
[   19.852435] ath: EEPROM regdomain: 0x64
[   19.852439] ath: EEPROM indicates we should expect a direct regpair map
[   19.852442] ath: Country alpha2 being used: 00
[   19.852444] ath: Regpair used: 0x64
[   19.852448] cfg80211: Updating information on frequency 2412 MHz for a 20 MHz width channel with regulatory rule:
[   19.852451] cfg80211: 2402000 KHz - 2472000 KHz @ 40000 KHz), (N/A mBi, 2000 mBm)
[   19.852453] cfg80211: Updating information on frequency 2417 MHz for a 20 MHz width channel with regulatory rule:
[   19.852455] cfg80211: 2402000 KHz - 2472000 KHz @ 40000 KHz), (N/A mBi, 2000 mBm)
[   19.852457] cfg80211: Updating information on frequency 2422 MHz for a 20 MHz width channel with regulatory rule:
[   19.852459] cfg80211: 2402000 KHz - 2472000 KHz @ 40000 KHz), (N/A mBi, 2000 mBm)
[   19.852461] cfg80211: Updating information on frequency 2427 MHz for a 20 MHz width channel with regulatory rule:
[   19.852464] cfg80211: 2402000 KHz - 2472000 KHz @ 40000 KHz), (N/A mBi, 2000 mBm)
[   19.852466] cfg80211: Updating information on frequency 2432 MHz for a 20 MHz width channel with regulatory rule:
[   19.852468] cfg80211: 2402000 KHz - 2472000 KHz @ 40000 KHz), (N/A mBi, 2000 mBm)
[   19.852470] cfg80211: Updating information on frequency 2437 MHz for a 20 MHz width channel with regulatory rule:
[   19.852472] cfg80211: 2402000 KHz - 2472000 KHz @ 40000 KHz), (N/A mBi, 2000 mBm)
[   19.852474] cfg80211: Updating information on frequency 2442 MHz for a 20 MHz width channel with regulatory rule:
[   19.852477] cfg80211: 2402000 KHz - 2472000 KHz @ 40000 KHz), (N/A mBi, 2000 mBm)
[   19.852479] cfg80211: Updating information on frequency 2447 MHz for a 20 MHz width channel with regulatory rule:
[   19.852481] cfg80211: 2402000 KHz - 2472000 KHz @ 40000 KHz), (N/A mBi, 2000 mBm)
[   19.852483] cfg80211: Updating information on frequency 2452 MHz for a 20 MHz width channel with regulatory rule:
[   19.852485] cfg80211: 2402000 KHz - 2472000 KHz @ 40000 KHz), (N/A mBi, 2000 mBm)
[   19.852487] cfg80211: Updating information on frequency 2457 MHz for a 20 MHz width channel with regulatory rule:
[   19.852489] cfg80211: 2402000 KHz - 2472000 KHz @ 40000 KHz), (N/A mBi, 2000 mBm)
[   19.852492] cfg80211: Updating information on frequency 2462 MHz for a 20 MHz width channel with regulatory rule:
[   19.852494] cfg80211: 2402000 KHz - 2472000 KHz @ 40000 KHz), (N/A mBi, 2000 mBm)
[   19.852496] cfg80211: Disabling freq 2467 MHz as custom regd has no rule that fits a 20 MHz wide channel
[   19.852498] cfg80211: Disabling freq 2472 MHz as custom regd has no rule that fits a 20 MHz wide channel
[   19.852500] cfg80211: Disabling freq 2484 MHz as custom regd has no rule that fits a 20 MHz wide channel
[   19.852598] cfg80211: Ignoring regulatory request Set by core since the driver uses its own custom regulatory domain
[   19.856021] ieee80211 phy0: Selected rate control algorithm 'minstrel_ht'
[   19.856520] ath5k: phy0: Atheros AR2425 chip found (MAC: 0xe2, PHY: 0x70)
[   19.882716] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   19.883438] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   21.224519] sky2 0000:02:00.0: eth0: Link is up at 100 Mbps, full duplex, flow control rx
[   21.224806] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   47.418034] audit_printk_skb: 39 callbacks suppressed
[   47.418039] type=1400 audit(1363094478.037:25): apparmor="DENIED" operation="open" parent=2136 profile="/usr/lib/telepathy/mission-control-5" name="/usr/share/gvfs/remote-volume-monitors/" pid=2137 comm="mission-control" requested_mask="r" denied_mask="r" fsuid=1000 ouid=0
[  326.323553] type=1400 audit(1363094756.942:26): apparmor="DENIED" operation="capable" parent=1 profile="/usr/sbin/cupsd" pid=680 comm="cupsd" pid=680 comm="cupsd" capability=36  capname="block_suspend"