[   26.651197] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[   26.905008] iwl3945 0000:06:00.0: loaded firmware version 15.32.2.9
[   26.973076] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   26.973500] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   28.414649] init: udev-fallback-graphics main process (1239) terminated with status 1
[   33.508251] NVRM: GPU at 0000:01:00: GPU-f2a9e1be-6b6d-71a9-d89b-51c6bbca3b8b
[   34.580658] wlan0: authenticate with 00:1d:8b:4d:64:34
[   34.581712] wlan0: capabilities/regulatory prevented using AP HT/VHT configuration, downgraded
[   34.581836] wlan0: send auth to 00:1d:8b:4d:64:34 (try 1/3)
[   34.583617] wlan0: authenticated
[   34.583771] iwl3945 0000:06:00.0 wlan0: disabling HT/VHT due to WEP/TKIP use
[   34.583776] iwl3945 0000:06:00.0 wlan0: disabling HT as WMM/QoS is not supported by the AP
[   34.583780] iwl3945 0000:06:00.0 wlan0: disabling VHT as WMM/QoS is not supported by the AP
[   34.584349] wlan0: associate with 00:1d:8b:4d:64:34 (try 1/3)
[   34.586852] wlan0: RX AssocResp from 00:1d:8b:4d:64:34 (capab=0x11 status=0 aid=1)
[   34.588367] wlan0: associated
[   34.588399] IPv6: ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[   34.588469] cfg80211: Calling CRDA for country: IT
[   34.596646] cfg80211: Regulatory domain changed to country: IT
[   34.596652] cfg80211:   (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[   34.596655] cfg80211:   (2402000 KHz - 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm)
[   34.596659] cfg80211:   (5170000 KHz - 5250000 KHz @ 40000 KHz), (N/A, 2000 mBm)
[   34.596662] cfg80211:   (5250000 KHz - 5330000 KHz @ 40000 KHz), (N/A, 2000 mBm)
[   34.596665] cfg80211:   (5490000 KHz - 5710000 KHz @ 40000 KHz), (N/A, 2700 mBm)
[   35.432647] IPv6: wlan0: IPv6 duplicate address fe80::21c:bfff:fe40:fb26 detected!