[   29.588469] input: HDA Intel MID Mic as /devices/pci0000:00/0000:00:1b.0/sound/card0/input7
[   29.588767] hda-intel 0000:02:00.1: Handle VGA-switcheroo audio client
[   29.588854] snd_hda_intel 0000:02:00.1: irq 46 for MSI/MSI-X
[   29.621378] input: HD-Audio Generic HDMI/DP,pcm=3 as /devices/pci0000:00/0000:00:01.0/0000:02:00.1/sound/card1/input8
[   29.659922] r8169 0000:20:00.0 eth0: link down
[   29.659972] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[   29.660247] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[   30.594169] psmouse serio1: synaptics: Touchpad model: 1, fw: 7.2, id: 0x1e0b1, caps: 0xd04733/0xa40000/0xa0000, board id: 3655, fw id: 609042
[   30.726024] input: SynPS/2 Synaptics TouchPad as /devices/platform/i8042/serio1/input/input9
[   37.128814] e4rat-preload: plymouth-stop pre-start process (1859) terminated with status 1
[   38.649536] e4rat-preload: tvheadend main process ended, respawning
[  102.506438] usb 2-1.3: new high-speed USB device number 3 using ehci-pci
[  102.616138] usb 2-1.3: New USB device found, idVendor=148f, idProduct=3070
[  102.616146] usb 2-1.3: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[  102.616150] usb 2-1.3: Product: 802.11 n WLAN
[  102.616154] usb 2-1.3: Manufacturer: Ralink
[  102.616158] usb 2-1.3: SerialNumber: 1.0
[  102.760428] cfg80211: Calling CRDA to update world regulatory domain
[  102.844511] cfg80211: World regulatory domain updated:
[  102.844518] cfg80211:   (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[  102.844523] cfg80211:   (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[  102.844526] cfg80211:   (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[  102.844529] cfg80211:   (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
[  102.844532] cfg80211:   (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[  102.844535] cfg80211:   (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
[  102.958230] usb 2-1.3: reset high-speed USB device number 3 using ehci-pci
[  103.142865] ieee80211 phy0: Selected rate control algorithm 'minstrel_ht'
[  103.143440] usbcore: registered new interface driver rt2800usb
[  103.507055] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[  103.507572] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[  106.681800] wlan0: authenticate with 34:08:04:73:86:d6
[  106.743381] wlan0: send auth to 34:08:04:73:86:d6 (try 1/3)
[  106.755058] wlan0: authenticated
[  106.755884] wlan0: associate with 34:08:04:73:86:d6 (try 1/3)
[  106.760680] wlan0: RX AssocResp from 34:08:04:73:86:d6 (capab=0x531 status=0 aid=1)
[  106.768693] wlan0: associated
[  106.768766] IPv6: ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[  106.768894] cfg80211: Calling CRDA for country: GB
[  106.774761] cfg80211: Regulatory domain changed to country: GB
[  106.774768] cfg80211:   (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[  106.774773] cfg80211:   (2402000 KHz - 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm)
[  106.774777] cfg80211:   (5170000 KHz - 5250000 KHz @ 40000 KHz), (N/A, 2000 mBm)
[  106.774781] cfg80211:   (5250000 KHz - 5330000 KHz @ 40000 KHz), (N/A, 2000 mBm)
[  106.774785] cfg80211:   (5490000 KHz - 5710000 KHz @ 40000 KHz), (N/A, 2700 mBm)
[  106.855924] wlan0: Limiting TX power to 20 (20 - 0) dBm as advertised by 34:08:04:73:86:d6
[  762.655749] usb 2-1.1: new high-speed USB device number 4 using ehci-pci
[  762.748890] usb 2-1.1: New USB device found, idVendor=2040, idProduct=c000
[  762.748898] usb 2-1.1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[  762.748903] usb 2-1.1: Product: WinTV MiniStick
[  762.748906] usb 2-1.1: Manufacturer: Hauppauge Computer Works
[  762.748910] usb 2-1.1: SerialNumber: 4034181674
[  763.399124] smscore_set_device_mode: firmware download success: sms1xxx-hcw-55xxx-dvbt-02.fw
[  763.402504] sms_ir_init: Allocating rc device
[  763.402514] sms_ir_init: IR port 0, timeout 100 ms
[  763.402517] sms_ir_init: Input device (IR) SMS IR (Hauppauge WinTV MiniStick) is set for key events
[  763.455057] Registered IR keymap rc-hauppauge
[  763.455230] input: SMS IR (Hauppauge WinTV MiniStick) as /devices/pci0000:00/0000:00:1d.0/usb2/2-1/2-1.1/rc/rc0/input10
[  763.455367] rc0: SMS IR (Hauppauge WinTV MiniStick) as /devices/pci0000:00/0000:00:1d.0/usb2/2-1/2-1.1/rc/rc0
[  763.468115] IR NEC protocol handler initialized
[  763.479654] IR RC5(x) protocol handler initialized
[  763.487780] IR RC6 protocol handler initialized
[  763.487816] DVB: registering new adapter (Hauppauge WinTV MiniStick)
[  763.488094] usb 2-1.1: DVB: registering adapter 0 frontend 0 (Siano Mobile Digital MDTV Receiver)...
[  763.491447] usbcore: registered new interface driver smsusb
[  763.497098] IR JVC protocol handler initialized
[  763.504107] IR Sony protocol handler initialized
[  763.510180] IR SANYO protocol handler initialized
[  763.516298] input: MCE IR Keyboard/Mouse (smsmdtv) as /devices/virtual/input/input11
[  763.516450] IR MCE Keyboard/mouse protocol handler initialized
[  763.525347] lirc_dev: IR Remote Control driver registered, major 250 
[  763.530779] rc rc0: lirc_dev: driver ir-lirc-codec (smsmdtv) registered at minor = 0
[  763.530785] IR LIRC bridge handler initialized