[   24.162731] input: Wacom Serial Penabled 2FG Touchscreen as /devices/pnp0/00:0b/tty/ttyS4/serio2/input/input13
[   24.184364] e1000e 0000:00:19.0: irq 41 for MSI/MSI-X
[   24.184721] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[   24.185300] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[   24.187555] iwlwifi 0000:02:00.0: L1 Enabled; Disabling L0S
[   24.187749] iwlwifi 0000:02:00.0: Radio type=0x0-0x3-0x1
[   24.427979] iwlwifi 0000:02:00.0: L1 Enabled; Disabling L0S
[   24.428185] iwlwifi 0000:02:00.0: Radio type=0x0-0x3-0x1
[   24.543643] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   24.544154] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   24.616262] vboxdrv: Found 4 processor cores.
[   24.616422] vboxdrv: fAsync=0 offMin=0xe7 offMax=0x15da
[   24.616496] vboxdrv: TSC mode is 'synchronous', kernel timer mode is 'normal'.
[   24.616498] vboxdrv: Successfully loaded version 4.1.18_Ubuntu (interface 0x00190000).
[   24.624913] vboxpci: IOMMU not found (not registered)
[   24.849367] init: anacron main process (1169) killed by TERM signal
[   25.301144] init: plymouth-stop pre-start process (1616) terminated with status 1
[   32.098453] psmouse serio3: trackpoint: IBM TrackPoint firmware: 0x0e, buttons: 3/3
[   32.393353] input: TPPS/2 IBM TrackPoint as /devices/platform/i8042/serio1/serio3/input/input14
[   55.092067] usb 2-1.2: new high-speed USB device number 3 using ehci_hcd
[   55.185491] usb 2-1.2: New USB device found, idVendor=0781, idProduct=5530
[   55.185499] usb 2-1.2: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[   55.185504] usb 2-1.2: Product: Cruzer
[   55.185508] usb 2-1.2: Manufacturer: SanDisk
[   55.185511] usb 2-1.2: SerialNumber: 20051737810EB34123CD
[   55.267660] usbcore: registered new interface driver uas
[   55.284863] Initializing USB Mass Storage driver...
[   55.284990] scsi6 : usb-storage 2-1.2:1.0
[   55.285062] usbcore: registered new interface driver usb-storage
[   55.285063] USB Mass Storage support registered.
[   56.285193] scsi 6:0:0:0: Direct-Access     SanDisk  Cruzer           1.26 PQ: 0 ANSI: 5
[   56.286757] sd 6:0:0:0: Attached scsi generic sg1 type 0
[   56.287971] sd 6:0:0:0: [sdb] 31266816 512-byte logical blocks: (16.0 GB/14.9 GiB)
[   56.289394] sd 6:0:0:0: [sdb] Write Protect is off
[   56.289401] sd 6:0:0:0: [sdb] Mode Sense: 43 00 00 00
[   56.290249] sd 6:0:0:0: [sdb] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
[   56.300149]  sdb: sdb1
[   56.303547] sd 6:0:0:0: [sdb] Attached SCSI removable disk
[   66.803191] usb 1-1.2: new high-speed USB device number 5 using ehci_hcd
[   66.896811] usb 1-1.2: New USB device found, idVendor=059f, idProduct=1021
[   66.896817] usb 1-1.2: New USB device strings: Mfr=10, Product=11, SerialNumber=3
[   66.896822] usb 1-1.2: Product: little disk
[   66.896826] usb 1-1.2: Manufacturer: LaCie
[   66.896829] usb 1-1.2: SerialNumber: 00E00123C3B5A
[   66.897999] scsi7 : usb-storage 1-1.2:1.0
[   67.937525] scsi 7:0:0:0: Direct-Access     SAMSUNG  HM500JI               PQ: 0 ANSI: 2 CCS
[   67.938406] sd 7:0:0:0: Attached scsi generic sg2 type 0
[   67.939413] sd 7:0:0:0: [sdc] 976773168 512-byte logical blocks: (500 GB/465 GiB)
[   67.940970] sd 7:0:0:0: [sdc] Write Protect is off
[   67.940974] sd 7:0:0:0: [sdc] Mode Sense: 34 00 00 00
[   67.941675] sd 7:0:0:0: [sdc] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA
[   67.972760]  sdc: sdc1 sdc2
[   67.976061] sd 7:0:0:0: [sdc] Attached SCSI disk
[   81.249999] wlan0: authenticate with 00:0f:cc:db:c1:a4
[   81.309037] wlan0: send auth to 00:0f:cc:db:c1:a4 (try 1/3)
[   81.311455] wlan0: authenticated
[   81.313290] wlan0: associate with 00:0f:cc:db:c1:a4 (try 1/3)
[   81.316381] wlan0: RX AssocResp from 00:0f:cc:db:c1:a4 (capab=0x451 status=0 aid=2)
[   81.322458] wlan0: associated
[   81.322677] IPv6: ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[  144.813479] hfs: unable to find HFS+ superblock
[  149.366831] hfs: write access to a journaled filesystem is not supported, use the force option at your own risk, mounting read-only.
[  823.742469] show_signal_msg: 24 callbacks suppressed
[  823.742474] nepomukservices[2743]: segfault at 4 ip b759d1f4 sp bf9b018c error 4 in libQtCore.so.4.8.2[b74a5000+2d6000]
[  841.057321] nepomukservices[3245]: segfault at 4 ip b753d1f4 sp bfe8020c error 4 in libQtCore.so.4.8.2[b7445000+2d6000]
[  845.516086] nepomukservices[3257]: segfault at 4 ip b75701f4 sp bfd1acfc error 4 in libQtCore.so.4.8.2[b7478000+2d6000]
[  850.977891] nepomukservices[3268]: segfault at 4 ip b74f81f4 sp bf907b3c error 4 in libQtCore.so.4.8.2[b7400000+2d6000]
[  854.865448] nepomukservices[3280]: segfault at 4 ip b75b31f4 sp bfbd6ecc error 4 in libQtCore.so.4.8.2[b74bb000+2d6000]
[  858.982983] nepomukservices[3290]: segfault at 4 ip b751e1f4 sp bfd4efcc error 4 in libQtCore.so.4.8.2[b7426000+2d6000]