[ 17.305565] EXT4-fs (sda2): re-mounted. Opts: errors=remount-ro,commit=600 [ 17.689066] init: plymouth-stop pre-start process (2422) terminated with status 1 [ 19.350800] acer_wmi: Unknown function number - 2 - 100 [ 20.941555] xhci_hcd 0000:00:14.0: PME# enabled [ 22.982687] ehci_hcd 0000:00:1d.0: PCI INT A disabled [ 22.982727] ehci_hcd 0000:00:1d.0: PME# enabled [ 25.000069] ehci_hcd 0000:00:1a.0: PCI INT A disabled [ 25.000110] ehci_hcd 0000:00:1a.0: PME# enabled [ 43.303425] EXT4-fs (sda2): re-mounted. Opts: errors=remount-ro,commit=0 [ 43.339008] NMI watchdog enabled, takes one hw-pmu counter. [ 43.339125] NMI watchdog enabled, takes one hw-pmu counter. [ 43.339228] NMI watchdog enabled, takes one hw-pmu counter. [ 43.339294] NMI watchdog enabled, takes one hw-pmu counter. [ 43.448332] ehci_hcd 0000:00:1a.0: BAR 0: set to [mem 0xc0719000-0xc07193ff] (PCI address [0xc0719000-0xc07193ff]) [ 43.448374] ehci_hcd 0000:00:1a.0: restoring config space at offset 0xf (was 0x100, writing 0x107) [ 43.448415] ehci_hcd 0000:00:1a.0: restoring config space at offset 0x1 (was 0x2900000, writing 0x2900002) [ 43.448531] ehci_hcd 0000:00:1a.0: PME# disabled [ 43.448551] ehci_hcd 0000:00:1a.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16 [ 43.448565] ehci_hcd 0000:00:1a.0: setting latency timer to 64 [ 43.715930] ehci_hcd 0000:00:1d.0: BAR 0: set to [mem 0xc0718000-0xc07183ff] (PCI address [0xc0718000-0xc07183ff]) [ 43.715969] ehci_hcd 0000:00:1d.0: restoring config space at offset 0xf (was 0x100, writing 0x107) [ 43.716011] ehci_hcd 0000:00:1d.0: restoring config space at offset 0x1 (was 0x2900000, writing 0x2900002) [ 43.716131] ehci_hcd 0000:00:1d.0: PME# disabled [ 43.716153] ehci_hcd 0000:00:1d.0: PCI INT A -> GSI 23 (level, low) -> IRQ 23 [ 43.716167] ehci_hcd 0000:00:1d.0: setting latency timer to 64 [ 43.815926] xhci_hcd 0000:00:14.0: PME# disabled [ 43.815954] xhci_hcd 0000:00:14.0: setting latency timer to 64 [ 45.060229] psmouse serio2: TouchPad at isa0060/serio2/input0 - driver resynced. [ 48.691986] psmouse serio2: TouchPad at isa0060/serio2/input0 lost sync at byte 1 [ 51.010418] eth2: no IPv6 routers present [ 199.609604] pci 0000:04:00.0: vpd r/w failed. This is likely a firmware bug on this device. Contact the card vendor for a firmware update.