[  120.106595] ndiswrapper: using IRQ 20
[  120.220414] wlan0: ethernet device 00:09:f3:70:21:f5 using serialized NDIS driver: rt2500, version: 0x20001, NDIS version: 0x500, vendor: 'IEEE 802.11g Wireless Card.', 1814:0201.5.conf
[  120.221682] wlan0: encryption modes supported: WEP; TKIP with WPA, WPA2, WPA2PSK; AES/CCMP with WPA, WPA2, WPA2PSK
[  120.222488] usbcore: registered new interface driver ndiswrapper
[  127.270522] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[  140.630155] wlan0: no IPv6 routers present
[  370.636441] ndiswrapper: device wlan0 removed
[  370.636456] ACPI: PCI interrupt for device 0000:05:06.0 disabled
[  370.636512] usbcore: deregistering interface driver ndiswrapper
[  373.107190] ACPI: PCI Interrupt 0000:05:06.0[A] -> Link [APC1] -> GSI 16 (level, low) -> IRQ 20
[  373.114671] phy0: Selected rate control algorithm 'pid'
[  373.141687] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[  389.255609] ACPI: PCI interrupt for device 0000:05:06.0 disabled
[  431.033647] ACPI: PCI Interrupt 0000:05:06.0[A] -> Link [APC1] -> GSI 16 (level, low) -> IRQ 20
[  431.040341] phy0: Selected rate control algorithm 'pid'
[  431.065014] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[  476.370723] ACPI: PCI interrupt for device 0000:05:06.0 disabled
[  503.496878] ACPI: PCI Interrupt 0000:05:06.0[A] -> Link [APC1] -> GSI 16 (level, low) -> IRQ 20
[  503.502752] phy0: Selected rate control algorithm 'pid'
[  503.528636] ADDRCONF(NETDEV_UP): wlan0: link is not ready