acx: this driver is still EXPERIMENTAL
acx: reading README file and/or Craig's HOWTO is recommended, visit http://acx100.sf.net in case of further questions/discussion
acx: compiled to use 32bit I/O access. I/O timing issues might occur, such as non-working firmware upload. Report them
running on a little-endian CPU
PCI module v0.3.36 initialized, waiting for cards to probe...
acx: found ACX111-based wireless network card at 0000:00:11.0, irq:11, phymem1:0xFFBEE000, phymem2:0xFFBA0000, mem1:0xe097c000, mem1_size:8192, mem2:0xe0b40000, mem2_size:131072
initial debug setting is 0x000A
using IRQ 11
acx: need to load firmware for acx111 chipset with radio ID 16, please provide via firmware hotplug:
acx: either one file only (<c>ombined firmware image file, radio-specific) or two files (radio-less base image file *plus* separate <r>adio-specific extension file)
requesting firmware image 'tiacx111c16'
acx_write_fw (main/combined): 0
acx_validate_fw (main/combined): 0
initializing max packet templates
dump queue head (from card):
len: 24
tx_memory_block_address: 19E40
rx_memory_block_address: 15240
tx1_queue address: 14774
rx1_queue address: 14434
NVS_vendor_offs:01CD probe_delay:200 eof_memory:1114112
CCAModes:04 Diversity:01 ShortPreOpt:01 PBCC:01 ChanAgil:00 PHY:05 Temp:01
AntennaID:00 Len:02 Data:01 02 
PowerLevelID:01 Len:02 Data:001E 000A 
DataRatesID:02 Len:05 Data:02 04 11 22 44 
DomainID:03 Len:06 Data:30 20 30 31 32 40 
ProductID:04 Len:09 Data:TI ACX100
ManufacturerID:05 Len:07 Data:TI Test
get_mask 0x00004182, set_mask 0x00000000
don't know how to get sensitivity for radio type 0x16
got sensitivity value 0
got antenna value 0x4A
got regulatory domain 0x30
get_mask 0x00000000, set_mask 0x00000000 - after update
new ratevector: 82 84 0B 0C 12 16 18 24 2C 30 48 60 6C
setting RXconfig to 2010:0FDD
acx: === chipset TNETW1130, radio type 0x16 (Radia), form factor 0x01 ((mini-)PCI / CardBus), EEPROM version 0x05: uploaded firmware 'Rev 2.3.1.31' ===
creating /proc entry driver/acx_wlan0
creating /proc entry driver/acx_wlan0_diag
creating /proc entry driver/acx_wlan0_eeprom
creating /proc entry driver/acx_wlan0_phy
acx v0.3.36: net device wlan0, driver compiled against wireless extensions 22 and Linux 2.6.22.1-46.fc7