[   36.590934] [fglrx] AGP detected, AgpState   = 0x1f000a1b (hardware caps of chipset)
[   36.590940] [fglrx] [agp] enabling AGP with mode=0x1f000b1a
[   36.590944] agpgart-amd64 0000:00:00.0: AGP 3.0 bridge
[   36.590964] agpgart-amd64 0000:00:00.0: putting AGP V3 device into 8x mode
[   36.591043] fglrx_pci 0000:01:00.0: putting AGP V3 device into 8x mode
[   36.591050] [fglrx] AGP enabled,  AgpCommand = 0x1f000312 (selected caps)
[   36.885882] [fglrx] Setup AGP aperture
[   36.898729] [fglrx] Firegl kernel thread PID: 3243
[   36.952928] [fglrx] Gart cacheable size:863 M.
[   36.952937] [fglrx] Reserved FB block: Shared offset:0, size:1000000 
[   36.952939] [fglrx] Reserved FB block: Unshared offset:fe0e000, size:1f2000 
[   36.952942] [fglrx] Reserved FB block: Unshared offset:1fffc000, size:4000 
[   39.224245] skge eth0: enabling interface
[   39.227824] ADDRCONF(NETDEV_UP): eth0: link is not ready
[   40.911087] skge eth0: Link is up at 100 Mbps, full duplex, flow control both
[   40.911533] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   51.324010] eth0: no IPv6 routers present
[   99.496062] Clocksource tsc unstable (delta = -249860268 ns)
[  119.420148] bttv0: unloading
[  119.420212] tda9887 1-0043: destroying instance
[  127.569779] bttv: driver version 0.9.17 loaded
[  127.569785] bttv: using 8 buffers with 2080k (520 pages) each for capture
[  127.569854] bttv: Bt8xx card found (0).
[  127.569871] bttv0: Bt878 (rev 17) at 0000:00:0e.0, irq: 19, latency: 64, mmio: 0xdfe00000
[  127.569952] bttv0: detected: Pinnacle PCTV [card=39], PCI subsystem ID is 11bd:0012
[  127.569958] bttv0: using: Pinnacle PCTV Studio/Rave [card=39,autodetected]
[  127.570012] bttv0: gpio: en=00000000, out=00000000 in=00ffffff [init]
[  127.572829] tuner' 1-0043: chip found @ 0x86 (bt878 #0 [sw])
[  127.576558] tda9887 1-0043: creating new instance
[  127.576564] tda9887 1-0043: tda988[5/6/7] found
[  127.579279] Chip ID is not zero. It is not a TEA5767
[  127.579434] tuner' 1-0060: chip found @ 0xc0 (bt878 #0 [sw])
[  127.589450] bttv0: i2c: checking for MSP34xx @ 0x80... not found
[  127.589952] bttv0: pinnacle/mt: id=1 info="PAL / mono" radio=no
[  127.589956] bttv0: tuner type=33
[  127.592714] mt20xx 1-0060: microtune: companycode=3cbf part=42 rev=22
[  127.597407] mt20xx 1-0060: microtune MT2050 found, OK
[  127.598955] bttv0: i2c: checking for MSP34xx @ 0x80... not found
[  127.599454] bttv0: i2c: checking for TDA9875 @ 0xb0... not found
[  127.600912] bttv0: i2c: checking for TDA7432 @ 0x8a... not found
[  127.606038] bttv0: registered device video0
[  127.606089] bttv0: registered device vbi0
[  127.606112] bttv0: PLL: 28636363 => 35468950 . ok
[  127.667731] bt878: AUDIO driver version 0.0.0 loaded
[12662.687526] usb 1-1: USB disconnect, address 2
[12662.687532] usb 1-1.1: USB disconnect, address 3
[12662.687536] usb 1-1.1.1: USB disconnect, address 4
[46029.700021] usb 1-1: new high speed USB device using ehci_hcd and address 5
[46029.862637] usb 1-1: configuration #1 chosen from 1 choice
[46029.862797] hub 1-1:1.0: USB hub found
[46029.862837] hub 1-1:1.0: 2 ports detected
[46030.132109] usb 1-1.1: new high speed USB device using ehci_hcd and address 6
[46030.242010] usb 1-1.1: configuration #1 chosen from 1 choice
[46030.242163] hub 1-1.1:1.0: USB hub found
[46030.242200] hub 1-1.1:1.0: 4 ports detected
[46030.512093] usb 1-1.1.1: new high speed USB device using ehci_hcd and address 7
[46030.709857] usb 1-1.1.1: configuration #1 chosen from 1 choice
[46030.740037] scsi5 : SCSI emulation for USB Mass Storage devices
[46030.742361] usb-storage: device found at 7
[46030.742366] usb-storage: waiting for device to settle before scanning
[46035.746060] usb-storage: device scan complete
[46035.750403] scsi 5:0:0:0: Direct-Access     Generic  Flash HS-CF      5.39 PQ: 0 ANSI: 0
[46035.753513] scsi 5:0:0:1: Direct-Access     Generic  Flash HS-COMBO   5.39 PQ: 0 ANSI: 0
[46035.788663] sd 5:0:0:0: [sdd] Attached SCSI removable disk
[46035.788737] sd 5:0:0:0: Attached scsi generic sg4 type 0
[46035.793788] sd 5:0:0:1: [sde] Attached SCSI removable disk
[46035.793867] sd 5:0:0:1: Attached scsi generic sg5 type 0
[62873.209463] usb 1-1: USB disconnect, address 5
[62873.209469] usb 1-1.1: USB disconnect, address 6
[62873.209473] usb 1-1.1.1: USB disconnect, address 7
[77127.332020] usb 1-1: new high speed USB device using ehci_hcd and address 8
[77127.467349] usb 1-1: configuration #1 chosen from 1 choice
[77127.467509] hub 1-1:1.0: USB hub found
[77127.467557] hub 1-1:1.0: 2 ports detected
[77127.740078] usb 1-1.1: new high speed USB device using ehci_hcd and address 9
[77127.869691] usb 1-1.1: configuration #1 chosen from 1 choice
[77127.869891] hub 1-1.1:1.0: USB hub found
[77127.870045] hub 1-1.1:1.0: 4 ports detected
[77128.140188] usb 1-1.1.1: new high speed USB device using ehci_hcd and address 10
[77128.352121] usb 1-1.1.1: configuration #1 chosen from 1 choice
[77128.412065] scsi6 : SCSI emulation for USB Mass Storage devices
[77128.414321] usb-storage: device found at 10
[77128.414326] usb-storage: waiting for device to settle before scanning
[77133.418276] usb-storage: device scan complete
[77133.422375] scsi 6:0:0:0: Direct-Access     Generic  Flash HS-CF      5.39 PQ: 0 ANSI: 0
[77133.425735] scsi 6:0:0:1: Direct-Access     Generic  Flash HS-COMBO   5.39 PQ: 0 ANSI: 0
[77133.463128] sd 6:0:0:0: [sdd] Attached SCSI removable disk
[77133.463199] sd 6:0:0:0: Attached scsi generic sg4 type 0
[77133.467412] sd 6:0:0:1: [sde] Attached SCSI removable disk
[77133.467485] sd 6:0:0:1: Attached scsi generic sg5 type 0