| 2022-05-24 14:29:59 |
Juerg Haefliger |
bug |
|
|
added bug |
| 2022-05-24 14:30:00 |
Juerg Haefliger |
linux-raspi (Ubuntu): status |
New |
Confirmed |
|
| 2022-05-24 14:30:03 |
Juerg Haefliger |
nominated for series |
|
Ubuntu Jammy |
|
| 2022-05-24 14:30:04 |
Juerg Haefliger |
bug task added |
|
linux-raspi (Ubuntu Jammy) |
|
| 2022-05-24 14:34:13 |
Juerg Haefliger |
description |
Upstream raspberrypi patchset 2022-05-24
Ported from the following raspberrypi branch:
rpi-5.15.y
from https://github.com/raspberrypi/linux.git
|
Upstream raspberrypi patchset 2022-05-24
Ported from the following raspberrypi branch:
rpi-5.15.y
from https://github.com/raspberrypi/linux.git
overlays: add RV8803 RTC overlay to the generic ARM RTC device tree
configs: add RV8803 RTC module to Raspberry Pi board defconfigs
media: imx296: Add the link frequency control
media: imx296: Set gain delay to 1 frame
media: imx296: Adjust exposure limits on vblank changes
media: imx296: Add horizontal and vertical flips support
media: imx296: Only advertise the full resolution mode
media: imx296: Add standby and stream on/off delays
media: imx296: Fix Bayer order
configs: Enable the IMX296 device module in platform defconfig
overlays: Add imx296 overlay
media: i2c: IMX296 camera sensor driver
dt-bindings: media: i2c: Add IMX296 CMOS sensor binding
drm/vc4: Move pixel doubling from Pixelvalve to HDMI block
drm/vc4: Correct HDMI timing registers for interlaced modes
drm/vc4: Add MISC_CONTROL register for vc4.
drm/vc4: Add HDMI format detection registers to register list
vc04_services: bcm2835-codec: Add support for V4L2_PIX_FMT_NV12_COL128
vc04_services: vchiq-mmal: Add defines for mmal_es_format flags
configs: Regenerate defconfigs
mmc: block: Don't do single-sector reads during recovery
overlays: Add gpio-hog overlay
drm/atomic: If margins are updated, update all planes.
drm/vc4_hdmi: Force a modeset when Broadcast RGB setting changes
dtoverlays: Fix incorrect property name for display rotation
drm/vc4: Warn if some v3d code is run on BCM2711
drm/vc4: crtc: Don't call into BO Handling on Async Page-Flips on BCM2711
drm/vc4: crtc: Move the BO Handling out of Common Page-Flip Handler
drm/vc4: crtc: Move the BO handling out of common page-flip callback
drm/vc4: crtc: Use an union to store the page flip callback
drm/vc4: drv: Skip BO Backend Initialization on BCM2711
drm/vc4: plane: Register a different drm_plane_helper_funcs on BCM2711
drm/vc4: kms: Register a different drm_mode_config_funcs on BCM2711
drm/vc4: drv: Register a different driver on BCM2711
drm/vc4: bo: Split out Dumb buffers fixup
drm/vc4: bo: Rename vc4_dumb_create
drm/vc4: Consolidate Hardware Revision Check
drm/vc4: plane: Prevent async update if we don't have a dlist
clk: Add locking to clk_get_rate_range
overlays: Remove other leading zeroes from node addresses
SQUASH: overlays: arducam-pivariety: Strip leading zero
dtoverlays: Add i2c-fan overlay
configs: Enable the EMC2305 fan controller driver
docs: hwmon: add emc2305.rst to docs
hwmon: emc2305: fixups for driver submitted to mailing lists
hwmon: (emc2305) add support for EMC2301/2/3/5 RPM-based PWM Fan Speed Controller.
dtbindings: Fixup microchip,emc2305.yaml bindings
dt-bindings: hwmon: add microchip,emc2305.yaml dt binding description.
thermal: broadcom: Use dev_err_probe to suppress defer errors
overlays: Add arducam-pivariety-overlay.dts
configs: Add CONFIG_VIDEO_ARDUCAM_PIVARIETY=m
media: i2c: Add driver of Arducam Pivariety series camera
media: dt-bindings: media: i2c: Add Arducam Pivariety Series CMOS sensor binding
dt-bindings: vendor-prefixes: Add Arducam
configs: Restore settings lost since 5.10
configs: Enable DM_WRITECACHE module on BCM2711
configs: Add CONFIG_EEPROM_AT25=m
staging: vchiq_arm: Add log_level module params
config: Update bcmrpi3_defconfig
Revert "fbdev: Hot-unplug firmware fb devices on forced removal"
Revert "fbdev: Fix unregistering of framebuffers without device"
drm/vc4_kms: Protect hvs dereference on fkms
ARM: dts: bcm2835: Switch HSM clock to firmware
overlays: Fix pitft28/35-resistive rotate params
ARM: dts: Add i2c0mux node to Model B rev 1
overlays: Add "drm" parameter to pitft28-resistive
tpm_tis_spi_main: Force probe routine to run synchronously with driver and device registration when IMA is enabled
clk-bcm2835: use subsys_initcall for the clock driver when IMA is enabled
rpivid: Use clk_get_max_rate()
drm/vc4: kms: Use maximum FIFO load for the HVS clock rate
drm/vc4: Make sure we don't end up with a core clock too high
drm/vc4: kms: Warn if clk_set_min_rate fails
drm/vc4: hdmi: Rework hdmi_enable_4kp60 detection
clk: tests: Add missing test case for ranges
clk: tests: Add some tests for clk_get_rate_range()
clk: Add clk_get_rate_range
Revert "clk: Introduce a clock request API"
Revert "clk: requests: Ignore if the pointer is null"
Revert "clk: requests: Dereference the request pointer after the check"
Revert "rpivid: Switch to new clock api"
Revert "bcm2835-unicam: Switch to new clock api"
Revert "drm/vc4: hdmi: Convert to the new clock request API"
Revert "drm/vc4: Increase the core clock based on HVS load"
Revert "drm/vc4: kms: Move clock request to our HVS state"
clk: bcm: rpi: Run some clocks at the minimum rate allowed
clk: bcm: rpi: Set a default minimum rate
clk: bcm: rpi: Add variant structure
clk: Test the clock pointer in clk_hw_get_name()
clk: Zero the clk_rate_request structure
clk: Stop forwarding clk_rate_requests to the parent
clk: Introduce clk_core_has_parent()
clk: Switch from __clk_determine_rate to clk_core_round_rate_nolock
clk: Remove redundant clk_core_init_rate_req() call
clk: Add missing clk_core_init_rate_req calls
clk: Introduce clk_hw_init_rate_request()
clk: Change clk_core_init_rate_req prototype
clk: Add our request boundaries in clk_core_init_rate_req
clk: Skip set_rate_range if our clock is orphan
clk: Set req_rate on reparenting
clk: Fix clk_get_parent() documentation
clk: Take into account uncached clocks in clk_set_rate_range()
clk: tests: Add some tests for orphan with multiple parents
clk: tests: Add tests for mux with multiple parents
clk: tests: Add tests for single parent mux
clk: tests: Add tests for uncached clock
clk: tests: Add reference to the orphan mux bug report
clk: tests: Add test suites description
clk: Drop the rate range on clk_put()
clk: test: Test clk_set_rate_range on orphan mux
clk: Add clk_drop_range
clk: Always set the rate on clk_set_range_rate
clk: Use clamp instead of open-coding our own
clk: Always clamp the rounded rate
clk: Introduce Kunit Tests for the framework
config: Enable the NFT_SYNPROXY module
configs: (Re)Enable CONFIG_IR_TOY
overlays: mipi-dbi-spi: width-mm and height-mm are mandatory
config: Enable CONFIG_MODULE_COMPRESS_XZ
configs: bcm2711_defconfig: Enable KASLR
vc4_hdmi: Remove VC4_HDMI_SCHEDULER_CONTROL_VERT_ALWAYS_KEEPOUT
Add support for the AudioInjector.net bare i2s sound card
dtoverlays: Add overlay for Sony IMX258 image sensor
defconfigs: Add IMX258 to the Pi defconfigs
media: i2c: imx258: Support faster pixel rate on binned modes
media: i2c: imx258: Set pixel_rate range to the same as the value
media: i2c: imx258: Issue reset before starting streaming
media: i2c: imx258: Add support for long exposure modes
media: i2c: imx258: Correct max FRM_LENGTH_LINES value
media: i2c: imx258: Allow configuration of clock lane behaviour
media: i2c: imx258: Add get_selection for pixel array information
media: i2c: imx258: Follow normal V4L2 behaviours for clipping exposure
media: i2c: imx258: Add support for running on 2 CSI data lanes
media: i2c: imx258: Add support for 24MHz clock
media: i2c: imx258: Register the ctrls from fwnode properties
media: i2c: imx258: Make V4L2_CID_VBLANK configurable.
media: i2c: imx258: Add regulator control
media: i2c: imx258: Remove redundant I2C writes.
media: i2c: imx258: Implement HFLIP and VFLIP controls.
media: i2c: imx258: Disable digital cropping on binned modes
media: i2c: imx258: Make image geometry meet sensor requirements
media: i2c: imx258: Remove unused defines
drm/vc4_hdmi: Force modeset when bpc changes
Revert "drm/vc4: hvs: Defer dlist slots deallocation"
drm/atomic-helpers: remove legacy_cursor_update hacks |
|
| 2022-05-24 14:34:30 |
Juerg Haefliger |
linux-raspi (Ubuntu Jammy): status |
New |
In Progress |
|
| 2022-05-24 14:34:33 |
Juerg Haefliger |
linux-raspi (Ubuntu Jammy): assignee |
|
Juerg Haefliger (juergh) |
|
| 2022-05-25 05:39:57 |
Juerg Haefliger |
tags |
|
kern-3384 |
|
| 2022-06-15 07:44:15 |
Stefan Bader |
linux-raspi (Ubuntu Jammy): importance |
Undecided |
Medium |
|
| 2022-06-15 07:44:23 |
Stefan Bader |
linux-raspi (Ubuntu): status |
Confirmed |
Invalid |
|
| 2022-06-22 11:40:57 |
Juerg Haefliger |
linux-raspi (Ubuntu Jammy): status |
In Progress |
Fix Committed |
|
| 2022-06-29 01:14:11 |
Ubuntu Kernel Bot |
tags |
kern-3384 |
kern-3384 verification-needed-jammy |
|
| 2022-06-29 05:32:54 |
Juerg Haefliger |
tags |
kern-3384 verification-needed-jammy |
kern-3384 verification-done-jammy |
|
| 2022-07-18 09:13:14 |
Launchpad Janitor |
linux-raspi (Ubuntu Jammy): status |
Fix Committed |
Fix Released |
|
| 2022-07-18 09:13:14 |
Launchpad Janitor |
cve linked |
|
2022-1789 |
|
| 2022-07-18 09:13:14 |
Launchpad Janitor |
cve linked |
|
2022-21123 |
|
| 2022-07-18 09:13:14 |
Launchpad Janitor |
cve linked |
|
2022-21125 |
|
| 2022-07-18 09:13:14 |
Launchpad Janitor |
cve linked |
|
2022-21166 |
|
| 2022-08-31 14:15:20 |
Launchpad Janitor |
linux-raspi (Ubuntu): status |
Invalid |
Fix Released |
|
