impish/linux-raspi: Update to upstream raspberrypi rpi-5.13.y (2021-08-27)
Affects | Status | Importance | Assigned to | Milestone | |
---|---|---|---|---|---|
linux-raspi (Ubuntu) |
Fix Released
|
Undecided
|
Juerg Haefliger | ||
Impish |
Fix Released
|
Undecided
|
Juerg Haefliger |
Bug Description
Upstream raspberrypi patchset 2021-08-27
Ported from the following raspberrypi branch:
rpi-5.13.y
from https:/
ALSA: usb-audio: Add registration quirk for JBL Quantum 600
ALSA: usb-audio: Add registration quirk for JBL Quantum headsets
ASoC: soc-core: Fix the error return code in snd_soc_
Fixes an onboard clock detection problem of the PRO versions
spi: Avoid undefined behaviour when counting unused native CSs
spi: Allow to have all native CSs in use along with GPIOs
spi: Make of_register_
brcmfmac: Delete second brcm folder hierarchy
brcmfmac: Fix a double-free in brcmf_sdio_
net: phy: broadcom: re-add check for PHY_BRCM_
net: bcmgenet: check return value after calling platform_
net: bcmgenet: Ensure all TX/RX queues DMAs are disabled
net: bcmgenet: ensure EXT_ENERGY_DET_MASK is clear
net: bcmgenet: Fix attaching to PYH failed on RPi 4B
mmc: sdhci: Fix warning message when accessing RPMB in HS400 mode
mmc: core: clear flags before allowing to retune
mmc: block: Disable CMDQ on the ioctl path
drm/vc4: FKMS: Change of Broadcast RGB mode needs a mode change
drm/panel: raspberrypi-
drm/vc4: fix argument ordering in vc4_crtc_
drm/msm/disp/dpu1: avoid perf update in frame done event
overlays: ghost-amp: Change early-disable sequence
overlays: Add ssd1331-spi support for OLED screen
ARM: dts: bcm2711: Tune DMA parameters for HDMI audio
ARM: dts: bcm283x: Fix up GPIO LED node names
media: hevc: Fix dependent slice segment flags
drm/vc4: Set a default HSM rate
drm/vc4: hdmi: Remove the DDC probing for status detection
drm/vc4: hdmi: Actually check for the connector status in hotplug
drm/probe-helper: Create a HPD IRQ event helper for a single connector
overlays: qca7000: Fix URL & README
Makefiles: dt: Always set '-@' on ARCH_BCM2835
overlays: rpi-poe-plus: Improve the cooling levels
overlays: Add TI BQ32000 RTC support
overlays: Add midi-uart{
Revert "overlays: Update display GPIO declarations" for Goodix
overlays: Reduce Pi 4 vc4 CMA size to 320MB
media: i2c: ov7251: Add fwnode properties controls
media: i2c: ov9281: Add fwnode properties controls
media: i2c: imx290: Add fwnode properties controls
dtoverlays: Add orientation (and rotation) parameter to sensor overlays
overlays: Add Ablic S35390A to i2c-rtc and -gpio
configs: NOP_USB_XCEIV=y and USB_GADGET=y
configs: Add RANDOM_
char: vc_mem: Delete dead code
ARM: dts: Adapt to upstream changes
configs: Add SND_BCM2708_
ASoC: bcm: Add chipdip-dac driver
overlays: Update and rename chipdip-
ARM: dts: Correct CM4 PHY MDIO address
overlays: Set CMA to 512MB on Pi 4 for vc4
brcmfmac: Try product-specific clm_blob names first
configs: Add CONFIG_DRM_GUD=m
drm/gud: Add async_flush module parameter
drm/gud: Add Raspberry Pi Pico ID
drm/gud: Use scatter-gather USB bulk transfer
drm/gud: Free buffers on device removal
drm/gud: cleanup coding style a bit
media: i2c: imx477: Fix framerates for 1332x990 mode
ARM: dts: bcm2711: Tidy the HDMI I2C aliases
configs: Add SND_SOC_WM8960=m
Revert "firmware: Updated mailbox header"
Revert "raspberrypi-
drm/vc4: Fix typo when getting firmware node
drm/vc4: Refactor mode checking logic
drm/vc4: Allow setting the TV norm via module parameter
drm/vc4: Add support for more analog TV standards
drm/vc4: Fix definition of PAL-M mode
drm/vc4: Refactor VEC TV mode setting
drm/vc4: Fix timings for VEC modes
overlays: Add overlay for Si446x Transceiver SPI
ARM: dts: bcm2711: fold in the correct interrupt
ydrm/vc4: fkms: Fix margin calculations for the right/bottom edges
drm/vc4: Fix margin calculations for the right/bottom edges
configs: Add KEYBOARD_CAP11XX=m
overlays: Add overlay for cap1106 capacitive touch sensor
overlays: Add overlay for Chipdip I2S master DAC
media: bcm2835-unicam: Forward input status from subdevice
bcm2711_thermal: Don't clamp temperature at zero
drm/vc4: hdmi: Only call into DRM framework if registered
drm/vc4: hdmi: Drop devm interrupt handler for hotplug interrupts
drm/vc4: hdmi: Drop devm interrupt handler for CEC interrupts
dwc_otg: Update NetBSD usb.h header licence
vc4/drv: Only notify firmware of display done with kms
drm/vc4: hdmi: Move initial register read after pm_runtime_get
drm/vc4: hdmi: Warn if we access the controller while disabled
drm/vc4: hdmi: Add missing clk_disable_
drm/vc4: hdmi: Make sure the device is powered with CEC
drm/vc4: hdmi: Split the CEC disable / enable functions in two
drm/vc4: hdmi: Put the device on error in pre_crtc_configure
ARM: dts: rpi: Add the firmware node to vc4
drm/vc4: Notify the firmware when DRM is in charge
drm/vc4: Remove conflicting framebuffers before callind bind_all
firmware: raspberrypi: Add RPI_FIRMWARE_
dt-bindings: display: vc4: Add phandle to the firmware
dt-bindings: clk: raspberrypi: Remove unused property
overlays: Make i2c-rtc and i2c-rtc-gpio share RTCs
media: i2c: imx477: Extend driver to support imx378 sensor
overlays: Add overlay for imx378 sensor
Documentation: devicetree: Add documentation for imx378 sensor
staging: vc04_services: isp: Set the YUV420/YVU420 format stride to 64 bytes
configs: Add CONFIG_MACVTAP=m (arm64 only)
drm/vc4: hdmi: Enable the scrambler on reconnection
drm/vc4: hdmi: Use a fixed rate for the HSM clock on BCM2835
media: i2c: ov9281: Remove override of subdev name
drm/vc4: Increase the core clock to a minimum of 500MHz
drm: vc4: Fix pixel-wrap issue with DVP teardown
overlays: Add dpi18cpadhi, vc4-kms-
Support RPi DPI interface in mode6 for 18-bit color
media: rpivid: Fix H265 aux ent reuse of the same slot
drm/vc4: Don't create hvs_load_tracker on fkms
drm/vc4: Fix timings for interlaced modes
media: i2c: imx290: Fix clock setup register assignments
media: i2c: imx290: Fix the pixel rate at 148.5Mpix/s
media: i2c: imx290: Support 60fps in 2 lane operation
drm/vc4: hdmi: Remove redundant variables
drm/vc4: Register HDMI codec
mmc: sdhost: Pass DT pointer to rpi_firmware_get
ARM: dts: Add firmware reference to sdhost node
clk: bcm2835: Pass DT node to rpi_firmware_get
drm/vc4: Increase the core clock based on HVS load
drm/vc4: Leverage the load tracker on the BCM2711
drm/vc4: crtc: Add some logging
drm/vc4: crtc: Rework the encoder retrieval code (again)
drm/vc4: crtc: Add encoder to vc4_crtc_config_pv prototype
drm/vc4: Make vc4_crtc_
ASoC: hdmi-codec: Add a prepare hook
ASoC: hdmi-codec: Add iec958 controls
snd: iec958: split status creation and fill
ASoC: hdmi-codec: Rework to support more controls
media: i2c: imx477: Fix for long exposure limit calculations
bcm2835: Allow compressed frames to set sizeimage (#4386)
drm/vc4: hdmi: Fix PM reference leak in vc4_hdmi_
Revert "drm/vc4: hdmi: Switch to pm_runtime_
drm/vc4: hdmi: Fix error path of hpd-gpios
Changed in linux-raspi (Ubuntu): | |
status: | New → Confirmed |
summary: |
- impish/linux-raspi: Upstream raspberrypi patchset 2021-08-27 + impish/linux-raspi: Update to upstream raspberrypi rpi-5.13.y + (2021-08-27) |
description: | updated |
description: | updated |
description: | updated |
description: | updated |
description: | updated |
Changed in linux-raspi (Ubuntu Impish): | |
assignee: | nobody → Juerg Haefliger (juergh) |
tags: | added: kernel-stable-tracking-bug |
This bug was fixed in the package linux-raspi - 5.13.0-1007.8
---------------
linux-raspi (5.13.0-1007.8) impish; urgency=medium
* impish/linux-raspi: 5.13.0-1007.8 -proposed tracker (LP: #1943746)
* impish/linux-raspi: Update to upstream raspberrypi rpi-5.13.y (2021-08-27) get_encoder public dpi-at056tn53v1 NOTIFY_ DISPLAY_ DONE unprepare on error path
(LP: #1942881)
- bcm2835: Allow compressed frames to set sizeimage (#4386)
- media: i2c: imx477: Fix for long exposure limit calculations
- ASoC: hdmi-codec: Rework to support more controls
- snd: iec958: split status creation and fill
- ASoC: hdmi-codec: Add iec958 controls
- ASoC: hdmi-codec: Add a prepare hook
- drm/vc4: Make vc4_crtc_
- drm/vc4: crtc: Add encoder to vc4_crtc_config_pv prototype
- drm/vc4: crtc: Rework the encoder retrieval code (again)
- drm/vc4: crtc: Add some logging
- drm/vc4: Leverage the load tracker on the BCM2711
- drm/vc4: Increase the core clock based on HVS load
- clk: bcm2835: Pass DT node to rpi_firmware_get
- ARM: dts: Add firmware reference to sdhost node
- mmc: sdhost: Pass DT pointer to rpi_firmware_get
- drm/vc4: Register HDMI codec
- drm/vc4: hdmi: Remove redundant variables
- media: i2c: imx290: Support 60fps in 2 lane operation
- media: i2c: imx290: Fix the pixel rate at 148.5Mpix/s
- media: i2c: imx290: Fix clock setup register assignments
- drm/vc4: Fix timings for interlaced modes
- drm/vc4: Don't create hvs_load_tracker on fkms
- media: rpivid: Fix H265 aux ent reuse of the same slot
- Support RPi DPI interface in mode6 for 18-bit color
- overlays: Add dpi18cpadhi, vc4-kms-
- drm: vc4: Fix pixel-wrap issue with DVP teardown
- drm/vc4: Increase the core clock to a minimum of 500MHz
- media: i2c: ov9281: Remove override of subdev name
- drm/vc4: hdmi: Use a fixed rate for the HSM clock on BCM2835
- drm/vc4: hdmi: Enable the scrambler on reconnection
- configs: Add CONFIG_MACVTAP=m (arm64 only)
- staging: vc04_services: isp: Set the YUV420/YVU420 format stride to 64 bytes
- Documentation: devicetree: Add documentation for imx378 sensor
- overlays: Add overlay for imx378 sensor
- media: i2c: imx477: Extend driver to support imx378 sensor
- overlays: Make i2c-rtc and i2c-rtc-gpio share RTCs
- dt-bindings: clk: raspberrypi: Remove unused property
- dt-bindings: display: vc4: Add phandle to the firmware
- firmware: raspberrypi: Add RPI_FIRMWARE_
- drm/vc4: Remove conflicting framebuffers before callind bind_all
- drm/vc4: Notify the firmware when DRM is in charge
- ARM: dts: rpi: Add the firmware node to vc4
- drm/vc4: hdmi: Put the device on error in pre_crtc_configure
- drm/vc4: hdmi: Split the CEC disable / enable functions in two
- drm/vc4: hdmi: Make sure the device is powered with CEC
- drm/vc4: hdmi: Add missing clk_disable_
- drm/vc4: hdmi: Warn if we access the controller while disabled
- drm/vc4: hdmi: Move initial register read after pm_runtime_get
- vc4/drv: Only notify firmware of display done with kms
- dwc_otg: Update NetBSD usb.h header li...