[dove] sync to LSP 5.3.5

[Eric Miao]

A total of 15 patches.

Subject: [PATCH 01/15] USB gadget: allow the USB_GADGET_VBUS_DRAW range to be 0
Subject: [PATCH 02/15] dove: set the USB_GADGET_VBUS_DRAW to 0
Subject: [PATCH 03/15] usb dove: update usb phy registers
Subject: [PATCH 04/15] dove: use '-1' as initial value for the previously used I2C port ID
Subject: [PATCH 05/15] mvl-dove: statically generate mv_hal_drivers makefiles
Subject: [PATCH 06/15] LCD0 should use extclk#1, and LCD1 uses internal refclk.
Subject: [PATCH 07/15] Add IDT support if chip is Dove A0 or above
Subject: [PATCH 08/15] hedley: fix mv hal pmu Makefile include paths
Subject: [PATCH 09/15] cmd line partitions: use 64 bit variables to detect partitions/offsets larger than 4G.
Subject: [PATCH 10/15] USB dove: enable USB voltage fix in device mode
Subject: [PATCH 11/15] v4l cafe_ccic: configure the sensor on resume when doing steaming
Subject: [PATCH 12/15] cafe camera: fix data type of saturation field in the ov7670 sensor driver
Subject: [PATCH 13/15] GC600: sync driver
Subject: [PATCH 14/15] fix bug in resolving brightness value
Subject: [PATCH 15/15] tune QVGA paramters to eliminate green line on left side

[Launchpad Janitor (janitor)]

This bug was fixed in the package linux-mvl-dove - 2.6.32-410.27

---------------
linux-mvl-dove (2.6.32-410.27) maverick; urgency=low

  [ Brad Figg ]

  * Rebased to 2.6.32-25.44

  [ Eric Miao ]

  * Sync config with LSP 5.3.4
    - LP: #633862

  [ Upstream Kernel Changes ]

  * idt: add platform data to set the clocks configuration
  * dove: provide idt platform data to set the clock's configuration
    - LP: #633862
  * dove lcd: make lcd's clock setting via cmdline to be applicable for all
    boards.
    - LP: #633862
  * sound: update the RT655 codec kcontrols
    - LP: #633862
  * dove: disable the KG2 display driver
    - LP: #633862
  * dovefb: add board option for disabling the edid polling
    - LP: #633862
  * Update new dummy EDID data to support more VESA standard timings.
    - LP: #633862
  * giga hal: set phy address to 1
    - LP: #633862
  * dove: tune pcei phy to pass electrical testing
    - LP: #633862
  * i2c-mv64xxx: fix I2C wait event timeout issue
    - LP: #622214
  * dove: enable USB gadget file storage testing option
    - LP: #633862
  * dove: support using gpio-i2c driver for the i2c bus of the VGA
    - LP: #633862
  * LCD dovefb: Support extension dummy EDID. 2. Add more video mode into
    extension EDID.
    - LP: #633862
  * LCD dovefb: move the clock setting part in dovefb_gfx.c to clock.c
    - LP: #633862
  * LCD dovefb: refine configure ref clk and lcd internal divider flow and
    give detailed comments.
    - LP: #633862
  * LCD dovefb: Refine data structure for reference clock selection
    - LP: #633862
  * LCD dovefb: Separate accurate and inaccurate mode clock by add a new
    clk structure.
    - LP: #633862
  * 1. default set lcd0 uses ext refclk0 and lcd1 uses internal refclk. 2.
    auto turn on accurate mode.
    - LP: #633862
  * Refine LCD refclk bootargs comments and update dove_defconfig.
    - LP: #633862
  * Refine the bootargs usage mechanism and update all board setup files.
    - LP: #633862
  * dove: update the LCD internal clock accurate mode setting
    - LP: #633862
  * sound: add Record Gain Capture Switch to the rt655 codec
    - LP: #633862
  * fix lcd backward compatibility for clk source selection
    - LP: #633862
  * Fix invalidate I$ all
    - LP: #633862
  * Add CPU errata 4574 and 4731 SWFIX
    - LP: #633862
  * Add missed isb and dsb
    - LP: #633862
  * Marvell CPU errata 4315 S/W FIX
    - LP: #633862
  * dove: enable CPU (PJ4) work arounds 4574,4731,4315
    - LP: #633862
  * Fix code logic of function, is_clksrc_pll()
    - LP: #633862
  * CS42l51 codec: unmute codec on system resume
    - LP: #633862
  * LCD dovefb: set edid data when edid paramete disabled.
    - LP: #633862
  * dove: use DOVE_PCIE0/1_IO_BUS_BASE for PCI bus addresses
    - LP: #633862
  * dove: provide phy address for old dove db boards
    - LP: #633862
  * sound orion i2s: clear pause, spdif and i2s mute fields on playback
    - LP: #633862
  * dove: sync dove_defconfig file with ac97 codec changes
    - LP: #633862
  * USB gadget: allow the USB_GADGET_VBUS_DRAW range to be 0
  * dove: set the USB_GADGET_VBUS_DRAW to 0
  * usb dove: update usb phy registers
  * dove: use '-1' as initial v...