[ 14.795467] Bluetooth: BNEP (Ethernet Emulation) ver 1.3 [ 14.795474] Bluetooth: BNEP filters: protocol multicast [ 14.836179] Bridge firewalling registered [ 17.325641] [drm] Initialized drm 1.1.0 20060810 [ 17.337041] pci 0000:00:02.0: power state changed by ACPI to D0 [ 17.337058] pci 0000:00:02.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16 [ 17.337068] pci 0000:00:02.0: setting latency timer to 64 [ 17.337302] pci 0000:00:02.0: irq 2299 for MSI/MSI-X [ 17.337461] [drm] Initialized i915 1.6.0 20080730 on minor 0 [ 19.325562] e1000e 0000:00:19.0: irq 2300 for MSI/MSI-X [ 19.381271] e1000e 0000:00:19.0: irq 2300 for MSI/MSI-X [ 19.383413] ADDRCONF(NETDEV_UP): eth0: link is not ready [ 19.387320] iwl3945 0000:03:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17 [ 19.387493] iwl3945 0000:03:00.0: restoring config space at offset 0x1 (was 0x100102, writing 0x100106) [ 19.387701] iwl3945 0000:03:00.0: irq 2298 for MSI/MSI-X [ 19.387825] iwl3945 0000:03:00.0: firmware: requesting iwlwifi-3945-1.ucode [ 19.548388] Registered led device: iwl-phy0:radio [ 19.548843] Registered led device: iwl-phy0:assoc [ 19.550404] Registered led device: iwl-phy0:RX [ 19.550472] Registered led device: iwl-phy0:TX [ 19.569620] ADDRCONF(NETDEV_UP): wlan0: link is not ready [ 19.952081] wlan0: direct probe to AP 00:11:88:28:ba:80 try 1 [ 20.149100] wlan0: direct probe to AP 00:11:88:28:ba:80 try 2 [ 20.150885] wlan0 direct probe responded [ 20.150892] wlan0: authenticate with AP 00:11:88:28:ba:80 [ 20.152574] wlan0: authenticated [ 20.152579] wlan0: associate with AP 00:11:88:28:ba:80 [ 20.155903] wlan0: RX AssocResp from 00:11:88:28:ba:80 (capab=0x401 status=0 aid=191) [ 20.155909] wlan0: associated [ 20.158744] wlan0: disassociating by local choice (reason=3) [ 20.828164] warning: `pulseaudio' uses 32-bit capabilities (legacy support in use) [ 29.995815] wlan0: authenticate with AP 00:11:88:28:ba:80 [ 29.999369] wlan0: authenticate with AP 00:11:88:28:ba:80 [ 29.999393] wlan0: authenticated [ 29.999399] wlan0: associate with AP 00:11:88:28:ba:80 [ 30.002595] wlan0: RX ReassocResp from 00:11:88:28:ba:80 (capab=0x401 status=0 aid=191) [ 30.002601] wlan0: associated [ 30.007518] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready [ 40.128117] wlan0: no IPv6 routers present