[   10.476817] ppdev: user-space parallel port driver
[   10.531258] ADDRCONF(NETDEV_UP): wlan0: link is not ready
[   10.552087] fb0: inteldrmfb frame buffer device
[   10.552094] registered panic notifier
[   10.552111] [drm] Initialized i915 1.6.0 20080730 for 0000:00:02.0 on minor 0
[   10.552198] HDA Intel 0000:00:1b.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
[   10.552265] HDA Intel 0000:00:1b.0: setting latency timer to 64
[   10.577240] vga16fb: initializing
[   10.577250] vga16fb: mapped to 0xc00a0000
[   10.577259] vga16fb: not registering due to another framebuffer present
[   10.808474] hda_codec: ALC662 rev1: BIOS auto-probing.
[   10.809787] input: HDA Digital PCBeep as /devices/pci0000:00/0000:00:1b.0/input/input10
[   10.818438] Console: switching to colour frame buffer device 128x37
[   11.872024] render error detected, EIR: 0x00000010
[   11.872115] page table error
[   11.872166]   PGTBL_ER: 0x00000010
[   11.872227] [drm:i915_handle_error] *ERROR* EIR stuck: 0x00000010, masking
[   11.872348] render error detected, EIR: 0x00000010
[   11.872428] page table error
[   11.872478]   PGTBL_ER: 0x00000010
[   56.369293] wlan0: deauthenticating from 00:22:93:1f:da:f7 by local choice (reason=3)
[   56.377893] wlan0: direct probe to AP 00:22:93:1f:da:f7 (try 1)
[   56.379011] wlan0: direct probe responded
[   56.379017] wlan0: authenticate with AP 00:22:93:1f:da:f7 (try 1)
[   56.380546] wlan0: authenticated
[   56.380582] wlan0: associate with AP 00:22:93:1f:da:f7 (try 1)
[   56.382556] wlan0: RX AssocResp from 00:22:93:1f:da:f7 (capab=0x451 status=0 aid=1)
[   56.382562] wlan0: associated
[   56.383935] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
[   56.387543] cfg80211: Calling CRDA for country: CN
[   56.395904] cfg80211: Received country IE:
[   56.395913] cfg80211: Regulatory domain: CN
[   56.395917] 	(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[   56.395924] 	(2402000 KHz - 2494000 KHz @ 40000 KHz), (10000 mBi, 10000 mBm)
[   56.395928] cfg80211: CRDA thinks this should applied:
[   56.395933] cfg80211: Regulatory domain: CN
[   56.395936] 	(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[   56.395942] 	(2402000 KHz - 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm)
[   56.395948] 	(5735000 KHz - 5835000 KHz @ 40000 KHz), (N/A, 3000 mBm)
[   56.395953] cfg80211: We intersect both of these and get:
[   56.395957] cfg80211: Regulatory domain: 98
[   56.395960] 	(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[   56.395966] 	(2402000 KHz - 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm)
[   56.395977] cfg80211: Disabling channel 2484 MHz on phy0 due to Country IE
[   56.395989] cfg80211: Current regulatory domain updated by AP to: CN
[   56.395994] 	(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[   56.396000] 	(2402000 KHz - 2482000 KHz @ 40000 KHz), (N/A, 2000 mBm)
[   66.892013] wlan0: no IPv6 routers present
[  298.958292] __ratelimit: 9 callbacks suppressed
[  298.958303] gnome-power-man[1170]: segfault at 1 ip 010f400b sp bfd61640 error 4 in libgtk-x11-2.0.so.0.2000.0[ff7000+3cd000]