Linux version 2.6.28-8-ixp4xx (buildd@prumnopitys) (gcc version 4.3.3 (Ubuntu 4.3.3-3ubuntu5) ) #26-Ubuntu Wed Feb 25 06:58:16 UTC 2009 (Ubuntu 2.6.28-8.26-ixp4xx)
CPU: XScale-IXP42x Family [690541f1] revision 1 (ARMv5TE), cr=0000397f
CPU: VIVT data cache, VIVT instruction cache
Machine: Linksys NSLU2
Memory policy: ECC disabled, Data cache writeback
On node 0 totalpages: 8192
free_area_init_node: node 0, pgdat c0268fb4, node_mem_map c027e000
  DMA zone: 64 pages used for memmap
  DMA zone: 0 pages reserved
  DMA zone: 8128 pages, LIFO batch:0
  Normal zone: 0 pages used for memmap
  Movable zone: 0 pages used for memmap
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 8128
Kernel command line: console=ttyS0,115200 rtc-x1205.probe=0,0x6f noirqdebug
Unknown boot option `rtc-x1205.probe=0,0x6f': ignoring
IRQ lockup detection disabled
PID hash table entries: 128 (order: 7, 512 bytes)
Console: colour dummy device 80x30
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Memory: 32MB = 32MB total
Memory: 24424KB available (2224K code, 178K data, 108K init)
SLUB: Genslabs=12, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
Calibrating delay loop... 266.24 BogoMIPS (lpj=1331200)
Security Framework initialized
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
net_namespace: 704 bytes
NET: Registered protocol family 16
IXP4xx: Using 16MiB expansion bus window size
NSLU2: Using MAC address 00:04:5a:0f:c2:34 for port 0
PCI: IXP4xx is host
PCI: IXP4xx Using direct access for memory space
pci 0000:00:01.0: reg 10 32bit mmio: [0x000000-0x000fff]
pci 0000:00:01.0: supports D1 D2
pci 0000:00:01.0: PME# supported from D0 D1 D2 D3hot
pci 0000:00:01.0: PME# disabled
pci 0000:00:01.1: reg 10 32bit mmio: [0x000000-0x000fff]
pci 0000:00:01.1: supports D1 D2
pci 0000:00:01.1: PME# supported from D0 D1 D2 D3hot
pci 0000:00:01.1: PME# disabled
pci 0000:00:01.2: reg 10 32bit mmio: [0x000000-0x0000ff]
pci 0000:00:01.2: supports D1 D2
pci 0000:00:01.2: PME# supported from D0 D1 D2 D3hot
pci 0000:00:01.2: PME# disabled
PCI: bus0: Fast back to back transfers disabled
pci 0000:00:01.0: dmabounce: registered device
pci 0000:00:01.1: dmabounce: registered device
pci 0000:00:01.2: dmabounce: registered device
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
NET: Registered protocol family 2
Switched to high resolution mode on CPU 0
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP reno registered
NET: Registered protocol family 1
checking if image is initramfs... it is
Freeing initrd memory: 5503K
IXP4xx Queue Manager initialized.
msgmni has been set to 58
io scheduler noop registered
io scheduler cfq registered (default)
Serial: 8250/16550 driver2 ports, IRQ sharing disabled
serial8250.0: ttyS0 at MMIO 0xc8000000 (irq = 15) is a XScale
console [ttyS0] enabled
serial8250.0: ttyS1 at MMIO 0xc8001000 (irq = 13) is a XScale
brd: module loaded
eth0: MII PHY 1 on NPE-B
Driver 'sd' needs updating - please use bus_type methods
IXP4XX-Flash.0: Found 1 x16 devices at 0x0 in 16-bit bank
IXP4XX-Flash.0: Found an alias at 0x800000 for the chip at 0x0
 Intel/Sharp Extended Query Table at 0x0031
Using buffer write method
cfi_cmdset_0001: Erase suspend on write enabled
erase region 0: offset=0x0,size=0x20000,blocks=64
Searching for RedBoot partition table in IXP4XX-Flash.0 at offset 0x7e0000
6 RedBoot partitions found on MTD device IXP4XX-Flash.0
Creating 6 MTD partitions on "IXP4XX-Flash.0":
0x00000000-0x00040000 : "RedBoot"
0x00040000-0x00060000 : "SysConf"
0x00060000-0x00080000 : "Loader"
0x00080000-0x00280000 : "Kernel"
0x00280000-0x007e0000 : "Ramdisk"
0x007e0000-0x00800000 : "FIS directory"
ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
PCI: enabling device 0000:00:01.2 (0140 -> 0142)
ehci_hcd 0000:00:01.2: EHCI Host Controller
ehci_hcd 0000:00:01.2: new USB bus registered, assigned bus number 1
ehci_hcd 0000:00:01.2: irq 26, io mem 0x48002000
ehci_hcd 0000:00:01.2: USB 2.0 started, EHCI 1.00
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 5 ports detected
usb usb1: New USB device found, idVendor=1d6b, idProduct=0002
usb usb1: New USB device strings: Mfr=3, Product=2, SerialNumber=1
usb usb1: Product: EHCI Host Controller
usb usb1: Manufacturer: Linux 2.6.28-8-ixp4xx ehci_hcd
usb usb1: SerialNumber: 0000:00:01.2
ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
PCI: enabling device 0000:00:01.0 (0140 -> 0142)
ohci_hcd 0000:00:01.0: OHCI Host Controller
ohci_hcd 0000:00:01.0: new USB bus registered, assigned bus number 2
ohci_hcd 0000:00:01.0: irq 28, io mem 0x48000000
usb usb2: configuration #1 chosen from 1 choice
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 3 ports detected
usb usb2: New USB device found, idVendor=1d6b, idProduct=0001
usb usb2: New USB device strings: Mfr=3, Product=2, SerialNumber=1
usb usb2: Product: OHCI Host Controller
usb usb2: Manufacturer: Linux 2.6.28-8-ixp4xx ohci_hcd
usb usb2: SerialNumber: 0000:00:01.0
PCI: enabling device 0000:00:01.1 (0140 -> 0142)
ohci_hcd 0000:00:01.1: OHCI Host Controller
ohci_hcd 0000:00:01.1: new USB bus registered, assigned bus number 3
ohci_hcd 0000:00:01.1: irq 27, io mem 0x48001000
usb usb3: configuration #1 chosen from 1 choice
hub 3-0:1.0: USB hub found
hub 3-0:1.0: 2 ports detected
usb usb3: New USB device found, idVendor=1d6b, idProduct=0001
usb usb3: New USB device strings: Mfr=3, Product=2, SerialNumber=1
usb usb3: Product: OHCI Host Controller
usb usb3: Manufacturer: Linux 2.6.28-8-ixp4xx ohci_hcd
usb usb3: SerialNumber: 0000:00:01.1
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
mice: PS/2 mouse device common for all mice
IXP4xx Watchdog Timer: heartbeat 60 sec
TCP cubic registered
NET: Registered protocol family 17
XScale DSP coprocessor detected.
usb 1-1: new high speed USB device using ehci_hcd and address 2
Freeing init memory: 108K
usb 1-1: configuration #1 chosen from 1 choice
scsi0 : SCSI emulation for USB Mass Storage devices
usb 1-1: New USB device found, idVendor=1058, idProduct=0910
usb 1-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
usb 1-1: Product: External HDD    
usb 1-1: Manufacturer: Western Digital 
usb 1-1: SerialNumber: 574341533831393036323735
usb-storage: device found at 2
usb-storage: waiting for device to settle before scanning
scsi 0:0:0:0: Direct-Access     WD       5000AAK External 1.06 PQ: 0 ANSI: 0
sd 0:0:0:0: [sda] 976773168 512-byte hardware sectors: (500 GB/465 GiB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Mode Sense: 00 00 00 00
sd 0:0:0:0: [sda] Assuming drive cache: write through
sd 0:0:0:0: [sda] 976773168 512-byte hardware sectors: (500 GB/465 GiB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Mode Sense: 00 00 00 00
sd 0:0:0:0: [sda] Assuming drive cache: write through
 sda: sda1 < sda5 sda6 sda7 sda8 sda9 > sda2
sd 0:0:0:0: [sda] Attached SCSI disk
sd 0:0:0:0: Attached scsi generic sg0 type 0
usb-storage: device scan complete
net eth0: firmware: requesting NPE-B
NPE-B: firmware functionality 0x2, revision 0x2:1
eth0: link down
eth0: link down
eth0: link up, 100Mbps, full-duplex, lpa 0x41E1
warning: process `rdate' used the deprecated sysctl system call with 1.40.
warning: process `rdate' used the deprecated sysctl system call with 1.40.
Adding 730916k swap on /dev/sda9.  Priority:-1 extents:1 across:730916k
kjournald starting.  Commit interval 5 seconds
EXT3 FS on sda7, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
kjournald starting.  Commit interval 5 seconds
EXT3 FS on sda2, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
kjournald starting.  Commit interval 5 seconds
EXT3 FS on sda8, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
fuse init (API version 7.10)