[    7.344636] Too many HDMI devices
[    7.344637] Too many HDMI devices
[    7.344638] Too many HDMI devices
[    7.344639] Too many HDMI devices
[    7.344640] Too many HDMI devices
[    7.344640] Too many HDMI devices
[    7.344641] Too many HDMI devices
[    7.344642] Too many HDMI devices
[    7.344731] hda-codec: out of range cmd 0:0:1f90:707:0
[    7.344733] hda-codec: out of range cmd 0:0:1f90:708:85
[    7.344970] hda-codec: out of range cmd 0:0:1f90:f00:c
[    7.344971] hda-codec: out of range cmd 0:0:1f90:709:0
[    7.344973] hda-codec: out of range cmd 0:0:1f90:f09:0
[    7.345044] hda-codec: out of range cmd 0:0:e0:f0d:0
[    7.345046] HDMI status: Codec=0 Pin=2 Presence_Detect=0 ELD_Valid=0
[    7.345062] HDMI status: Codec=0 Pin=5 Presence_Detect=0 ELD_Valid=0
[    7.345079] HDMI status: Codec=0 Pin=7 Presence_Detect=0 ELD_Valid=0
[    7.345096] HDMI status: Codec=0 Pin=9 Presence_Detect=0 ELD_Valid=0
[    7.345115] HDMI status: Codec=0 Pin=8080 Presence_Detect=1 ELD_Valid=1
[    7.345116] hda-codec: out of range cmd 0:0:1f90:f2e:8
[    7.345118] hda_codec: cannot build controls for #0 (error -16)
[    7.345119] hda_codec: cannot revert codec
[    7.345551] snd_hda_intel 0000:0f:00.1: PCI INT B disabled
[    7.345560] snd_hda_intel: probe of 0000:0f:00.1 failed with error -16
[    9.343041] tg3 0000:01:00.0: eth0: Link is up at 1000 Mbps, full duplex
[    9.343044] tg3 0000:01:00.0: eth0: Flow control is on for TX and on for RX
[    9.343940] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[    9.747576] floppy0: no floppy controllers found
[    9.983671] vesafb: mode is 1920x1200x32, linelength=7680, pages=0
[    9.983672] vesafb: scrolling: redraw
[    9.983674] vesafb: Truecolor: size=0:8:8:8, shift=0:16:8:0
[    9.988949] vesafb: framebuffer at 0xe0000000, mapped to 0xffffc90008780000, using 9024k, total 9024k
[    9.989173] Console: switching to colour frame buffer device 240x75
[    9.989203] fb0: VESA VGA frame buffer device
[   10.002134] init: plymouth-splash main process (1291) terminated with status 1
[   10.220866] fglrx_pci 0000:0f:00.0: irq 68 for MSI/MSI-X
[   10.221505] [fglrx] Firegl kernel thread PID: 1305
[   10.221640] [fglrx] Firegl kernel thread PID: 1306
[   10.221810] [fglrx] Firegl kernel thread PID: 1307
[   10.221891] [fglrx] IRQ 68 Enabled
[   10.355981] [fglrx] Gart USWC size:1280 M.
[   10.355984] [fglrx] Gart cacheable size:508 M.
[   10.355987] [fglrx] Reserved FB block: Shared offset:0, size:1000000 
[   10.355988] [fglrx] Reserved FB block: Unshared offset:f8fd000, size:403000 
[   10.355990] [fglrx] Reserved FB block: Unshared offset:3ffee000, size:12000 
[   20.111000] eth0: no IPv6 routers present
[  480.432943] EXT4-fs (sda6): mounted filesystem with ordered data mode. Opts: (null)
[72604.260594] tg3 0000:01:00.0: PME# enabled
[72604.260615] pcieport 0000:00:1c.5: wake-up capability enabled by ACPI
[72604.283822] ADDRCONF(NETDEV_UP): eth0: link is not ready
[72604.655410] tg3 0000:01:00.0: irq 69 for MSI/MSI-X
[72604.733416] ADDRCONF(NETDEV_UP): eth0: link is not ready
[72604.733890] ADDRCONF(NETDEV_UP): eth0: link is not ready
[72607.050466] tg3 0000:01:00.0: eth0: Link is up at 1000 Mbps, full duplex
[72607.050469] tg3 0000:01:00.0: eth0: Flow control is on for TX and on for RX
[72607.051500] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[72617.352351] eth0: no IPv6 routers present
[75566.152940] [fglrx] IRQ 68 Disabled
[75566.915551] fglrx_pci 0000:0f:00.0: irq 68 for MSI/MSI-X
[75566.916233] [fglrx] Firegl kernel thread PID: 8509
[75566.916528] [fglrx] Firegl kernel thread PID: 8510
[75566.916825] [fglrx] Firegl kernel thread PID: 8511
[75566.916968] [fglrx] IRQ 68 Enabled
[75567.054872] [fglrx] Gart USWC size:1280 M.
[75567.054876] [fglrx] Gart cacheable size:508 M.
[75567.054883] [fglrx] Reserved FB block: Shared offset:0, size:1000000 
[75567.054886] [fglrx] Reserved FB block: Unshared offset:f8fd000, size:403000 
[75567.054889] [fglrx] Reserved FB block: Unshared offset:3ffee000, size:12000 
[76202.844643] vboxdrv: Found 8 processor cores.
[76202.845025] vboxdrv: fAsync=0 offMin=0x228 offMax=0x2079c
[76202.845073] vboxdrv: TSC mode is 'synchronous', kernel timer mode is 'normal'.
[76202.845075] vboxdrv: Successfully loaded version 4.1.12_Ubuntu (interface 0x00190000).
[76202.855508] vboxpci: IOMMU not found (not registered)
[76416.200600] warning: `VirtualBox' uses 32-bit capabilities (legacy support in use)
[76416.816915] show_signal_msg: 36 callbacks suppressed
[76416.816920] VirtualBox[14086]: segfault at 7fe30f96b040 ip 00007fe30f96b040 sp 00007fff2c9d0768 error 14 in libappmenu-qt.so[7fe30f8e2000+1ff000]
[76476.643394] ADDRCONF(NETDEV_UP): eth0: link is not ready
[76476.987781] tg3 0000:01:00.0: irq 69 for MSI/MSI-X
[76477.048380] ADDRCONF(NETDEV_UP): eth0: link is not ready
[76477.048609] ADDRCONF(NETDEV_UP): eth0: link is not ready
[76479.382654] tg3 0000:01:00.0: eth0: Link is up at 1000 Mbps, full duplex
[76479.382659] tg3 0000:01:00.0: eth0: Flow control is on for TX and on for RX
[76479.384424] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[76489.748676] eth0: no IPv6 routers present
[76730.029139] device eth0 entered promiscuous mode
[76743.373409] EXT4-fs (sdb1): Unaligned AIO/DIO on inode 3147160 by VirtualBox; performance will be poor.
[77052.656543] VirtualBox[15287]: segfault at ffffffffb80c6d48 ip 00007f2d026b0c58 sp 00007fffb4eeed00 error 4 in libX11.so.6.3.0[7f2d0267d000+12f000]
[164511.793824] EXT4-fs (sdb1): Unaligned AIO/DIO on inode 3147160 by VirtualBox; performance will be poor.
[164671.482524] telepathy-gabbl[9307] general protection ip:7f49aee9b8ee sp:7fff9061f110 error:0 in libtelepathy-glib.so.0.70.0[7f49aee40000+1fa000]
[164810.725187] telepathy-gabbl[6569] general protection ip:7f86d2a578ee sp:7fff8f8d1eb0 error:0 in libtelepathy-glib.so.0.70.0[7f86d29fc000+1fa000]
[165918.407863] telepathy-gabbl[6924] general protection ip:7f37f38158ee sp:7fffe0ca92f0 error:0 in libtelepathy-glib.so.0.70.0[7f37f37ba000+1fa000]
[171374.831586] telepathy-gabbl[7362] general protection ip:7f91f1b8f8ee sp:7fff23a12cc0 error:0 in libtelepathy-glib.so.0.70.0[7f91f1b34000+1fa000]
[171987.816700] telepathy-gabbl[9330] general protection ip:7fdcd71458ee sp:7fff61e7a130 error:0 in libtelepathy-glib.so.0.70.0[7fdcd70ea000+1fa000]
[203569.590599] telepathy-gabbl[12118] general protection ip:7f12d38028ee sp:7fff80d3c5e0 error:0 in libtelepathy-glib.so.0.70.0[7f12d37a7000+1fa000]
[213622.834131] telepathy-gabbl[12225]: segfault at f3661880 ip 000000000048f9f0 sp 00007fff5e8bb370 error 4 in telepathy-gabble[400000+10f000]
[213651.850129] telepathy-gabbl[13898] trap stack segment ip:7f4dad2428f4 sp:7fff255d0480 error:0
[250681.481954] EXT4-fs (sdb1): Unaligned AIO/DIO on inode 3147160 by VirtualBox; performance will be poor.
[254254.993119] usb 1-6: new high-speed USB device number 2 using ehci_hcd
[279903.039503] usb 1-6: USB disconnect, device number 2
[297692.574993] EXT4-fs (sdb1): Unaligned AIO/DIO on inode 3147160 by VirtualBox; performance will be poor.
[304940.709901] VirtualBox[11047]: segfault at 2c0c6d48 ip 00007fca76607c58 sp 00007fffb802a690 error 4 in libX11.so.6.3.0[7fca765d4000+12f000]
[307589.427871] VirtualBox[11113]: segfault at fffffffffc0c6d48 ip 00007ff748e5ac58 sp 00007fff53a2ace0 error 4 in libX11.so.6.3.0[7ff748e27000+12f000]
[334069.007928] EXT4-fs (sdb1): Unaligned AIO/DIO on inode 3153704 by VirtualBox; performance will be poor.
[334470.400844] VirtualBox[17672]: segfault at ffffffffa40c6d48 ip 00007ff2f004ac58 sp 00007fff2f411d80 error 4 in libX11.so.6.3.0[7ff2f0017000+12f000]
[391413.409896] EXT4-fs (sdb1): Unaligned AIO/DIO on inode 3147160 by VirtualBox; performance will be poor.