UEC installer does not set up a bridge device by default for Eucalyptus nodes (NCs)
Bug #425915 reported by
Daniel Nurmi
This bug report is a duplicate of:
Bug #424541: When installing a node controller, a bridge device should be created.
Edit
Remove
This bug affects 1 person
| Affects | Status | Importance | Assigned to | Milestone | |
|---|---|---|---|---|---|
| eucalyptus (Ubuntu) |
New
|
Undecided
|
Unassigned | ||
Bug Description
This report applies to eucalyptus in Karmic
In order for the UEC/Eucalyptus to function right after install, the nodes are required to have a bridge device set up to which a physical ethernet device is attached (and, the device needs to be on the same ethernet network on which the cloud front-end systems are connected). In most Ubuntu/Eucalyptus documentation, the name of this device is set to 'br0' by default (this can change, but if it does it should be changed in the documentation as well).
The name of the bridge device should also be used as the default 'VNET_BRIDGE' in eucalyptus.conf for the eucalyptus-nc component.
Revision history for this message
| Etienne Goyer (etienne-goyer-outlands) wrote | #1 |
To post a comment you must log in.
I already reported that issue as bug #424541.