[   27.936057] usb 6-1: new low speed USB device using uhci_hcd and address 2
[   28.158242] usb 6-1: configuration #1 chosen from 1 choice
[   28.284409] usbcore: registered new interface driver hiddev
[   28.298420] input: USB Mouse as /devices/pci0000:00/0000:00:1d.1/usb6/6-1/6-1:1.0/input/input12
[   28.298520] generic-usb 0003:15D9:0A41.0001: input,hidraw0: USB HID v1.10 Mouse [USB Mouse] on usb-0000:00:1d.1-1/input0
[   28.298541] usbcore: registered new interface driver usbhid
[   28.298544] usbhid: v2.6:USB HID core driver
[   37.570159] ppdev: user-space parallel port driver
[   48.804384] b44: eth0: Link is up at 100 Mbps, full duplex.
[   48.804388] b44: eth0: Flow control is off for TX and off for RX.
[   48.804669] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   59.120042] eth0: no IPv6 routers present
[ 2061.157014] CE: hpet increasing min_delta_ns to 15000 nsec
[ 3867.989353] b44: eth0: Link is down.
[ 3872.989244] b44: eth0: Link is up at 100 Mbps, full duplex.
[ 3872.989252] b44: eth0: Flow control is off for TX and off for RX.
[ 7360.660179] usb 2-1: new high speed USB device using ehci_hcd and address 4
[ 7360.794450] usb 2-1: configuration #1 chosen from 1 choice
[ 7360.889238] Initializing USB Mass Storage driver...
[ 7360.889576] scsi4 : SCSI emulation for USB Mass Storage devices
[ 7360.889922] usbcore: registered new interface driver usb-storage
[ 7360.889930] USB Mass Storage support registered.
[ 7360.890009] usb-storage: device found at 4
[ 7360.890015] usb-storage: waiting for device to settle before scanning
[ 7365.888555] usb-storage: device scan complete
[ 7365.889490] scsi 4:0:0:0: Direct-Access     WD       My Passport 070A 1032 PQ: 0 ANSI: 4
[ 7365.890353] scsi 4:0:0:1: CD-ROM            WD       Virtual CD 070A  1032 PQ: 0 ANSI: 4
[ 7365.891234] scsi 4:0:0:2: Enclosure         WD       SES Device       1032 PQ: 0 ANSI: 4
[ 7365.892127] sd 4:0:0:0: Attached scsi generic sg2 type 0
[ 7365.897326] sr1: scsi3-mmc drive: 51x/51x caddy
[ 7365.897581] sr 4:0:0:1: Attached scsi CD-ROM sr1
[ 7365.897725] sr 4:0:0:1: Attached scsi generic sg3 type 5
[ 7365.897930] scsi 4:0:0:2: Attached scsi generic sg4 type 13
[ 7365.898672] sd 4:0:0:0: [sdb] 1463775232 512-byte logical blocks: (749 GB/697 GiB)
[ 7365.900963] sd 4:0:0:0: [sdb] Write Protect is off
[ 7365.900972] sd 4:0:0:0: [sdb] Mode Sense: 23 00 10 00
[ 7365.900979] sd 4:0:0:0: [sdb] Assuming drive cache: write through
[ 7365.911501] sd 4:0:0:0: [sdb] Assuming drive cache: write through
[ 7365.911509]  sdb: sdb1
[ 7365.942806] sd 4:0:0:0: [sdb] Assuming drive cache: write through
[ 7365.942813] sd 4:0:0:0: [sdb] Attached SCSI disk
[ 7365.998373] ses 4:0:0:2: Attached Enclosure device
[ 7366.797192] UDF-fs: Partition marked readonly; forcing readonly mount
[ 7366.804320] UDF-fs INFO UDF: Mounting volume 'WD SmartWare', timestamp 2009/11/14 02:34 (1078)
[ 7367.397478] EXT4-fs (sdb1): barriers enabled
[ 7367.418798] kjournald2 starting: pid 3835, dev sdb1:8, commit interval 5 seconds
[ 7367.419862] EXT4-fs (sdb1): internal journal on sdb1:8
[ 7367.419875] EXT4-fs (sdb1): delayed allocation enabled
[ 7367.419883] EXT4-fs: file extents enabled
[ 7367.454870] EXT4-fs: mballoc enabled
[ 7367.454890] EXT4-fs (sdb1): mounted filesystem with ordered data mode
[18224.896236] CE: hpet increasing min_delta_ns to 22500 nsec